Whirlpool WA 8385W, WA 8588W, WA 7733, WA STUTTGART 1600, WA 8955 User Manual

...
YOUR ELECTRONIC WASHING MACHINE GB
This washing machine is equipped with all-e lectron ic con trol, wh ich ope ns up a host of possi bi litie s for you. Amongst others, these include: precise determination of load, imbalance detection and correct ion system, fast prog ramme changing, accurat e programme sequence indicator, start delay, soaking, safety feature
The
load determining facility
optimises the washing procedure accordingly. The machine adapts automatically to the prevailing circumstances: if you are washing a minimum load, the programme carries out only two rinse cycles during the cotton and synthetics programmes, while keeping the rinse results very good. You save on water, energy and time as a result.
Thanks to its circumstances, achieving favourable consumption figures even in the case of small loads. Water supply temperature and pressure, quantity of water and degree of loading, are the parameters taken into account. The progamme duration is influenced by these factors. This is checked and updated at particular stages of the programme. Consequently, the programme duration can vary by up to 60 minutes.
The
imbalance detection and correction system
imbalance is too great on initiating a spin cycle. This may occur with a badly distributed load or in the case of single large laundry item. The laundry is re-distributed and the spin speed is not increased until satisfactory laundry distribution has been achieved.
If you happen to have selected the wrong programme, you can quickly change programme at any time, without needing to add new detergent. Select the desired programme and start the appliance. The new program resumes the wash programme at the same stage at which the preceding one was interrupted.
The
accurate sequence indicator
LED indicators coming on: after starting the programme, the programme sequence indicator moves from left to right passing through “Wash”, “Rinse”, “Spin”. Once the current stage of the programme has been completed that LED indicator goes out.
Dynamic-Sense Technology
evaluates the laundry load at the start of the wash cycle and
the appliance adapts optimally to the prevailing
protects your washing machine if the
shows what stage of the programme has been reached by
Dynamic-Sense Technol ogy
,
.
The washing process is subdivided into three phases which corresponds to the three wash LEDs:
1.
Enzyme phase
dissolved.
2.
Heating-up phase
3.
Washing phase
Using the
hours in advance. You can set th e programme start t ime so that t he laun dry will b e compl eted by a particular time, thus allowing you to t ak e adv an ta ge of f av oura bl e l owe r e lec tricity tariffs at night.
In order to soak particularly heavily soiled colourfast laundry, select the “Coloured” programme and,
once the water has been fed in, press the you can leave the laundry to You can continue the programme by pressing the
Depending on the washing machine type, it may be equ ipped with the anti-fl ood s afety fea tur e
intelligent Water Stop system
water leakage and brings this to your attention with an audible alarm.
“Start Delay”
: at low temperature, organic soiling such as e.g. blood, milk and egg are
: the water is heated up to the selected washing temperature.
: the laundry is washed and, if the temperature is raised, whitened.
option (if present) you can select the programme start time from 1 to 19
“Start/Pause”
as long as you want.
soak
”: Even while switched off your washing machine is able to dete ct
button. The programme is interrupted and
“Start/Pause”
button once again.
21
LAUNDRY CARE LABELS
WASH
Resistant cotton
Synthetics
Delicates
The figures correspond to the maximum permitted washing temperatures.
Hand-washed items
Do not wash Chlorine bleaching possible
Chlorine bleaching not possible
Dry cleanable
Not dry cleanable
DRY
Dry at normal temperature
Dry at a lower temperat ure
IRON
Hot iron
Use medium hot iron Do not use hot iron Do not iron
Do not dry in tumble dryer
22
QUICK REFERENCE GUIDE GB
BEFORE USING THE APPLIANCE FOR THE FIRST TIME:
FOLLOW THE “INSTALLATION INSTRUCTIONS
REMOVE THE TRANSIT BOLTS BEFORE USING THE APPLIANCE.
First wash cycle without laundry:
Turn on the tap.
1.
Close the appliance door.
2.
Pour a small amount of detergent (about 30 ml) into the detergent dispenser .
3.
Select a short program (see programme chart).
4.
The
5.
6.
This initial cycle serves to eliminate any water remaining after your appliance was tested at the factory.
NORMAL DAILY USE:
1.
2.
3.
4.
5.
6.
IMPORTANT: During the first 15 minutes of the “Cotton”, “Coulored cotton” and “Synthetics”
programmes the door can be opened for adding laundry (“Door Free” indicator). This is not possible if “Rapid” is selected.
“Power On”
The pilot lamp of the Press the
Turn on the tap. Sort the wash according to fabric type and colour and load the appliance. Close the door. Put in detergent and any additives required into the dispenser. Select the programme, the temperature and any special options required. The pilot lamp of the
Press the
indication shows that the machine is switched on.
“Start/Pause”
“Start/Pause”
“Start/Pause”
“Start/Pause”
button.
button.
button flashes.
button flashes.
”.
23
GB CONTENTS
YOUR ELECTRONIC WASHING MACHINE LAUNDRY CARE LABELS APPLIANCE AND ACCESSORIES CHILD SAFETY PROTECTING THE ENVIRONMENT SAFETY INSTRUCTIONS TRANSPORT / HANDLING PREPARING THE WASH DETERGENT AND ADDITIVES DYEING AND BLEACHING
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
21 22 25 25 26 26 26 27 28
29 PROGRAMME SELECTION / PROGRAMME START START DELAY DOOR LOCK / PROGRAMME END CHANGING / INTERRUPTING /
CLEARING PROGRAMME REMOVING THE FILTER / DRAINING RESIDUAL WATER CARE AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE INSTALLATION INSTRUCTIONS
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
29 29 30
30
30 32 33 35 35
24
APPLIANCE AND ACCESSORIES
1. Worktop
2. Control panel
3. Detergent dispenser
4. After-Sales Service sticker (on the back side of the door)
5. Door
6. Door handle
- To open the door press the button on the inside of the handle and pull
- Close the door by pushing it firmly (the lock will click into place)
7. Child safety (inside door)
8. Filter (behind cover)
9. Plinth
10.Residual water drain (behind the plinth)
CHILD SAFETY
To protect the appliance from improper use, turn the plastic screw on the interior of the do or using a coin or the thick rounded plastic projection on the coloured insert from the detergent dispenser.
1. Slot vertical: safety position, i.e. the door will not lock.
2. Slot horizontal: normal position, i.e. the door can be
locked again.
25
PROTECTING THE ENVIRONMENT
PACKING
The packing material is 100% recyclable (marked with the recycling symbol ). Adhere to local regulations when disposing of packaging material.
The packaging material (plastic bags, polystyrene parts, etc.) is potentially dangerous and must be kept out of reach of children.
PRODUCT
The appliance is made from recyclable materials and must be scrapped in accordance with local waste di spo sal regulations.
Before scrapping, cut off the po wer c ab le so the appliance cannot be connected to the mains.
ENVIRONMENTAL TIPS
Do not exceed the deterg en t do sag es indicated in the Manufactu re r’s in st ru ct ion s.
The Eco Flap - a special system in the outlet will prevent detergent loss from t he d r um t o avoid detergent loss into the environment.
Remove detergent from compartment if you intend scrapping your appliance.
MAXIMISE THE LOAD SIZE
Achieve the best use of energy, water, detergent and time by using th e recommended maximum load size.
DO YOU NEED TO PREWASH?
Use “Prewash” for heavily soiled laundry only! Save detergent, time, water and between 5 to 15 % energy consumption by not selecting “Prewash” for slight to normally soiled laundry.
IS A HOT WASH REQUIRED?
Pretreat stains with stain remover or soak dried in stains in water before washing to reduce the necessity of a h ot was h program.
Save up to 50% energy by using a 60° C instead of a 90° C wash programme or a 40° C instead of a 60°C wash programme.
BEFORE USING A DRYING PROGRAMME
Save energy and time by selecting a high spin speed to reduce the water content in laundry before using a drying programme (for machines with adjustable spin s pee d).
SAFETY INSTRUCTIONS
Use the appliance only for domestic washing and for its intended application.
Ensure the installation of electrical and water connections have been made in accordance with the Manufacturer’s instructio ns and in observance of local safety regulations (refer to “Installation Instructions”).
Before cleaning or maintaining the appliance , switch it off and unplug it.
When the appliance is not in use unplug it and turn off the tap.
TRANSPORT / HANDLING
1.
Unplug the appliance.
2.
Turn off the tap.
3.
Remove the water supply and drain hose.
Do not attempt to force the do or o pe n.
Do not allow children to play with the appliance or enter the drum. Do not rest any weight on the door.
Packing materials can be dangerous for children: keep all packing materials (plastic bags, polystyrene, etc.) well out of their rea ch.
The appliance conforms to European safety regulations and to Directive n. 93/68/EEC and standard 93/68/EC.
4.
Eliminate all water from the hoses and from the appliance (see “Removing the Filter / Draining Residual Water”).
5.
Fit the transit bolts (obligatory) (see “Installation Instructions”).
26
Loading...
+ 12 hidden pages