Whirlpool WAT 9365WP, WAT 9369WP INSTRUCTION FOR USE

WAT 9369 WP

PROGRAMME TABLE

ABC

E F

A. Waterstop indication B. Water tap indication C. Programme sequence indication

D. Spin speed reduction button E. Start Delay button F. Start/Pause button

Programme Type of fabrics / Degree of soiling / Notes Max.

Averagely soiled, hard wearing and temperat ure sta ble

Cotton

Kochwäsche

Coloured Cotton

Bunt- und Kochwäsche

Synthetic

Pflegeleicht

Chrono programme

Kleine Wäsche

Delicates

Feinwäsche

Wool

Wolle

Handwash

Hand Wäsche

Rinse + Spin

Spülen + Schleudern

Intensive Spin

Intensivschleudern

Gentle Spin

Schonschleudern

Drain

Abpumpen

textiles in cotton and linen (bed linen, table linen, underwear, shirts etc.). The max. load for heavily soiled laundry is 3.5 kg.

Averagely soiled, hard wearing and temperature stable textiles in cotton and linen (bed linen, table linen, underwear, shirts etc.).

Lightly or averagely soiled blouses, skirts, etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or cotton blends.

Lightly soiled outer garments and sportswear made of

cotton, polyester, polyamide and cotton blend. Delicate curtains, dresses, skirts and blouses. 1.5 Yes Yes Only machine washable woollens with pure new wool

label. If you select the special function “Rinse Hold” do not leave garments to soak for too long.

Silk and other textiles, which are labelle d with “Handw ash”.

For improved garment care the spin speed is restricted to

400 rpm. For no spin, select the option “Rinse Hold”. When

the option light is flashing, turn the programme selector to

“Drain” and press the “Start/Pause”. Programme for treating wash with starch or softener.

Terminates with an intensive spin cycle.

Programme for Intensive spin cycle. 5.0

Programme for gentle spin cycle. 1.5 Drain only, without spin cycle. Alternative way of

terminating programmes with “Rinse Hold” setting.

Load

Normal 5.0

Rapid 3.0

Normal 5.0

Rapid 3.0

Normal 2.5

Rapid 1.5

3.0

1.0

5.0

—

Detergent and Additives Options Temperature°C Spin Speed

Pre-

Wash Softener Rapid Pre-

wash

Yes Yes

—

Yes

❉❉❉❉❉ ❉ ❉

❉❉❉❉❉ ❉ ❉ ❉

❉

—

Yes

—

Yes

——

—— —

❉

—— —

—

—— —

—— — —

—— — — —

wash

❉

Intensive

Rinse

—

Rinse

Hold

Spin

speed

reduction

❉❉❉ ❉❉❉

❉❉❉

❉

—

❉❉❉

❉❉ ❉❉

N.B.: This appliance is controlled by sensors. The excess of detergent in the dispenser could cause technical problems.

Start

Delay

❉

rpm/min

Min. to 1000

30-40-60 Min. to 1000

30-40-60 Min. to 800

30 Min. to 1000

30-40 Min. to 800

Cold-30-40 Min. to 800

30 No spin to 400

Cold Min. to 1000

—

Min. to 1000

Min. to 800

—

5019 100 12640

Programme

Cotton

Coloured Cotton 60 5.0 48 0.95 120

Synthetic 60 2.0 54 0.70 89 Synthetic 40 2.0 50 0.50 74

Chrono programme 30 3.0 35 0.40 30

Delicates 40 1.5 50 0.50 45

Wool 40 1.0 50 0.50 42

Handwash 30 1.0 35 0.40 25

Prewash cycle increases programme duration by 5 to 20 min. Consumption values were measured in normalized conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.

The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. **To reduce the water tempera tu r e, some cold water is added at the end of the main was h cycle, before the pump drains the water out.

Temperature selector (°C)

CONSUMPTION DATA

Rated Load

(kg)

5.0 49

Water

(l)

Energy

(kWh)

1.60 125

Programme

duration (min) *

ADDING DETERGENT AND ADDITIVES

Add the detergent and the additives into th e dispenser as follows:

• Pro gra mme with pre and mai n wash

• Main wash programme without prewash

• Fabric softeners and conditioners

• Stain remover agents

• Anti-scale agents (water hardness 4)

Important:

• Be careful not to fill more than the

• For programme with prewash: do not use liquid detergents.

• For programmes without prewash from cold to 40° C it is recommended to use

a liquid detergent to avoid whiti sh residue s on the col oured laun dry.

• With a Start delay, use a dose aid for liquid detergent, placed directly in the drum.

“MAX”

level mark.

CLOSE THE DOOR AND SELECT THE PROGRAMME

1. Turn the

• The remaining time display shows the duration of the chosen programme (in hours and minutes) and

2. The programme sequence and the predefined spin sp eed indication corresponding to the selected

programme selector knob

the pilot lamp of the programme lights up.

“Start/Pause”

PRESS ANY DESIRED OPTION BUTTON(S).

An audible tone sounds if the combination of programme and additional options is not possible. Unsuitable combinations of options are deselected automatically “Rapid” button

• For quick, economical washes. Ideal for minimum loads of lightly-soiled articles.

“Prewash” button

• Only for heavily soiled loads (for example sand, granular dirt) sensible. The cycle time increases from 5

to 20 min.

“Intensive Rinse” button

• The water level and the cycle time increase for improved rinsing efficiency.

• This option is particularly suitable for areas with very soft water washing baby linen and helps people

with allergies.

“Rinse Hold” button

• The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing

and prevent colours from changing.

• This option is particularly recommended for the programme “Synthetic” or “Delicate”.

• This function is particularly useful if you want to postpone spinning to a later time.

to the desired programme with its predefined temperature.

button is flashing.

The pilot lamp lights up.

The programme stops to “Rinse Hold” at the time the “Rinse Hold” button light flashes.

Note: Terminate the “Rinse Hold” option:

• Press the “Rinse Ho ld” button again; the programme will terminate automatically with the final spin cycle for the present wash programme.

• If you do not wish to spin the clothes, turn the programme selector knob to the drain programme and “Start” again.

“Spin speed reduction” button

• Every programme has an automatic predefined maximum spin speed.

• Press the button to set another spin speed.

• If no lamps are on, the final spinning is canceled.

START DELAY

The Start Delay allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper.

• Press the “Start Delay” button to select the delay time by 1 to 19 hours;

• Press the

• The time delay indication disappears when the programme starts and it’s replaced by the remaining time.

• Th e nu mber of ho urs pr ese l ecte d ca n la te r be redu ced pressin g ag ai n the “Start Delay” button.

To cancel the “Start Delay”.

• Turn the programme selector to the “” position.

• Reselect the desired programme and options and press the

“Start/Pause”

PROGRAMME START

Open the tap and press the indicator lamps show the sequence reached in the programme. After starting the programme, the sequence indication runs from left to right through Wash, Rinse, Spin. When the seque nce of the programme is finishe d the corresponding lamps goes out.

DOOR LOCK

During the running programme the door can be opened f or adding further laundry. The door locks automatically in all rinsing and spinning cycles. If the programme is stopped or the electrical

power supply is terminated, the door lock will open after approximately 1 minute.

PROGRAMME END

• The remaining time is on “0:00” and all the lights of the programme sequence indication are “Off”. A short audible tone sounds three times.

1. Turn the programme selector to the position “”.

2. Turn the water supply tap off.

3. Open the door and the drum flaps and unload the machine.

SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER PROGRAMME START

1. Press the

2. Select the new programme (with temperature), any option s and another spin speed if you want it.

3. Press the programme sequence indication. Do not add detergent for this programme.

“Start/Pause”

TO STOP, RESET A PROGRAMME BEFORE THE END

1. Press the

2. Set the programme selector to “Drain”. The spin indications are off and the remaining time shows 2 minutes.

3. Press the

“Start/Pause”

AUTOMATIC SAFETY FUNCTIONS / FAULTS

This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately. Often, however, the faults detected are small enough to be solved in a matter of minutes. Informations can be found in the “Troubleshooting Guide”.

button. The “Start Delay” light flashes until the programme starts.

“Start/Pause”

button to pause the programme. The light flashes.

button again. The programme continues at the same position of the

button to pause the programme. Th e lights flashes.

button to start the drain programme.

button. The pilot lamp of the

button.

“Start/Pause”

button lights up. The

5019 100 12640