Whirlpool WED5050LW, YWED5050LW, WGD5050LW Dimension Guide

Dimension Guide

YWED5010LW, WED5050LW,
YWED5050LW- Electric

401∕2"

Height

WGD5050LW - Gas

W11462169A

283∕8"

Depth

29"

Width

DETAILED PLANNING DIMENSIONS

WARNING: To reduce the risk of re, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS and

INSTALLATION INSTRUCTIONS, located in your appliance's Owner's Manual, before installing and operating this appliance.

Electrical Requirements

Fuel Type Electric Gas

Minimum Circuit
Amperage Rating

Maximum AMP Draw 26 A 6 A
Operating Voltage 120/240 V - AC only 120 V - AC only
Current Canada Rating 24 A N/A
Operating Frequency 60 Hz

30 A 15 A

D

B

22.8"

(579.36 mm)

90°

A

C

G

E

F

Product Dimensions

in mm

A Height (With leveling legs not extended) 401∕
B Width 29 737
C Top Height (with min. feet) 367∕
D Depth 283∕
E Top Height (With leveling legs fully extended) 381∕
F Height (With leveling legs fully extended) 421∕
G Depth with Door Open 5011∕

2

8

8

2

8

16

1028

937
722

978
1069
1288

2

DETAILED PLANNING DIMENSIONS

Electric Gas

H

T

I

R

J

K

L

M

N

S

O

P

Q

Product Dimensions

in mm

H Strain Relief from Side (elec) 153∕

I Strain Relief Height (elec) (With leveling legs not extended) 281∕

J Exhaust Duct from Side 147∕

K Power Cord from Side (gas) 143∕

L Power Cord Height (gas) 323∕

M Gas Connection (With leveling legs not extended) 111∕

N Gas Connection from Side 93∕

O Strain Relief Height (elec) (With leveling legs fully extended) 293∕

P Exhaust Duct Height (With leveling legs fully extended) 611∕

Q Gas Connection (With leveling legs fully extended) 3 5∕

R Exhaust Duct Height (With leveling legs not extended) 51∕
S Water Inlet Height (on steam models only) 321∕
T Water Inlet from Side (on steam models only) 4 101

Gas Power Cord Length 60 1525

Power Cord Length (Canadian) 523∕

4

8

16

4

8

16

16

4

16

16

16

8

8

400
714
366
375
822

43
234
755
170

84
128
816

1330

3

DETAILED PLANNING DIMENSIONS

Spacing for recessed area or closet installation

The dimensions shown are for the recommended spacing allowed.

Ƀ Additional spacing should be considered for ease of installation and servicing.
Ƀ Additional clearances might be required for wall, door, and oor moldings.
Ƀ Additional spacing of 1" (25 mm) on all sides of the dryer is recommended to reduce noise transfer.
Ƀ For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors

with equivalent ventilations openings are acceptable.

Ƀ Companion appliance spacing should also be considered.

14" max

(356 mm)

3"

(76 mm)

18"

(460 mm)

2

48 in

(310 cm)

6"/0"*

(152 mm/0 mm)

1"/0"*

(25 mm/0 mm)

*Recommended/Minimum spacing

3"

(76 mm)

1"

(25 mm)

2

2/

24 in

24"

24"

(155 cm)

2

4