AIR ENGINEERED
OPERATING AND INSTALLATION INSTRUCTIONS
FOR WHISPAIR RANGEHOODS
UTILISING ON BOARD FAN MOTOR UNITS
CONGRATULATIONS
Congratulations and thank you for choosing a
Whispair rangehood.
To avoid the risks that are always present when you
use an electrical appliance it is important that the
rangehood is installed correctly and that you read
the safety instructions carefully to avoid misuse and
hazards.
We recommend that you keep this instruction
booklet for future reference and pass it on to any
future owners.
IMPORTANT INFORMATION
ENVIRONMENTAL TIP
Information on disposal for users
Most of the packing materials are recyclable. Please
dispose of those materials through your local
recycling depot or by placing them in a appropriate
collection bin.
If you wish to discard this product, please contact your
local authorities and ask for the correct method of
disposal.
AFTER UNPACKING THE RANGEHOOD
PLEASE REVIEW YOUR NEW ITEM TO ENSURE
THAT IT HASN’T BEEN DAMAGED IN TRANSIT
OR IS MISSING ANY COMPONENTS. FAILURE
TO REPORT ANY ISSUE WITHIN 72 HOURS OF
RECEIPT OF YOUR ITEM MAY RESULT IN
ADDITIONAL CHARGES.
TO AVOID THE RISK OF INJURY OR
DAMAGE TO THE PRODUCT IT IS
ESSENTIAL TO READ THESE
INSTRUCTIONS PRIOR TO
INSTALLATION AND USE
1
PRODUCT DESCRIPTION & CARTON CONTENTS
CARTON 1 - HOOD UNIT WITH INTEGRATED FAN MOTOR
You will be supplied with one of the three hood unit options detailed below.
OPTION 1 - INTEGRATED HOOD
MODELS INCLUDED:
X3M06S6.OU(T/B), X3M06S5.OP(T/B), X3UM06S5.OP(T/B), X3M09S6.OU(T/B), X3M09S5.OP(T/B), X3UM09S5.OP(T/B),
X3MD09S6.OU(T/B), X3MD09S5.OP(T/B), X3UD09S5.OP(T/B), X3MD12S6.OU(T/B), X3MD12S5.OP(T/B) & X3UD12S5.OP(T/B)
INCLUDED IN THE CARTON:
1. Main hood housing including switch control and led lighting
2. Bafe lters
3. Grease trap
4. Cabinet installation screws
5. Operating & installation guide
9.
Transition duct - rectangle to round outlet x 1 (Rectangle top ducted models only)
Rectangle duct extension (1x) (Rectangle back ducted models only)
10.
Rectangle aluminium powder coated wall / eave vent (1x) (Rectangle back ducted models only)
11.
OPTION 2 - WALL HUNG CANOPY HOOD
MODELS INCLUDED:
X5L09S6.OU(T/B), X5L09S6.OP(T/B), X5S09S6.OU(T/B), X5S09S6.OP(T/B), X5V09S6.OU(T/B), X5V09S6.OP(T/B),
X5R09S6.OU(T/B), X5R09S6.OP(T/B), X5R09W6.OU(T/B) & X5R09W6.OP(T/B)
INCLUDED IN THE CARTON:
1. Main hood housing including switch control and led lighting
2. Bafe lters
3. Grease trap
4. Stainless steel chimney (2x)
5. Chimney bracket
6. Wall mounting bracket
7. Fixing screws
8. Operating & installation guide
9.
Transition duct - rectangle to round outlet x 1 (Rectangle top ducted models only)
10.
Rectangle duct extension (1x) (Rectangle back ducted models only)
Rectangle aluminium powder coated wall / eave vent (1x) (Rectangle back ducted models only)
11.
OPTION 3 - ISLAND HUNG CANOPY HOOD
MODELS INCLUDED:
X7S09S6.OU/T, X7S09S6.OP/T, X7V09S6.OU/T, X7V09S6.OP/T, X7R09S6.OU/T, X7R09S6.OP/T, X7R09W6.OU/T & X7R09W6.OP/T
INCLUDED IN THE CARTON:
1. Main hood housing including switch control and led lighting
2. Bafe lters
3. Grease trap
4. Stainless steel chimney (1x)
5. Ceiling (island) mounting plate
6. Mounting Beams (2x)
7. Threaded rod (4x) and nuts
8. Fixing screws
9. Operating & installation guide
10.
Transition duct - rectangle to round outlet x 1 (Rectangle top ducted models only)
2
CONDITIONS OF USE AND MAINTENANCE
This rangehood is a domestic appliance which has been manufactured and tested to comply with Australian and New Zealand
Standard AS/NZS 60335.2.31 and is designed to work under Australian and New Zealand conditions. The hoods are designed
to remove bi-products of cooking – heat, steam, grease and odour.
This appliance is intended for domestic application only. Any other usage is at the owner’s risk and could be dangerous. The
manufacturer cannot be held liable for damage resulting from incorrect or improper use or operation. This unit is approved for
electrical safety (Please refer RCM E4759).
WHISPAIR reserves the right to change the specication without notice.
All WHISPAIR performance gures are based upon standards developed by the Haus Group, which either comply or are in excess
of the government regulated standards.
SAFETY
WARNING: The installation of WHISPAIR rangehoods must comply with the information in this guide. Failure
to install the rangehood in accordance with these installation instructions may result in electrical hazards,
injury, damage to your appliance and loss of warranty. Specically, failure by the installer to install the
screws or xing devices in accordance with these installation instructions may result in electrical hazards.
Please install the appliance as detailed in these instructions.
The rangehood is not intended for use by children or inrmed persons without supervision.
CAUTION: Accessible parts may become hot when used with cooking appliances.
Ensure the canopy rangehood is switched off and power source cable unplugged before carrying out
maintenance, to avoid any possibility of electric shock.
Always use non-ammable materials to minimize the risk of re.
Do not ambé under the range hood.
There shall be adequate ventilation of the room when the range hood is used at the same time as
appliances burning gas or other fuels.
In the case of damage to power supply cords, use only an authorized service agent or licensed electrician.
The air must not be discharged into a ue that is used for exhausting fumes from appliances burning gas
or other fuels.
Bafe lters and grease trap must be regularly cleaned to reduce the risk of re.
Always cover lit gas burners with pots or pans when cooker hood is in use.
3
DUCTING AND EXTRACTION LEVELS
WHISPAIR ducting is designed to ensure optimum performance for your rangehood. Please follow the installation instructions
carefully.
Every WHISPAIR rangehood must be ducted to the outside environment by the use of non-ammable ducting. The rangehood
must not be ducted into a wall cavity or a ceiling space where a build-up of grease can occur and become a potential re risk.
Ensure the external outlet on the KLEENAIR unit is not covered and the air ow is not restricted in any way as this may result in
reduced performance.
The duct must at all times have a cross sectional surface area equivalent to the hood outlet. The rectangular hood outlet has
an approximate area of 24,200mm and the 150mm diameter round outlet has an area of 17,696mm2. Do not reduce the
duct size at any time and avoid sharp bends. If the duct run is longer than six (6) metres, it may be necessary to enlarge the
duct size to ensure optimum performance. The manufacturer does not guarantee performance when the duct length is greater
than six (6) metres.
Ensure that all ducting is correctly tted and sealed with pipe clips, duct tape or silicone to ensure that fumes do not escape prior
to reaching the outside environment.
The WHISPAIR extraction calculations are based upon a 50pa change of head of pressure loss and are used to factor the
variance of air ow resistance through the ducting. 50pa is equivalent to approximately four (4) metres (the recommended
length) of ducting, which is above and beyond the industry standard of one straight metre of ducting. The KLEENAIR ULTRA
offers a powerful 1680 cubic metres per hour (466 litres per second) and the KLEENAIR POWER offers 1020 cubic metres per
hour (283 litres per second) of air movement.
SERVICING
The installation and tting of the rangehood should be done in such a way that will allow the unit to be removed if service is
required. Additional costs incurred in the removal, such as damage to walls, are not covered under warranty.
It is expected that the stainless steel is cleaned with a quality non-abrasive stainless steel cleaner. The bafe lters and grease
trap are removable and dishwasher safe. It is recommended that these items be cleaned regularly, at a minimum of 4 weeks.
The KLEENAIR unit should be checked regularly to ensure that nothing is obstructing the air ow from the housing.
4