® Duet® Steam Washer
PRODUCT MODEL NUMBERS |
OVERALL DIMENSIONS |
51" |
(686 mm) |
WFW9600T, WFW9450W |
|
|
27" |
|
(1295 m |
|
|
|
|
|
Electrical: 120-volt, 60 Hz, AC-only,
15 or 20 amp fused electrical supply. A time-delay fuse or circuit breaker and separate circuit is recommended.
38" 65 mm)
RECESSED AREA AND CLOSET INSTALLATIONS |
|
|
|
|
|
|
) |
|
|||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
For closet installation, with a door, the minimum ventilation |
|
|
|
|
Recommended installation spacing for |
|
|||||||
openings in the top and bottom of the door are required (view B). |
|
|
|
|
cabinet installation |
|
|
|
|||||
Louvered doors with equivalent air ventilation openings are |
Washer on Pedestal |
|
For cabinet installation, with a door, the minimum |
||||||||||
acceptable. |
|
|
3" |
|
ventilation openings in the top are required. |
|
|||||||
|
|
|
|
|
|
|
|
||||||
|
|
|
|
(76 mm) |
|
|
|
|
7" |
|
|
|
|
|
34" min. |
48 in.2 * |
|
|
|
|
|
|
(178 mm) |
7" |
|
|
|
|
(864 mm) (310 cm2) |
|
|
|
|
18" min. |
(178 mm) |
|
|
|
|||
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
|
|
|
(457 mm) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
9" |
|
|
24 in.2 * |
|
|
|
|
|
|
|
|
|
|
(229 mm) |
|
|
|
3" |
|
|
|
|
|
|
|
|
|
|
|
|
(155 cm2) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
(76 mm) |
|
|
|
|
|
|
|
|
|
1" |
311/2" 4" |
|
|
|
|
|
|
|
|
|
|
|
|
(25 mm) (800 mm) (102 mm) |
|
|
|
|
|
|
|
|
|
|
|
||
|
A |
|
B |
1" |
27" |
1" |
311/2" |
4" |
|
|
|
|
1" |
|
|
(25 mm) |
(686 mm) |
(25 mm) |
(800 mm) |
(102 mm) |
|
311/2" |
|
27" |
|||
|
|
|
|
4" |
1" |
(25 mm) |
|||||||
|
|
|
|
|
|
|
|
|
|||||
|
A. Side view - closet or confined area |
|
|
|
|
|
(102 mm) |
(800 mm) (25 mm) (686 mm) |
|
||||
|
B. Closet door with vents |
|
|
Stacked Washer and Dryer |
|
|
|
|
|
||||
|
|
|
|
|
|
|
|
|
|
|
|
||
|
|
|
|
48 in.2 * |
|
|
|
|
6" (152 mm) |
|
|
|
|
Undercounter Installation - Washer Only |
(310 cm2) |
|
|
|
|
|
|
|
bottom air |
||||
|
|
3" (76 mm) |
|
|
|
|
|
||||||
|
|
|
|
|
|
|
|
|
|
|
*Min. top and |
||
Dimensions shown are the recommended spacing. |
|
|
|
|
|
|
|
openings for |
|||||
|
|
|
|
|
|
|
|
|
|
|
|
closet door. |
|
|
|
|
|
|
|
|
|
|
|
|
|
**External exhaust |
|
|
|
|
|
|
|
|
|
|
76" |
|
|
elbow requires |
|
|
|
|
|
|
|
|
|
|
|
|
additional space. |
||
|
|
|
|
|
|
|
|
|
(1930 mm) |
|
|||
|
39" min. |
|
|
|
|
|
|
|
|
***Wall, door and |
|||
|
|
|
|
|
|
|
|
|
|
|
|||
(990 mm) |
|
|
|
|
|
|
|
|
|
|
floor molding may |
||
|
|
|
|
|
|
|
|
|
|
|
|
require additional |
|
|
|
|
|
|
|
|
|
|
|
|
|
spacing. |
|
|
1" |
27" |
1" |
|
|
|
|
|
|
|
|
|
|
|
(25 mm) |
(686 mm) |
(25 mm) |
|
|
3" (76 mm) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
DRAIN SYSTEM OPTIONS |
|
24 in.2 * |
|
|
1" |
|
51/2"** |
(686 mm) |
(250 mm) |
|
|||
|
(155 cm2) |
|
|
(25 mm) |
|
(250 mm) |
|
||||||
|
|
|
|
|
|
|
(140 mm) |
|
27" |
1" *** |
|
||
|
|
|
|
|
|
|
|
|
1" *** |
|
|
Standpipe drain system - wall or floor (view A & B)
The standpipe drain requires a minimum diameter standpipe of 2" (50 mm). The minimum carry-away capacity can be no less than 17 gal. (64 L) per minute.
The top of the standpipe must be at least 30" (762 mm) high and no higher than
96" (2.4 m) from the bottom of the washer.
30" min. (762 mm)
Laundry tub drain system (view A)
The laundry tub needs a minimum
20 gal. (76 L) capacity. The top of the laundry tub must be at least 30" (762 mm) above the floor.
30" min. (762 mm)
Floor drain system (view B)
The floor drain system requires a siphon break that may be purchased separately.
The siphon break must be a minimum of 28" (710 mm) from the bottom of the washer.
Additional hoses might be needed.
28" min. (710 mm)
A |
B |
A |
B |
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation |
Ref. W10254043 |
Instructions packed with product. Specifications subject to change without notice. |
05/2009 |
|