Whirlpool WAT 53510/2 PROGRAM CHART

GB WAT 53510

Programme

Cotton with prewash

Koch-Buntwäsche mit Vorwäsche

Coton-Couleurs avec prélavage

Synthetic with prewash

Pflegeleicht mit Vorwäsche

Synthétiques avec prélavage

Delicate with prewash

Feinwäsche mit Vorwäsche

Délicats avec prélavage

Cotton

Koch- Buntwäsche

Coton-Couleurs

Cotton short

Koch- Buntwäsche kurz

Coton-Couleurs

Synthetic

Pflegeleicht; Synthétiques

Synthetic short

Pflegeleicht kurz; Synthétiques

Spülen + Schleudern; Rinçage + Essorage

Schonschleudern; Essorage Court

Delicate

Feinwäsche; Délicats

Wool

Wolle; Laine

Handwash

Handwäsche; Lavage Main

Rinse + Gentle Spin

Spülen + Schonschleudern;

Rinçage + Essorage Court

Rinse + Spin

Spin

Schleudern; Essorage

Gentle spin

Drain

Abpumpen; Vidange

N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.

Care

Labels

—

Type of wash / Notes

Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.

Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.

Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.

Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.

Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc., made of cotton and linen.

Slightly to normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.

Slightly soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton.

Curtains and delicate clothing, dresses, skirts, shirts and blouses. Only woollens with a felt-free finish, labelled with the woolmark and identified as

machine washable. If you select “Rinse Hold” do not leave items to soak for too long.

Textiles made of silk, linen, wool and viscose marked as “handwashable”. If you select “Rinse Hold” do not leave items to soak for too long.

Same as the last two rinses and the final spin in the “Synthetic” programme. Programme for treating wash with starch or softener.

Same as the last rinse and the final spin in the “Cotton” programme. In this programme spinning is intensive or gentle.

In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.

In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.

Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.

A. Temperature Selection Knob B. “Spin Speed Reduction” Button C. “On/Off” Button (“Ein/Aus”;

Max.

load

5.0

2.0

1.5

5.0

3.0

2.0

1.5

1.0

2.0

5.0

2.0

—

Detergents and additives Special Options

Pre-

wash

Yes

—

— —

— — ——

—— ————— —————— — — —————— — — — ——

Main Wash

Yes

Softe-

ner

“Mar./Ar.”

Bleach

)

Eco

Easy

Ironing

Öko

Bügel-

leicht

Eco

Repassage

Facile

❉

: Option

Yes: dosing required

Do not use liquid detergents.

For improved garment care, spin speed is restricted to 600 rpm in this programme, even if the spin speed reduction button is not pressed.

For improved garment care, spin speed is zero in this programme.

Intensive

Rinse

Intensiv

Spülen

Rinçage

Plus

Rinse

Hold

Spülstopp

Arrêt Cuve

Pleine

Spin Speed

Reduction

❉❉❉❉ ❉ ❉ ❉ ❉ ❉

❉❉ ❉ ❉ ❉

—

—— — —

❉❉

❉❉❉❉ ❉ ❉ ❉ ❉

——

❉

—

❉

——

❉

—— — —

❉

—— — —

❉

—— — —

❉

—— — —

❉

——

❉❉ ❉ ❉

—

❉

❉❉ ❉ ❉ ❉

❉❉ ❉❉

❉❉ ❉❉ ❉ ❉❉

❉ ❉

— ——

❉❉

5019 412 10023

Tem pe -

rature

Max. 95 1000

Max. 60 600

Max. 40 600

Max. 95 1000

Max. 60 1000

Max. 60 600

Max. 40 600

Max. 30

°C

—

— — —

Max.

Spin

Speed

rpm

—

600

1000

600

CONSUMPTION DATA

Programme

Cotton Cotton

Cotton Synthetic Synthetic

Delicate

Wool

Handwash

Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.

The data on the “Energy Label” refer to the programme “Cotton 60°C”.

* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump

drains the water out.

Temperature Selector

(°C)

95 5.0 63* 1.80 2:05 60 5.0 55 0.95 2:05 40 5.0 55 0.55 2:05 60 2.0 56 0.80 1:35 40 2.0 50 0.40 1:30 40 1.5 60 0.55 0:50 40 1.0 60 0.50 0:40 30 1.0 60 0.30 0:50

PREPARATION OF WASH CYCLE

1. Load the machine, close the drum flaps and check that they are properly locked.

2. Add detergents and additives into the dispenser to no more than the

“MAX

” level

mark, as follows:

• Programme with pre and main wash

• Main wash programme without prewash

• Fabric softeners and conditioners

• Chlorine bleach

• Stain remover agents

• Anti-scale agents (if necessary)

3. Turn the

programme selector knob

to the

desired programme.

4. Turn the

temperature selector knob

the desired temperature.

5. Press the

spin speed reduction button,

desired.

• If you want to cancel the final spin, select

Load

(kg)

Water

(l)

Energy

(kWh)

Approx. Programme

Duration

(hours : minutes)

SELECT THE DESIRED OPTION

Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet.

“Eco” button

(“Öko”; “Eco”)

• The duration of the wash is extended and the max temperature reduced to save up to 40% of energy compared to a normal wash but maintaining good washing results.

“Easy Ironing” button

(“Bügelleicht”; “Repassage Facile”)

• Can be used together with “Cotton” and “Synthetic” programmes to make ironing easier.

• Increases the water quantity in rinsing and the clothes are spun in a softer manner.

“Intensive Rinse” button

(“Intensiv Spülen”; “Rinçage Plus”)

• One rinse cycle is added to ensure a more intensive rinse.

• This option is particularly suitable for areas

with very soft water, washing baby linen and people with detergents allergies.

the rinse hold option and drain the water after the cycle has finished

(see Appliance

in “Rinse Hold”).

“Rinse Hold” button

(“Spülstopp”; “Arrêt Cuve Pleine”)

• The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from fading.

• This option is particularly recommended for the “Synthetic” or “Delicate” programmes.

• This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only.

Appliance in “Rinse Hold”

(“Spülstopp”; “Arrêt Cuve Pleine”)

• Press the “Rinse Hold” button again: the programme will terminate automatically with the selected spin cycle.

• If you do not wish to spin the clothes, press the “

On/Off

” button

(“Ein/Aus”; Mar./Ar.)

, turn the programme selector knob to the “Drain” programme and press the “ button

(“Ein/Aus”; Mar./Ar.)

again.

On/Off

PROGRAMME START

Turn on the tap and press the “

(“Ein/Aus”; Mar./Ar.)

“

On/Off

” button

. The indicator light of the

(“Ein/Aus”; Mar./Ar.)

On/Off

” button

lights

up.

: If there is a power interruption or if the

Note

appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted.

END OF WASH CYCLE

• The programme selector knob is in the Stop position “ ”.

1. Press the “

to switch off the machine.

Ar.)

On/Off

” button

(“Ein/Aus”; Mar./

2. Cancel the options.

3. Turn the tap off.

4. Wait for the door to unlock (about 1minute).

5. Open the door and the drum flaps and unload the machine.

CHANGE THE PROGRAMME DURING THE WASH CYCLE

1. Switch off the machine by pressing the “

On/Off

” button

(“Ein/Aus”; Mar./Ar.)

2. Select the new programme.

3. Start programme by pressing the “ button

(“Ein/Aus”; Mar./Ar.)

again.

PAUSE/INTERRUPT A PROGRAMME

If, for any reason, you wish to interrupt the programme for a certain time and continue it later:

1. Press the “

Ar.)

On/Off

” button

(“Ein/Aus”; Mar./

2. After the desired pause, press again the

“On/Off”

”

CANCEL PROGRAMME

button

(“Ein/Aus”; Mar./Ar.)

1. Switch off the machine by pressing the “

On/Off

” button

(“Ein/Aus”; Mar./Ar.)

2. Set the programme selector to “Drain”.

3. Press the “

again to start the “Drain” programme.

Ar.)

On/Off

” button

(“Ein/Aus”; Mar./

On/Off

”

5019 412 10023