Whirlpool WFG530S0ES, WFG515S0EW, WFG515S0ET, WFG515S0ES, WFG530S0EB Specification Sheet

30" (76.2 cm) Freestanding Gas Range

A

B

C

PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS

WFG515S0E WFG530S0E

Type of Gas

Natural Gas:

• This range is factory set for use with Natural gas. See “Gas
Conversions” section. The model/serial rating plate is located on the
oven frame behind the top left side of the oven door has information
on the types of gas that can be used. If the types of gas listed do not
include the type of gas available, check with the local gas supplier.

LP gas conversion:

Conversion must be done by a qualified service technician.

No attempt shall be made to convert the appliance from the gas
specified on the model/serial rating plate for use with a different gas
without consulting the serving gas supplier. See “Gas Conversions”
section.

Gas Supply Line

• Provide a gas supply line if 3/4" (1.9 cm) rigid pipe to the range
location. A smaller pipe on longer runs may result in insuffient
gas supply. With LP gas, piping or tubing size can be 1/2" (1.3 cm)
minimum. Usually, LP gas suppliers deteremine the size and materials
used in the system. NOTE: Pipe-joint compounds that resist the
action of LP gas must be used. Do not use TEFLON tape.

Flexible metal appliance connector:

• If local codes permit, a new CSA design-certified, 4 to 5 ft (122
to 152.4 cm) long, 1/2" (1.3 cm)
or 3/4" (1.9 cm) I.D., flexible metal
appliance connector may be used for
connecting range to the gas supply line.

• A 1/2" (1.3 cm) male pipe thread is needed for connection to the
female pipe threads of the inlet to the appliance pressure regulator.

• Do not kink or damage the flexible metal tubing when moving the
range.

• Must include a shutoff valve:
The supply line must be equipped with a manual shutoff valve. This
valve should be located in the same room but external to the range
opening, such as an adjacent cabinet. It should be in a location that
allows ease of opening and closing. Do not block access to shutoff
valve. The valve is for turning on or shutting off gas to the range.

A

F

E

D

IMPORTANT: Range must be level after installation. Follow
the instructions in the “Level Range” section. Using the cooktop
as a reference for leveling the range is not recommended.

* Range can be raised approximately 1" (2.5 cm) by adjusting

the leveling legs.

** Front of door and drawer may extend further forward

depending on styling.

Electrical

A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is
required. A time-delay fuse or circuit breaker is also recommended.
It is recommended that a separate circuit serving only this range be
provided.

7

/8" (70.8 cm) max. depth

A. 27

with handle

B. 36" (91.4 cm) cooktop

height (max.) with leveling
legs screwed all the way in*

C. 467/8" (119.1 cm) overall

height (max.) with leveling
legs screwed all the way in*

D. 297/8" (75.9 cm) width

C

E. 257/16" (64.3 cm) depth.

B

Back of range to front
of cooktop**

F. Model/serial rating plate

(located on the oven frame
behind the top left side of
the oven door)

A. Gas supply line
B. Shutoff valve “open” position
C. To range

†®

TEFLON is a registered trademark of E.I. Du Point De Nemours and Company.

CABINET OPENING DIMENSIONS

A. 18" (45.7 cm) upper side cabinet to

countertop

B. 13" (33 cm) max. upper cabinet

depth
C. 30" (76.2 cm) min. opening width
D. For minimum clearance to top of

cooktop, see NOTE *.
E. 301/8" (76.5 cm) min. opening width

F. The shaded areas are recommended

for installation of rigid gas pipe.
G. 4 1/2" (11.4 cm)
H. 8" (20.3 cm)

I. 17" (43.2 cm)

J. 2" (5.1 cm)
K. 41/2" (11.4)
L. 2" (5.1 cm) min. clearance from both

sides of range to side wall or other

combustible material.
M. Grounded outlet
N. Cabinet door or hinges should not

B

C

A

L

F

K

E

M

H

G

I

J

D

F

K

Cabinet opening dimensions shown are for 25" (64.0 cm)
countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm)
countertop height.

IMPORTANT: If installing a range hood or microwave hood combination
above the range, following the range hood or microwave hoods
combination instructions for dimensional clearances above
the cooktop surface.
A freestanding range may be installed next to combustible walls with
zero clearance.
* NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet

is covered by not less than 1/4" (0.64 cm) flame retardant millboard
covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm)
stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking

N

platform and the bottom of an uncovered wood or metal cabinet.

extend into the cutout.

Because Whirlpool Corporation includes a continues commitment to improve our products,

we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see

Installation Instructions packed with product. Specifications subject

to change without notice.

Ref. W10658550

08/10/15

B