Page 1
28007T
IMPORTANT:
Please read the instructions before using your appliance.
Page 2
2
Content Page
Points of Safety 3
Description of Parts 4
Operating Instructions 5/6
Maintenance and Care 7
If unexpected difficulties arise 7
Disposing of the Unit 7
Page 3
3
Please read through the information
contained in this instructions booklet
carefully. It gives important advice on
the safety, assembly, use and maintenance of the White Knight Spin Dryer.
Retain the instructions booklet in a
safe place for future reference and, if
applicable, pass it on to the subsequent
owner of the appliance. The manufacturer will not be liable if the instructions
specified below are not observed. Do
not put the White Knight Spin Dryer
to improper use, i.e. Do not use the
appliance other than for the purposes
it is intended for. It is only intended for
household use and for spinning items of
laundry only.
• Before connecting the appliance, check that the
details given on the rating plate correspond to the
requirements of your electrical installation.
• Do not operate the appliance if:
– the mains cable is damaged;
– the appliance shows clear signs of damage.
• Check the appliance for any damage which may
have occurred during transit.
• Dispose of the packaging in accordance with
regulations.
• Remove the transport locking piece from inside
the drum.
• The spin dryer is intended for use by adults only.
Ensure that children or infirm persons do not play
around with the appliance.
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their
safety.
Children should be supervised to ensure that they
do not play with the appliance.
• Modifications to the appliance can endanger
your safety and health. Therefore, repairs to the
appliance should be carried out by an authorised
engineer only.
• Never operate the appliance in rooms where
inflammable materials are stored or where gases
have formed.
• Never unplug the appliance by pulling on the
cable, but only by removing the plug directly from
the socket.
• Ensure that the mains cable is not exposed to
either heat or chemical substances, nor that it is
pulled across sharp edges or surfaces.
• If the mains cable becomes damaged, have it
replaced immediately by an authorised repair
agent.
• Do not touch or use the appliance with wet hands
or when barefoot and standing on a wet floor.
• Do not expose the appliance to atmospheric
effects, such as sun, rain, etc.
• The basic safety regulations must be strictly observed. In case of doubt, have a qualified engineer
inspect the electrical installation of your house.
Electrical security is only ensured when the appliance has been duly earthed, as described under
the safety regulations for electrical connections.
If the mains socket does not comply with the plug,
the socket should be replaced by a suitable one.
• Never spin items of laundry which have been
cleaned, washed, impregnated or sprayed with
wax, paint, petrol or inflammable liquids. The
vapours can constitute a fire hazard or cause
an explosion. Always wash materials containing
these substances by hand first and let them dry
outside in the fresh air.
• Do not use the appliance as a footboard or load
heavy items onto it.
• Do not reach into the drum while it is spinning.
• Do not store the spin dryer directly next to a hot
stove or heater.
• Do not use a two-way or multi-way adaptor or
extension lead. The spin dryer must be connected
to its own individual socket.
• Pull out the plug
– if the appliance malfunctions during operation;
– before cleaning and maintenance;
– after use.
• Operate the spin dryer only in an upright position on an even floor and maintain a distance of
about 50 cm from the wall or other objects
(Fig. B).
• During operation, do not lift, carry, hold, move or
tip over the appliance.
• Never handle the operating lever and lid with
force.
• Lift or carry the appliance by the carrying handles only.
• Before disposal of the spin dryer, cut off the
mains cable. Ensure that the appliance is
disposed of carefully and orderly.
Points of Safety
Page 4
4
1 = Lid
2 = Operating Lever
3 = Cable Storage Fixture
4 = Carrying Handle
5 = Plug
6 = Mains Cable
7 = Outer Casing
8 = Outlet Spout
9 = Foot
Description of Parts
3
1
2
7
8
9
4
5
6
Page 5
5
OFF
ON
A
C
Operating Instructions
20"
20"
B
50 cm
50 cm
Congratulations on your new purchase
We recommend that you read these instructions
carefully in order to quickly become familiar with
your new appliance.
A good appliance, which is used correctly, will
serve you for many years.
Unpacking the appliance
Dispose of packing materials in accordance with
regulations.
Check the spin dryer for any transport damage
which must be reported to your retailer within 24
hours.
Preparation for Use
1. Put the operating lever in the “OFF” position.
See diagram A.
2. Open the lid.
3. Remove the transport safeguard from inside the
spin drum.
4. We recommend that the spin drum be washed
out with a standard detergent before using for
the first time.
5. Place the spin dryer on a level floor at a distance
of about 50 cm away from the wall or other
objects. Never balance out irregularities in the
floor surface by laying wood, paper or similar
materials under the appliance. See diagram B.
Loading the machine
1. Place each article of laundry singly in the
spin drum, Distribute the washing evenly
in the drum and press down firmly, so as to
avoid leaving empty spaces (and thus avoiding
excessive vibration of the machine during
operation). See diagram C.
2. Press the loaded washing down, so that there is
a gap of at least 3 cm between the washing and
the top edge of the drum, lastly, cover the washing
with a cloth, the ends of which should be tucked
well down inside the drum, so as to avoid items
of washing being catapulted out during operation. See diagram D.
3. Place a sufficiently large container for excess
water under the outlet spout. See diagram E.
Do not tilt the dryer whilst in operation.
4. Do not place rolled up items of clothing (e.g.
jeans) in the spin dryer. See diagram F.
Page 6
6
E
1"
D
ca. 3 cm
F
Switch on the appliance
Turn the operating lever to the right as far as it will
go to the ’ON‘ position. See diagram A.
The spin dryer is now in operation and water flows
out of the outlet spout.
Spin Drying Times
• For normal washing: 3-5 minutes.
• The residual moisture amounts to:
– approx 40% in machines with a spin speed of
2800 rpm;
– For washing which requires no ironing:
15-30 seconds max.
Switch off the appliance
When water ceases to flow out of the outlet spout,
or when the spin process is to be terminated, turn
the operating lever back to the left to the ‘OFF‘
position.
When the drum has come to a standstill, open the
lid. A special safety device prevents the lid being
opened before the drum has stopped spinning.
Never force the lid open
Remove the laundry from the drum.
Gently tilt the spin dryer forward, so that any remai-
ning water can flow out of the outlet spout.
See diagram E.
Pull out the plug
Page 7
7
Hinweis: Stand der techn. Angaben.
Techn. Änderungen vorbehalten.
Maintenance and Care
• Always pull out the plug before cleaning the appliance.
• After use, wipe the spin drum dry with a cloth.
• If dirty washing has been spun, it is necessary
to rinse the drum out with clear water in order to
avoid soiling the next load of washing.
• Clean the exterior of the spin dryer with a damp
cloth and wipe it dry.
• Use standard detergents only to clean the appliance.
• Do not use abrasive cleaning agents.
• Never use petrol or other solvent liquids.
• The spin dryer requires no other maintenance.
Customer Service
If the spin dryer was purchased and is used in the
UK and you require a service call, please contact
the service agent named on the warranty card.
Our customer service department can be contacted at:
Crosslee plc, Hipperholme, Halifax, HX3 8DE.
Telephone 01422 203963, or by emailing customer service at: customerservice@crosslee.co.uk
If unexpected difficulties arise
• Before contacting your dealer, check whether the
fault is due to one of the following minor causes.
The motor does not function:
• Has the fuse blown?
• Is there damage to the mains cable, plug or
socket? Pull out the plug before checking!
• Never open the motor yourself!
Water does not flow out:
• Pull out the plug! Check whether the outlet spout
is blocked by a piece of washing.
• Press the spin drum from the inside against the
outer casing with your hand and remove the
piece of washing.
The spin dryer does not pick up spin
speed:
• Please note that the spin dryer normally overcomes a certain amount of unbalance itself when
picking up spin speed. The motor and spin drum
are suspended flexibly for that reason.
• However, if the unbalance is too great (brought
about by incorrect loading of the spin dryer), the
machine cannot pick up spin speed.
The spin dryer “jumps”:
1. Switch off the spin dryer immediately!
2. When the drum has come to a standstill, repack
the washing evenly.
3. Reload the spin dryer in accordance with the
instructions given on the previous page.
Model
28007 T
Power:
Voltage
Fuse
Power input
[V]
[A]
[W]
230
13
350
Performance:
Max. load (dry weight)
Spin speed
Residual water
[kg]
[U/min]
[%]
3,7
2800
40
Disposing of the Unit
This appliance is marked according to the European directive
2002/96/EC on Waste Electrical and Electronic Equipment
(WEEE).
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment
and human health, which could otherwise be caused by inappropriate waste handling of this product.
The symbol on the product, or on the documents
accompanying the product, indicates that this
appliance may not be treated as household
waste. Instead it shall be handed over to the
applicable collection point for the recycling of
electrical and electronic equipment.
Disposal must be carried out in accordance with local environ-
mental regulations for waste disposal.
Page 8
8
Teile-Nr. 188 229
GA 03.10 Br.
Loading...