Whirlpool WAT PRIMELINE 32 DI, WAT PRIMELINE 30 DI INSTRUCTION FOR USE

GB WAT Primeline

A. Programme selector

B. Time display

C. “Start Delay” button

D. “Spin” button

E. “Start” button

F. Programme sequence indicator

G. “Reset” button

H. “Door open” indication

PROGRAMME CHART

This washing machine is equipped with

F

B

J

K

C

D

A

H

I

G

E

automatic safety functions which detect and
diagnose faults at an early stage and react
appropriately:

I. “Service” indication
J. “Water tap closed” indication
K. “Clean pump” indication

1)

Do not use liquid detergent for main wash if you

have activated prewash option.

2)

Do not use liquid detergent when activating the

“Start delay”.

3)

For improved garment care, spin speed is restricted

in these programmes.

Programme

Cotton/

Hygienic+

40 - 60 - 95 °C

SuperEco

60 °C

Synthetics

30 - 40 - 60 °C

Delicates

30 - 40 °C

Daily load

40 °C

Quick wash

30 °C

Wool

Cold - 40 °C

Handwash

40 °C

Lingerie

30 °C

Rinse & Spin

Koch-

Buntwäsche/

Hygiene +

40 - 60 - 95°C

SuperEco

60°C

Pflegeleicht

30 - 40 - 60°C

Feinwäsche

30 - 40°C

Mischwäsche

40°C

Schnelle

Wäsche 30min.

30°C

Wolle

Kalt - 40°C

Handwäsche

40°C

Dessous

30°C

Spülen &

Schleudern

Spin Schleudern – 5.5

Drain Abpumpen – –

 = optional / Yes = dosing required

Care

Labels

– 5.5

Max.
Load

- for temperature selection, respect the manufacturer's recommendations on the care label

kg

Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of
cotton and linen.

Selecting “Cotton 95”, this programme eleiminates bacteria, ensuring sanitization of your

5.5

laundry. The bacteria removal efficiency has been tested following a similar methodology to the
NF EN 13697 standard of Nov. 2001.

Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc. made of
cotton and/or linen.

Offers highest economy in energy consumption by prolonged wash duration. Ideal to be run

5.5

overnight to additionally profit from the more favourable energy rates. To avoid noise of spinning
at night, set spin speed to “0” and start spin programme in the morning, or define programme
start with “Start Delay” accordingly. Use with maximum load.

Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide

3.0

(Perlon, Nylon).

Curtains and delicate clothing, dresses, skirts, shirts and blouses.

1.5

Slightly to normally soiled textiles made of cotton and/or synthetics.

3.0

Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton.

3.0

Only woollens with a felt-free finish, labelled with the woolmark and identified as machine
washable.

1.0

This programme (40ºC) is tested and approved by The Woolmark Company for machine
washable wool.

Textiles made of linen, silk, wool and viscose marked as “handwashable”.
This programme (40ºC) is tested and approved by The Woolmark Company for

1.0

handwashable wool.

A very gentle spin is used in this programme.

This programme is particularly suitable to treat delicate lingerie (use of a laundry net

1.0

strongly recommended).

Same as the last rinse and the final spin in the “Cotton” programme.

In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.

Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.

The wool and handwash cycles of this machine have been tested and approved by The Woolmark Company for
the washing of Woolmark garments labelled as “machine wash” or “hand wash”provided that the garments are
washed according to the instructions on the garment label and those issued in this programme chart.

Type of wash / Notes

M0703

Detergents and Additives Special options Max.

Pre-

Main

wash

Wash

1)

Yes



– Yes

1)

Yes



1)

Yes



– Yes

– Yes

– Yes

– Yes

– Yes

– –

– – –

– – –

Softener Start

Delay

Start

vorwahl

 

 

 

 

 

 

 

 

 

 





Clean+

Clean+

2)

2)

2)

2)

2)

2)

2)

2)

2)

Pre-

Short

wash

Vor-

wäsche

Kurz

Intensive

Intensiv-

rinse

spülen

Rinse

hold

Spül-

stopp

     

– – –

  

     

–

– – –

– – –

– – – –

– – – –

– – – –

– – –

– –



 

  

  

 

 

 

  

– – – – –

– – – – – – –

Bauknecht is a registered trademark.

Variable

Schleu-

spin

dern



Spin

Speed

rpm

max.

max.

1000

1000

max.

max.

1000

400

400

max.

max.

5019 412 10120

3)

3)

3)

3)

3)

CONSUMPTION DATA

Programme

Temperature

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx. Programme

Duration***

(hours : minutes)

White Cotton / Hygienic+ 95 5.5 55* 1.70 1:55

Cotton** 60 5.5 49 0.93 2:35

Cotton 40 5.5 53 0.55 2:00

SuperEco 60 5.5 49 0.73 4:00
Synthetics 60 3.0 54* 0.90 1:40
Synthetics 40 3.0 48 0.55 1:25

Delicates 40 1.5 51 0.50 0:45
Daily load 40 3.0 43 0.48 1:00

Quick wash 30 3.0 36 0.30 0:30

Wool

40 1.0 53 0.50 0:45

Handwash 40 1.0 43 0.50 0:35

Lingerie 30 1.0 42 0.30 0:31

Prewash cycle increases programme duration by aproximately 20 min. Consumption values were measured in normalized conditions in
compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to
the water supply pressure and temperature, the load and the type of wash.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water
out.
** Reference Programme for Energy Label.
*** The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions
applicable at that time.

PREPARATION OF THE WASH CYCLE

1. Load the machine, close the drum doors and check
that they are properly locked.

2. Add detergent as indicated on the front page and as
described in the chapter “Detergents and Additives”
in your Instructions for Use, and close the lid.

3. Turn the programme selector to the desired
programme and temperature. The time display
shows the duration of the chosen programme (in
hours and minutes), and the lamp next to the
“Start” button blinks. The indication lamp of the
predefined spin speed lights up.

4. The spin speed indicated can be altered by pressing
the “Spin” button.

SELECT THE DESIRED OPTION(S)

Selecting or deselecting an option can be done at
any time during the programme. The option will be
applied as long as the corresponding programme
phase has not been executed yet.
When the combination of programme and
additional option(s) is not possible, the indication
lights switch off automatically.
“Clean+” button

• Choose this option if you use an in-wash additive for
stain removal (powder, for example “Vanish”) - it
will optimize the additive’s efficiency to get better
wash performance and stain removal.

• Selectable for programmes “Cotton” and
“Synthetics”; choose temperature of 30 or 40°C and
use with maximum load.

• Add an appropriate amount of in-wash additive for
stain removal (powder) to the main wash chamber,
together with your detergent (only use powder
detergent with this option). Respect the

• Prolongs the programme by approx. 10 to 15 minutes.

• Appropriate for use of stain removers and bleaches
on oxygen basis. Chlorine or perborate bleaches

must not be used!
“Prewash” button

• Only for heavily soiled loads (for example sand,
granular dirt) sensible. Increases the cycle time by
approximately 20 min.

• Do not use liquid detergents for the main wash when
activating the prewash option.

“Short” button

• Reduces water consumption, above all during rinsing.

• Suitable for lightly soiled laundry and small loads
(max. 3 kg).

“Intensive Rinse” button

• The amount of water is increased to ensure a more

intensive rinse.

• This option is particularly suitable for areas with very
soft water, washing baby linen and people with skin
allergies.

“Rinse Hold” button

• The laundry remains in the last rinse water without

progressing to the final spin cycle to avoid creasing
and prevent colours from changing.

• This option is particularly recommended for the
“Synthetics”, “Daily load” and “Delicates”
programmes.

• It is useful if you want to postpone spinning to a later
time, or if you want to drain out only.

• If you select “Rinse Hold”, do not leave items to
soak for too long.

• As soon as the appliance stops in the rinse hold, the
“Rinse hold” lamp of the sequence indicator lights up
and the lamp next to the “Start” button flashes.

manufacturer’s dosing instructions.

Terminate the “Rinse Hold” option:

• Press the “Start” button; the programme will

terminate automatically with the final spin cycle for
the present wash programme.

• If you do not wish to spin the clothes, turn the
programme selector knob to the “Drain”
programme and press the “Start” button.

“Variable spin” button

• Every programme has a predefined spin speed.

• Press the button to set another spin speed.

• If spin speed “0” is selected, the final spinning is

cancelled but intermediate spin peaks remain during
the rinse. The water is drained out only.

START DELAY

The “Start delay” button allows the user to run the
machine at his convenience, for example at night when
electricity is cheaper.

• Select programme, spin speed and options.

• Press the “Start Delay” button several times to

select a delay time by 1 to 23 hours.

• Press the “Start” button - the countdown of the
delay time begins. The light of the “Start delay”
button and the dot on the display will keep blinking
until the programme starts.

• As soon as the programme starts, the light over the
“Start Delay” button goes off and the time delay
on the display is replaced by the remaining
programme time.

• After the “Start” button has been pressed, the
number of hours preselected can be reduced by
pressing again the “Start delay” button.

To cancel the “Start delay”
..before you press the “Start” button:

• Turn the programme selector to another position
or press the “Reset” button.
..after having pressed the “Start” button:

• Press the “Reset” button for at least 3 second. The

start delay indicator light goes off.

PROGRAMME START

Open the tap and press the “Start” button. The
indication lamp next to the “Start” button lights up.
The programme sequence indicator shows the current
programme phase, running from left to right through
Wash, Rinse, Spin/Drain. When the programme phrase is
finised, the corresponding indication goes out.

• Note: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where it
was interrupted.

“DOOR OPEN” INDICATION

Before starting and after end of a programme, the lamp
lights to show the the lid can be opened. As long as a
wash programme is running, the lid remains locked and
must on no account be forced open. In case you have
an urgent need to open it during a running programme,
refer to “Cancel (Reset) a running programme before
the end”.

RED INDICATIONS

“Service”

Lighting up of the “Service” indication can be caused
by a fault in an electrical component. Refer to the
“Troubleshooting Guide” in your “Instructions for Use”;
if the fault persists, contact our After Sales Service.

“Water tap closed”

The appliance has no or insufficient water supply. Open
the water tap; if the indications still lights up, refer to the
“Troubleshooting Guide” in the Instructions for Use.

“Clean pump”

Waste water is not pumped out. Check whether the
drain hose is kinked or the filter must be cleaned; in the
latter case refer to the Instructions for Use (“Removing
the Filter”).

PROGRAMME END

All the lights of the programme sequence indicator are
off, and the “Door open” indication lights up.

1. Turn the programme selector to the “Off/O”
position.

2. Close the water tap.

3. Open lid and drum and unload the machine.

4. Leave the lid open for some time to allow the
interior of the machine to dry.

CHANGE PROGRAMME AND/OR OPTIONS
AFTER PROGRAMME START

1. Press the “Start” button to pause the programme.
The light blinks.

2. Select the new programme, any options and another
spin speed if you want.

3. Press the “Start” button again. The new
programme continues at the same position where
the previous programme was interrupted. Do not
add detergent for this programme.

CANCEL (RESET) A RUNNING PROGRAMME
BEFORE THE END

The “Reset” button cancels a programme before the
end. Press the “Reset” button for at least 3 seconds;
“rES” appears on the display. Any existing water is
drained out before the lid can be opened.

Bauknecht is a registered trademark.

5019 412 10120