Whirlpool WTW6200V, WTW6800W, WTW6300W, WTW6500W, WTW6340W Dimension Manual
...
Top Load Washer Washer
17"*
(432 mm)
1"
(25 mm)
27
1
/2"
(699 mm)
1"
(25 mm)
27"
(686 mm)
5"
(127 mm)
24
"
2*
(155 cm2)
48
"
2*
(310 cm2)
14"*max
(356 mm)
3
"
*
(76 mm)
3
"
*
(76 mm)
1"
(25 mm)
PRODUCT MODEL NUMBERS
WTW6200V, WTW6500W, WTW6800W,
WTW6300W, WTW6340W, WTW7300X,
WTW7340X, WTW7600X, WTW7800X,
WTW7990X, WTW8400Y, WTW8440Y,
WTW8600Y, WTW8800Y
Recessed or closet installation - stacked washer and dryer
A. Front view
B. Side view
C. Closet door with vents
A B C
* Required spacing
Installation spacing for recessed area or closet installation
The dimensions shown show recommended spacing allowed, with tested spacing of 0" (0 mm) clearance on sides.
■ Additional clearances might be required for wall, door, oor moldings.
■ Additional spacing should be considered for ease of installation and servicing.
■ Additional spacing on all sides of the washer is recommended to reduce noise transfer.
■ For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings are acceptable.
■ Companion appliance spacing should also be considered.
W10240438B
06/2011
ELECTRICAL REQUIREMENTS
A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is
recommended that a separate circuit serving only this appliance be provided.
DRAIN SYSTEM
The washer can be installed using the standpipe drain system (oor or wall), the laundry tub drain system, or the oor drain system.
Select the drain hose installation method you need.
Standpipe drain system - wall or oor (views A & B)
The standpipe drain requires a minimum diameter standpipe
of 2" (51 mm). The minimum carry-away capacity can be not
less than 17 gal. (64 L) per minute. A 2" (51 mm) diameter to
1" (25 mm) diameter standpipe adapter kit is available. See
"Tools and Parts".
The top of the standpipe must be at least 39" (990 mm) high
and no higher than 96" (2.4 m) from the bottom of the washer.
39"
(990 mm)
A
B
Laundry tub drain system (view C)
The laundry tub needs a minimum 20 gal. (76 L) capacity. The
top of the landry tub must be at least 39" (990 mm) above the
oor and no higher than 96" (2.4 m) from the bottom of the
washer.
Floor draim system (view D)
The oor drain system requires a siphon break that may be
purchased separately. The siphone break must be a minimum
of 28" (710 mm) from the bottom of the washer. Additional hoses
might be needed.
39"
(990 mm)
C
28"
(710 mm)
D
Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation
our products, we reserve the right to change materials and specications without notice. Instructions packed with product. Specications subject to change without notice.
Loading...