Whirlpool WDP350PAAW5, WDP350PAAW3, WDP350PAAW1, WDP350PAAW2, WDP350PAAB5 Installation Guide

...
iNSTALLATiON iNSTRUCTiONS
PORTABLEDISHWASHER
PLASTICGIANT TUB MODELS
iNSTRUCTiONS D'INSTALLATION
LAVE-VAISSELLEENCASTRE
MODELES A TRESGRANDE CUVE EN PLASTIQUE
Table of Contents ................................................ 2
Table des mati_res ............................................... 7
W10255025A
Dishwasher Safety ............................................2
InstallationRequirements .....................................3
Toolsand Parts...............................................3
Location Requirements .......................................3
Water Supply Requirements ..................................3
ElectricalRequirements ......................................3
Caster Installation.............................................4
Prepare the Dishwasher .......................................4
Connecting Dishwasher ....................................... 5
Connecting faucet adapter ................................... 5
Connecting to water and electrical supply ..................... 5
Using the faucet .............................................. 6
Disconnecting the dishwasher ................................ 6
Storing ........................................................ 6
Storing for the summer ....................................... 6
Winterizing your dishwasher .................................. 6
DISHWASHERSAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.
This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING." These words mean:
You can be killed or seriously injured if you don't immediately follow instructions.
You can be killed or seriously injured if you don't follow
instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.
You Need fo:
Slowly open dishwasher door while someone grasps the rear of the dishwasher. Remove shipping materials, drain hose and lower
rack. Close dishwasher door until latched.
Observe all governing codes and ordinances.
Prepare dishwasher and faucet for use as specified in these instructions.
Tip Over Hazard
Do not use dishwasher unti_ completely installed.
Do not push down on open door. Doing so can result in serious injury or cuts.
Have everything you need to properly install dishwasher. The dishwasher must be installed to meet all electrical and plumbing
national and local codes and ordinances.
iNSTALLATiON REQUIREMENTS
Water Supply Requirements
Tools and Parts
Gather the recommended tools and parts before starting installation. Read and follow the instructions provided with any tools
listed here.
All installations
Tools needed:
Pliers _Sy _ ,small I
i
Parts supplied:
FauCet adapte[ kit;
! Part NUmbers374592 ] cas! e S [ Literature Ij
Make sure all these parts were included in the parts bag. Close and latch dishwasher door. See parts list for accessories available for your
dishwasher.
NOTE: Parts are available for purchase in plumbing supply stores. Check local codes. Check existing electrical supply. See "Electrical Requirements" section. It is recommended that electrical connections be made by a licensed electrical installer.
•nammer _ j
A hot water line with 20-120 psi (138-862 kPa) water pressure can be verified by a licensed plumber.
120°F (49°C) water at dishwasher.
Electrical Requirements
Be sure that the electrical connection and wire size are adequate and in conformance with the National Electrical Code, ANSl/NFPA
70 - latest edition and all local codes and ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02269
You must have:
120-volt, 60 Hz, AC-only, 15- or 20- amp, fused electrical supply.
mating grounded electrical outlet.
We recommend:
a time-delay fuse or circuit breaker.
a separate circuit.
Location Requirements
Grounded electrical supply is required.
Sink or laundry tub that can drain water at a minimum carry-away capacity of 7 gal. (26 L) per minute.
Top of sink or laundry tub that is at least 27" (68.6 cm) high and not higher than 48" ( 122 cm) from the bottom of dishwasher.
Floor support for dishwasher weight of 180 Ibs (81.6 kg).
Grounded electrical outlet.
Hot water faucet or hot and cold single-spout water faucet
within 30" (76.2 cm) of the back of dishwasher.
20-120 psi (103-827 kPa) water pressure.
CASTER iNSTALLATiON
Excessive Weight Hazard
Use two or more people to move and install dishwasher.
Failure to do so can result in back or other injury.
PREPARETHEDISHWASHER
Tip Over Hazard
Do not use dishwasher until completely installed. Do not pushdown on open door.
Doingso can result in serious injury or cuts.
Excessive Weight Hazard
Usetwo or more people to move and install
dishwasher. Failure to do so can result inback or other injury.
Grasp sides of dishwasher door frame and put dishwasher on its back.
Firmly push casters into holes at corners of dishwasher as shown. Pull on each caster to check that casters are snug.
Helpful Tip: It may be helpful to place a piece of wood between the caster wheels and then lightly tap the wood with a hammer.
4
Stand dishwasher upright. Open door and remove shipping foam, cardboard tower and any other shipping materials. Close
dishwasher door. Latch dishwasher door shut.
Loading...
+ 8 hidden pages