Whirlpool WMC10007AW0, WMC10007AB0 Installation Guide

MICROWAVE OVEN

UNDER-THE-CABINETINSTALLATIONINSTRUCTIONS

This product is not intended for use above any heat source, such as a range or cooktop. See "Installation Requirements" section for further notes.

These installation instructions cover different models. The appearance of your particular model may differ slightly from the illustration in these installation instructions.

INSTRUCTIONSD'INSTALLATIONFOURA MICRO-ONDES

SOUSPLACARDMURAL

Ce produit n'est pas con£_u pour I'utilisation au-dessus de tous de source de chaleur, comme une cuisiniere ou table de cuisson. Voir la

section "Exigences d'installation" pour d'autres remarques.

Ces instructions d'installation sont valables pour plusieurs modeles. II se peut que I'apparence de votre propre modele soit legerement

differente de celle montree sur les illustrations dans ce document.

Table of Contents / Tabledes mati@res

MICROWAVE OVEN SAFETY .................................................. 1

INSTALLATION REQUIREMENTS ........................................... 2

Tools and Parts ......................................................................2

Location Requirements .......................................................... 2

Product Dimensions ............................................................... 2

Electrical Requirements ......................................................... 3

INSTALLATION INSTRUCTIONS ............................................. 3

Place Cabinet Template ......................................................... 3

Mark and Drill Holes ............................................................... 4

Install the Microwave Oven .................................................... 4

Complete Installation ............................................................. 5

SECURITE DU FOUR A MICRO-ONDES .......................................... 7

EXIGENCES D'INSTALLATION .......................................................... 7

Outils et pieces ................................................................................. 7

Exigences d'emplacement ............................................................... 7

Dimensions du produit ..................................................................... 7

Specifications electriques ................................................................ 8

INSTRUCTIONS [:)'INSTALLATION ................................................... 9

Placement du gabarit du placard ..................................................... 9

Marquage de I'emplacement/per_:age des trous ............................ 9

Installation du four & micro-ondes ................................................. 10

Achever I'installation ........................................................................ 11

MICROWAVE OVEN SAFETY

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety

messages.

This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."

These words mean:

You can be killed or seriously injured if you don't immediately

follow instructions.

You can be killed or seriously injured if you don't follow instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.

W10482078A/JSIM0609-18261-005

INSTALLATIONREQUIREMENTS

t'O0)S 3_J

Tools Needed Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed here.

• Measuring tape • 1/2" (13 mm) drill bit

• Pencil • 1/2" (13 mm) wood bit or

• Masking tape metal hole cutter (if

• Scissors cabinet)

• No. 2 Phillips screwdriver • Covering or microwave

• Drill oven carton

Parts Supplied (not shown to scale)

For information on reordering,see "Replacement Parts" section.

installing under a metal

NOTE: This microwave oven is intended for installation over a countertop. Do not install this microwave oven over any heat

source, such as a range or cooktop. Check the opening where the microwave oven will be installed.

The location must provide:

• Minimum cabinet depth of 12" (30.5 cm).

• Minimum cabinet lower shelf thickness of 3/16" (5 mm).

• Support for weight of at least 50 Ibs (22.7 kg), in addition to the normal contents of the cabinet, as well as any items that

might be hanging from the bottom of the cabinet.

• Grounded electrical outlet inside upper cabinet. See "Electrical Requirements" section.

To allow for adequate ventilation, which is important for product performance, a clearance of at least 2V2"(6.4 cm) must exist between the microwave oven and a side wall (or cabinetry wall) on each side.

5 mm x 80, 40 mm bolts (4)*

Spacers(8)

*Depending on cabinet shelf depth and/or cabinet trim overhang

length, bolts longer than those provided (40 mm) may be required.

C-washers (4)

Templates A and B

101/2''

(26.7 cm)

Electrical Shock Hazard

Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter.

Do not use an extension cord. Failure to follow these instructions can result in death,

fire, or electrical shock.

Observe all governing codes and ordinances.

Required:

• A 120 volt, 60 Hz, AC only, 15- or 20-amp electrical supply with a fuse or circuit breaker.

Recommended:

• A time-delay fuse or time-delay circuit breaker.

• A separate circuit serving only this microwave oven.

GROUNDING iNSTRUCTiONS

[] For all cord connected appliances:

The microwave oven must be grounded. In the event of an electrical short circuit, grounding reduces the risk of

electric shock by providing an escape wire for the electric current. The microwave oven is equipped with a cord

having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed

and grounded.

WARNING: Improper use of the grounding plug can

result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are

not completely understood, or if doubt exists as to whether the microwave oven is properly grounded.

Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install

an outlet near the microwave oven.

SAVETHESE iNSTRUCTiONS

INSTALLATIONINSTRUCTIONS

The shadowed area of Template A represents the top of the microwave oven. Make sure it is centered in the space where the

microwave oven will be installed.

// ',

/, , ,, \ \

// .....

/ / ........... $,

A B

A. Template A B. Cabinet front edge

Installation Under Cabinet without Partition

If the cabinet does not have a partition, place the template (Template A) on the lower shelf of the cabinet, as shown in the

illustration at the beginning of this section.

Tape the template into place.

Proceed to "Mark and Drill Holes" section.

Installation Under Cabinet with Partition

If the cabinet has a partition, or if the microwave oven is being installed under adjoining cabinets, cut Template B from Template A.

Cut Template A into two pieces to fit into each side of the partition.

Align each piece of Template A so that it is flush with the front edge of the cabinet, as shown.

A. Template A (in 2 pieces) B. Template B

C. Hole centerlines

D. Partition

4. Align the Hole Centerlines of Template A with those of Template B, as shown.

5. Tape the template pieces into place.

\ \

1. Mark the four hole centers through the template onto the lower shelf of the cabinet.

2. Remove the template.

Following are the dimensions for the mounting holes on Template A:

i 7s/4 '' (19.8 cm) __i.___ 4%6" ---,-i

-, 12 %6" (30.7 crn) i ,J

i (lO.9cro) ,

i i i i

t() i :

/ ' +

51_,'1e" installation | , /

(14.4 crn; space | 5 11/le"

8 11/16" i | (14.4 cm)

(22.0 crn) I 7 1;4" ;

I i I

4, i (18.4om_:

Cent;rof t t

Remove the plugs from the four mounting holes on the top of the microwave oven. Save the plugs in case the microwave oven is used as a countertop unit in the future.

_\\\\\\

" I i

(7._om_,I , I W-r-lO/lo-

_ i _4.ocm_

Cabinet front edge

3. Using 1/2" drill, drill four holes through the centers marked in Step 1.

4. Place the four C-washers near the holes inside the cabinet.

A. Plugs (4)

Start the four bolts into the mounting holes. Turn each bolt three or four times.

If the front edge of the cabinet is flush with the bottom of the cabinet (if there is no "lip" or trim overhang that extends below the cabinet bottom), proceed to Step 7.

If the front edge of the cabinet has a "lip" or trim overhang that extends below the bottom of the cabinet, measure the length

of the overhang. Spacers may need to be used on the back bolts.

A. Cabinet B. Trim overhang

Determine the number of spacers needed for the back bolts.

If the trim overhang is: Use:

less than 1/2" (13 mm) O, 1 or 2 spacers 1/2"-3/4" (13-19 mm) 2 or 3 spacers

3/4"-1" (19-25 mm) 3 or 4 spacers

6. Place the appropriate number of spacers on the back bolts.

\\\

\\\\\\

+ 8 hidden pages