Whirlpool WRT313SZLZ, WRT313SZLB, WRT313SZLW Dimension Guide
3
20
/4" (527 mm)
FC Door Height
Top Mount Refrigerator
1/2" (12 mm)
Middle of
the Freezer
Model Size Height Overall
WRT313SZLW
WRT313SZLB
WRT313SZLZ
"A"
5
/16" (1684 mm) 653/8" (1661 mm) 663/16" (1681 mm) 431/4" (1099 mm) 203/4" (527 mm) 24" (610 mm) 55" (1405 mm)
66
11/16" (43 mm)
Overall Cab Height (Including
Rollers "B")
Overall Top Door Freezer to
Rollers"C")
Refrigerator Door
Height "D"
7
/16" (36 mm)
1
Freezer Door Height Cabinet Width Middle of the Freezer
Note: Millimeter dimensions are actual. Fractional inch dimensions are derived by rounding off to the nearest 1/16 inch.
1
W11532300B
13/8" (35 mm)
2713/16" (707 mm)
Maximum Overall
24" (610 mm) Cab Width
241/8" (617 mm) Door Width
225/8" (575 mm)
11/16" (17 mm)
31/8" (80 mm)
Top Mount Refrigerator
Allow at least 1" (2.54 cm) between back of cabinet
and the wall (consider the condenser as back in case
is present). If your refrigerator has an ice maker, make
sure you leave 1" (2.54 cm) at the back for the water
line connections.
Wall
90°
115/16" (50 mm)
491/16" (1246 mm)
247/16" (617 mm) End Cap Width
LOCATION REQUIREMENTS
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
To ensure proper ventilation for your refrigerator, it is recommended to allow a 1/2" (1.27 cm) space on each side. Allow 1½" (3.81 cm) of space between overhead
cabinets and refrigerator top. Allow at least 1" (2.54 cm) between back of cabinet and the wall (consider the condenser as back in case is present). If your
refrigerator has an ice maker, make sure you leave extra space at the back for the water line connections.
If you are installing your refrigerator next to a xed wall, leave 2 1/4" (5.7 cm) on the hinge side to allow the door to swing open.
This space on the hinge side also allows for crisper removal when the door is fully swung open.
NOTE: This refrigerator is intended for use in a location where the temperature ranges from a minimum of 55°F (13°C) to a maximum of 110°F (43°C). The preferred
room temperature range for optimum performance, which reduces electricity usage and provides superior cooling, is between 60°F (15°C) and 90°F (32°C). It is
recommended that you do not install the refrigerator near a heat source, such as an oven or radiator.
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.
2
115°
Maximum Aperture
Top Mount Refrigerator
31" (787.4 mm)
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Electrical: A 115 V, 60 Hz., AC only, 15 A or 20 A fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be
provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer Control depending on the
model) to OFF and then disconnect the refrigerator from the electrical source. When you are nished, reconnect the refrigerator to the electrical source and reset the
control (Thermostat, Refrigerator or Freezer Control depending on the model) to the desired setting. See “Using the Controls.”
Water: A cold water supply with water pressure between 30 and 120 psi (207 and 827 kPa) is required to operate ice maker and water dispenser. If you have questions
about your water pressure, call a licensed, qualied plumber.
IMPORTANT: The pressure of the water coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 30 and 120 psi
(207 and 827 kPa). Reverse Osmosis Water Supply: If a reverse osmosis water ltration system is connected to your cold water supply, the water pressure to the reverse
osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa).
3
Models: WRT313SZLW, WRT313SZLB, WRT313SZLZ
Top Mount Refrigerator
A
B
Freezer Shelves
Refrigerator Compartment Features
Description Width "A" Depth "B" Height "C"
FREEZER GLASS SHELF TM CHROME 183/16" (462 mm) 11" (279.19 mm) N/A
Refrigerator Shelves
Refrigerator Compartment Features
Description Width "A" Depth "B" Height "C"
BOTTOM GLASS SHELF ASSY CHROME 201/4" (514 mm) 179/16" (446.02 mm) N/A
REFRIGERATOR GLASS SHELF STANDARD
CHROME
201/4" (514 mm) 151/16" (382.49 mm) N/A
4
Models: WRT313SZLW, WRT313SZLB, WRT313SZLZ
Top Mount Refrigerator
A
B
Freezer Shelves
Refrigerator Compartment Features
Description Width "A" Depth "B" Height "C"
FREEZER GLASS SHELF TM 183/16" (462 mm) 11" (279.19 mm) N/A
Refrigerator Shelves
Refrigerator Compartment Features
Description Width "A" Depth "B" Height "C"
REFRIGERATOR GLASS SHELF STANDARD 201/4" (514 mm) 151/16" (382.49 mm) N/A
BOTTOM GLASS SHELF ASSY STANDARD 201/4" (514 mm) 179/16" (446.02 mm) N/A
5
Innity Slide Shelf
Models: WRT313SZLW, WRT313SZLB, WRT313SZLZ
Top Mount Refrigerator
A
200
B
Refrigerator Compartment Features
Description Width "A" Depth "B" Height "C"
1
Innity Slide Shelf 20
/4" (513.6 mm) 151/16" (382.8 mm)
6
CRISPER PAN
Top Mount Refrigerator
CRISPER PAN
A
Models: WRT313SZLW, WRT313SZLB, WRT313SZLZ
Refrigerator Compartment Features
Description Width "A" Depth "B" Height "C"
CRISPER PAN 1913/16" (502.5 mm) 155/16" (389.6 mm) 1015/16" (277.3 mm)
B
C
COLD SPACE DRAWER
A
Models: WRT313SZLW, WRT313SZLB, WRT313SZLZ
Refrigerator Compartment Features
Description Width "A" Depth "B" Height "C"
COLD SPACE DRAWER 201/4" (513.9 mm) 155/8" (397.5 mm) 33/4" (95.8 mm)
B
C
7
Loading...