TM |
Microwave Hood Combination |
PRODUCT MODEL NUMBERS
WMH53520C WMH76719C
ELECTRICAL REQUIREMENTS
Observe all governing codes and ordinances.
Required:
■■ A 120 volt, 60 Hz, AC only, 15or 20-amp electrical supply with a fuse or circuit breaker.
Recommended:
■■ A time-delay fuse or time-delay circuit breaker.
■■ A separate circuit serving only this microwave oven.
VENTING DESIGN SPECIFICATIONS
This section is intended for architectural designer and builder/contractor reference only.
NOTES:
■■ Vent materials needed for installation are not provided with microwave hood combination.
■■ We do not recommend using a flexible metal vent.
■■ To avoid possible product damage, be sure to vent air outside, unless using recirculation installation. Do not vent exhaust air into concealed spaces, such as spaces within walls or ceilings, attics, crawl spaces or garages.
For optimal venting installation, we recommend:
■■ Using roof or wall caps that have back draft dampers. ■■ Using a rigid metal vent.
■■ Using the most direct route by minimizing the length of the vent and number of elbows to provide efficient performance.
■■ Using uniformly sized vents.
■■ Using duct tape to seal all joints in the vent system.
■■ Using caulking compound to seal exterior wall or roof opening around cap.
■■ Not installing two elbows together for optimal hood performance.
If venting through the wall, be sure that there is proper clearance within the wall for the damper to open fully.
If venting through the roof, and rectangular to round transition is used, be sure there is at least 3" (7.6 cm) of clearance between the top of the microwave oven and the transition piece. See “Rectangular to Round Transition” illustration.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Roof venting |
Roof cap |
|||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
PRODUCT DIMENSIONS
17¹⁄"
(43.5 cm) +/- 3 ⁄16" (5 mm)
|
Up |
to |
|||
16 |
|
||||
(42. |
|
|
|
" |
|
5 |
|
³⁄ |
|||
cm)* |
|||||
|
|
||||
16¹⁄" (41.3 cm)
|
|
.0cm) |
|
"(76 |
|
⁄ |
|
|
29 |
|
|
* Overall depth of product will vary slightly depending on door design.
INSTALLATION DIMENSIONS:
NOTE: The grounded 3 prong outlet must be inside the upper cabinet. See “Electrical Requirements” section.
A B
30" (76.2 cm) min.
30" (76.2 cm) typical*
66" (167.6 cm) min.
12" (30.5 cm) min. 14" (35.6 cm) max.
upper cabinet and side cabinet depth
A.2" x 4" wall stud
B.Grounded 3 prong outlet
*30" (76.2 cm) is typical for 66" (167.6 cm) installation height. Exact dimensions may vary depending on type of range/cooktop below.
Wall venting |
|
Wall cap |
|
Page 1 of 2 |
|
|
|||
|
|
|
|
|
|
|
|
|
|
Because Whirlpool Corporation includes a continuous commitment to improve our |
Dimensions are for planning purposes only. For complete details, see Installation |
Ref. W10823835A |
||
products, we reserve the right to change materials and specifications without notice. |
Instructions packed with product. Specifications subject to change without notice. |
04/25/2017 |
||
Loading...