Whirlpool WAT 9555D PROGRAM CHART

WAT 9555

PROGRAMME TABLE

Programme Type of fabrics / Degree of soiling / Notes Max.

Cotton

Coloured

Cotton

Synthetics

Chrono

programme

Delicates

Wool

Handwash

Rinse + Spin

Intensive Spin

Averagely soiled, hard wearing and temperature stable textiles in cotton and linen (bed linen, table linen, underwear, shirts etc.). The max. load for heavily soiled laundry is 3.5 kg.

Averagely soiled, hard wearing and temperature stable textiles in cotton and linen (bed linen, table linen, underwear, shirts etc.).

Lightly or averagely soiled blouses, skirts, etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or cotton blends.

Lightly soiled outer garments and sportswear made of cotton, polyester, polyamide and cotton blend.

Delicate curtains, dresses, skirts and blouses. 1.5 Yes Yes Only machine washable woollens with pure new wool label. If

you select the special function “Rinse Hold” do not leave garments to soak for too long.

Silk and other textiles, which are labelled with “Handwash”. For improved garment care the spin speed is restricted to 400 rpm. For no spin, select the option “Rinse Hold”. When the option light is flashing, turn the programme selector to “Drain” and press the “Start/Pause”.

Programme for treating wash with starch or softener. Terminates with an intensive spin cycle.

Programme for Intensive spin cycle. 5.0 — — —

Load

5.0 Yes Yes

2.5 Yes Yes

3.0 — Yes

1.0 — Yes

5.0 — —

Detergent and Additives Options Temperature°C Spin Speed

Pre-

Wash Softener Bleach Pre-

wash

❉❉❉❉❉ ❉ ❉

❉

❉ ❉

❉

—

—— —

—

—— —

—

Intensive

wash

❉❉❉ ❉ ❉

❉

———

A. Waterstop indication B. Programme sequence indication

C. Spin speed reduction button D. Start/Pause

Rinse

Hold

Spin speed

reduction

❉❉❉

—

❉❉❉ ❉❉❉

❉

—

❉❉❉

❉❉

Start

Delay

❉

rpm/min

95 Min. to 1200

30-40-60 Min. to 1200

30-40-60 Min. to 1000

30 Min. to 1200

30-40 Min. to 1000

-30-40

— Min. to 1200

Min. to 1000

No spin to

Min. to 1200

400

Spin

Drain

Programme for gentle spin cycle. 1.5 — —

Drain only, without spin cyc le. Al te rn ati v e w ay of te rm ina ti n g programmes with “Rinse Hold” setting.

———

—

——— —

—

❉❉

N.B.: This appliance is controlled by sensors. The excess of detergent in the dispenser could cause technical problems.

—

❉

——

Min. to 1000

5019 100 12574

Programme

Cotton

Coloured Cotton

Synthetics Synthetics

Chrono programme

Delicates

Wool

Handwash

Prewash cycle increases programme duration by 5 to 20 min. Consumption values were measured in normalized conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.

The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. **To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

Temperature selector (°C)

CONSUMPTION DATA

60 5.0 48 1.15 125 60 2.0 54 0.70 89 40 2.0 50 0.50 74 30 3.0 35 0.40 30 40 1.5 50 0.50 45 40 1.0 50 0.50 42 30 1.0 35 0.40 25

Load

(kg)

5.0 49 1.60 120

Water

(l)

Energy

(kWh)

Programme

duration (min) *

ADDING DETERGENT AND ADDITIVES

Add the detergent and the additives into the dispenser as follows:

• Programme with pre and main wash

• Main wash programme without prewash

• Fabric softeners and conditioners

• Chlorine bleach

• Stain remover agents

• Anti-scale agents (water hardness 4)

Important:

• Be careful not to fill more than the

• For programme with pre-wash: do not use liquid detergents.

• For programmes without prewash from cold to 40° C it is recommended to use a liquid detergent

to avoid whitish residues on the coloured laundry.

• With a Start delay, use a dose aid for liquid detergent, placed directly in the drum.

“MAX”

level mark.

CLOSE THE DOOR AND SELECT THE PROGRAMME

1. Turn the

• The remaining time display “” shows the duration of the chosen programme (in hours and

minutes) and the

2. The programme sequence and the predefined spin speed indication corresponding to the

selected programme lights up.

PRESS ANY DESIRED OPTION BUTTON(S).

An audible tone sounds if the combination of programm e and additio nal options i s not possi ble. Unsuitable combinations of options are deselected automatically

Prewash button

• Only for heavily soiled loads (for example sand, granular dirt) sensible. The cycle time increases

from 5 to 20 min.

Intensive Rinse button

• The water level and the cycle time increase for improved rinsing efficiency.

• This option is particularly suitable for areas with very soft water washing baby linen and helps

people with allergies.

Rinse Hold button

• The laundry remains in the last rinse water without progressing to the final spin cycle to avoid

creasing and prevent colours from changing.

• This option is particularly recommended for the programme Synthetics “” or Delicates “”.

• This function is particularly useful if you want to postpone spinning to a later time.

programme selector knob

Start/Pause

“”

button “” is flashing.

to the desired programme with its predefined temperature.

The pilot lamp lights up

Note:

The programme stops to “Rinse Hold” at the time the Rinse Hold button “” light flashes.

Terminate the “Rinse Hold” option:

• Press the Rinse Hold button “” again; the programme will terminate automatically with the final spin cycle for the present wash programme.

• If you do not wish to spin the clothes, turn the programme selector knob to the drain programme “” and start again.

Spin speed reduction button

• Every programme has an automatic predefined maximum spin speed.

• Press the button “” to set another spin speed.

• If no lamps are on, the final spinning is canceled.

“”

START DELAY

The Start Delay allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper.

• Press the Start Delay button “” to select the delay time by 1 to 19 hours;

• Press the

• The time delay indication disappear when the programme starts and it’s replaced by the remaining time “”.

• The number of hours preselected can later be reduced pressing ag ain the St art Delay button “”.

To cancel the “Start Delay”.

• Turn the programme selector to the

• Reselect the desired programme and options and press the

Start/Pause

button “”. The “Start Delay” light flashes until the programme starts.

“”

position.

Start/Pause

button “”.

PROGRAMME START

Open the tap and press the indicator lamps show the sequence reached in the programme. After starting the programme, the

sequence indication runs from left to right through Wash “”, Rinse “”, Spin “”. When the sequence of the programme is finished the corresponding lamps goes out.

Start/Pause

button “”. The pilot lamp of the “” button lights up. The

DOOR LOCK

During the running programme the door can be opened for adding further laundry. The door locks automatically in all rinsing and spinning cycles. If the programme is stopped or the

electrical power supply is terminated, the door lock will open after approximately 1 minute.

PROGRAMME END

• The remaining time is on “0:00” and all the lights of the programme sequence indication are “Off”. A short audible tone sounds three times.

1. Turn the programme selector to the position

2. Turn the water supply tap off.

3. Open the door and the drum flaps and unload the machine.

“”

SELECTING A NEW PROGRAMME, SPIN SPEED, OPTI ONS AFTER PROGRAMME ST ART

1. Press the

2. Select the new programme (with temperature), any options and another spin speed if you want it.

3. Press the programme sequence indication. Do not add detergent for this programme.

Start/Pause

button “” to pause the programme. The light flashes. button “” again. The programme continues at the same position of the

TO STOP, RESET A PROGRAMME BEFORE THE END

1. Press the

2. Set the programme selector to Drain “”. The spin indications are off and the remaining time shows 2 minutes.

3. Press the

Start/Pause

button “” to pause the programme. The lights flashes.

button “” to start the drain programme.

AUTOMATIC SAFETY FUNCTIONS / FAULTS

This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately. Often, however, the faults detected are small enough to be solved in a matter of minutes. Informations can be found in the “Troubleshooting Guide”.

5019 100 12574

Whirlpool WAT 9555D PROGRAM CHART

Specifications and Main Features

Frequently Asked Questions

User Manual