Whirlpool WME1832 A X, WME1624 A X, KV 1450 A, KR 325 A IL PRODUCT SHEET

FINDKNPENLFGBD SGRI
A. Refrigerator Compartment
1. Crisper drawer
2. Shelves / Shelf zone
3. Control panel/Thermostat unit with light (depending on the model)
4. Top shelf
5. Door trays
6. Bottle shelf
8. Rating plate (at side of crisper drawer)
9. Light, located under the control panel or inside the product (depending on the model)
10. Fan with filter (if present), see specific instructions for filter
B. Low temperature compartment (if present)
Notes: The number of shelves and type of accessories may vary, depending on the model.
All shelves, door trays and racks are removable.
Important: Do not clean refrigerator accessories in a dishwasher.
10b
10a
PRODUCT SHEET
GB
9
10
B
3
2
A
2
A
8
1
8
1
3
4
5
7
6
FINDKNPENLFGBD SGRI
1. Loosen the screw and remove the diffuser.
2. When replacing the lamp, bear in mind that
this appliance is fitted with a special lamp (15W with bayonet connector); to replace, do not unscrew it but pull towards the inside of the refrigerator (as indicated by the arrow).
3. Refit the diffuser and secure it with the screw.
1. Unscrew the lamp as shown in the figure
2. Replace the lamp with one of the same power
or of the max. power in watt, specified near the lamp holder.
REPLACING THE LAMP (depending on the model)
1. Thermostat knob
Thermostat to •/Off: refrigeration and refrigerator compartment light are switched off. Thermostat to 1-min: minimum refrigeration. Thermostat to 7-max: maximum refrigeration.
It is advisable to set the thermostat to 3­4/med.
The refrigerator can operate at ambient temperatures between +10°C and +38°C.
Optimum performance is obtained at temperatures between +16°C and +38°C. Note: Ambient air temperature, the frequency of door opening and the position of the appliance can affect the internal temperatures of the refrigerator. Take these factors into consideration when setting the thermostat.
REFRIGERATOR COMPARTMENT CONTROLS
(depending on the model)
Loading...
+ 1 hidden pages