Whirlpool WTW6200V User Manual

Automatic Washer
PRODUCT MODEL NUMBERS
DRAIN SYSTEM OPTIONS
WTW6200V
Electrical: A 120-volt, 60-Hz, AC-only, 15- or 20-amp fused electrical supply is required. A time­delay fuse or circuit breaker and separate circuit serving only this appliance are recommended.
Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.
Ref. W10181465
10-15-08
RECESSED AREA AND CLOSET INSTALLATION
For closet installation, with a door, the minimum ventilation openings in the top and bottom of the door are required (view C). Louvered doors with equivalent air ventilation openings in the top and bottom are acceptable.
Standpipe drain system - wall or floor (view A & B)
The standpipe drain requires a minimum diameter standpipe of 2" (5 cm). The minimum carry-away capacity can be no less than 17 gal. (64 L) per minute.
The top of the standpipe must be at least 39" (99 cm) high and no higher than 96" (244 cm) from the bottom of the washer.
Laundry tub drain system (view C)
The laundry tub needs a minimum 20 gal. (76 L) capacity. The top of the laundry tub must be at least 39" (99 cm) above the floor and no higher than 96" (244 cm) from the bottom of the washer.
Floor drain system (view D)
The floor drain system requires a siphon break that may be purchased separately.
The siphon break must be a minimum of 28" (71 cm) from the bottom of the washer. Additional hoses might be needed.
A
Front view
B
Side view
C
Closet door with vents
Water: A water heater set to deliver 120°F (49°C) water to the washer. Hot and cold faucets located within 3 ft (90 cm) of the hot and cold water fill valves, and water pressure of 20 to 100 psi (138 to 690 kPa).
3"*
(7.6 cm)
3"*
(7.6 cm)
17"*
(43.2 cm)
1"
(2.5 cm)
271⁄2"
(69.9 cm)
1"
(2.5 cm)
1"*
(2.5 cm)
27"
(68.6 cm)
5"* (12.7 cm)
14"* max.
(35.6 cm)
48 in.
2
*
(310 cm
2
)
24 in.
2
*
(155 cm2)
1
2
28"
(71 cm)
39"
(99 cm)
*Required spacing
C
D
®
39"
(99 cm)
AB
Loading...