Whirlpool TS 4046 PROGRAM CHART
GB TS 4046
Programme
Cotton with
prewash
Cotton
Coulored
Synthetics
Rinse + Spin
Prelavado
Algodón 90°
Mixtas 60°
Sintéticos 40°
Aclarado
Care
Labels
–
Type of wash / Notes
Heavily soiled sheets, tablecloths, underdothes, shirts etc., in hard
wearing and high temperature resistant cotton.
The maximum load for heavily soiled washing is 3,5 kg.
Moderately soiled sheets, tablecloths, underdothes, towels etc., in hard
wearing and high emperature resistant cotton.
Averagely soiled blouses, shirts etc., made of polyester (Diolen,
Trevira), polyamide (Perlon, Nylon), cotton or cotton blends.
Lightly soiled shirts, blouses etc., made of polyester (Diolen, Trevira),
polyamide (Perlon, Nylon) or cotton blends.
This programme allows starch or softener to be added.
It is followed by an intensive spin cycle.
“On/Off”
Max.
load
kg
5,0 Yes 1)Yes
5,0 – Yes
Cotton only
5,0
Mixed fabrics
2,0
2,0 – Yes
5,0 – –
Pre-
wash
– Yes
Programme duration figures (guideline) are
valid for maximum temperature wash with no
additional options.
i : option / Yes: dosing required
1)
Do not use liquid detergents.
Detergents and additives Option Tempera-
Main
Softener Bleach Cold
wash
i i i i i
i i i i i
i
i
i
wash
Lavado
–
–
–
Half
load
1/2
frío
carga
centrifugado
i
i i i
i i i
–
No
spin
No
i
ture
°C
90 400 130
90 400 115
60 400 85
40 400 70
Cold 400 20
Maximum
Spin
speed
rpm
Programme
time
approx.
min.
Spin
Delicate
Wool
Rinse + Spin
Spin
Drain
Centrifugado
Delicados 40°
Lana
Aclarado
Centrifugado
Vaciado
– Programme for intensive spin cycle. 5,0 – – – – – –
Delicate fabrics and curtains (dresses, skirts, shirts, blouses, etc.). 1,5 – Yes
Machine washable woollens with pure new wool label. 1,0 – Yes
This programme allows starch or softener to be added.
–
It is followed by a gentle spin cycle.
– Programme for gentle spin cycle. 1,5 – – – – – –
– Drain only, without spin cycle. – – – – – – – – – – 5
N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.
1,5 – –
i
i
i
i
–
–
–
i
i
i
–
–
–
i
i
i
i
– 400 15
40 400 55
40 400 45
Cold 400 15
– 400 10
5019 612 10097
ENERGY AND WATER CONSUMPTION DATA
Temperature
Programme
Cotton 90 5,0 72 1,80 115
Coloured 60 5,0 72 1,15 115
Coloured 60 2,0 66 0,80 85
Synthetics 40 2,0 66 0,40 100
Synthetics + 1/2 load 40 1,0 54 0,30 70
Delicate 40 1,5 70 0,65 55
Wool 40 1,0 70 0,65 45
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values
in the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Coloured 60°C”.
PREPARATION OF WASH CYCLE PRESS ANY DESIRED OPTION BUTTON(S)
1. Close the drum flaps and check that they are
properly locked.
2. Add detergents and additives into the dispenser
to no more then the “MAX” level mark, as
follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
3. Turn the programme selector knob clockwise
to the desired programme.
selector
(°C)
Load
(kg)
Water
(l)
“Cold wash” button
• This option suppresses the heating of the water.
• You can use this option with all washing cycles.
“Half load” button
• Reduces the water consumption in the “Cotton”
and “Synthetics” programmes especially during
the rinse.
• Especially suitable for lightly soiled or small
loads (reduces the quantity of detergents).
• Not suitable for high temperature programmes.
“No spin” button
• Excludes spinning from programme, press
button.
Suitable for delicate laundry.
Note: with “Cotton” and “Synthetic” programmes a
short spin cycle is provided in any case, even if the
exclusion has been selected, in order to optimize
rinsing results.
Energy
(kWh)
Programme time
(min)
PROGRAMME START
Open the water inlet tap and press the “On/Off”
button. The pilot lamp lights up.
DOOR LOCK
During the running programme, the door cannot be
opened.
The door locks automatically in all programmes.
If the programme is stopped or if an electrical power
failure occurs, the door unlocks automatically after
about 1 minute.
PROGRAMME END
• The programme selector knob is at “STOP”,
the pilot lamp lights.
1. Press the “On/Off” button, the pilot lamp goes
out.
2. Cancel the options by pressing the appropriate
buttons.
3. Turn the water supply tap off.
4. Wait for the door to unlock (about 1 minute).
5. Open the door and the drum flaps and unload
the machine.
SELECTING A NEW PROGRAMME, SPIN
SPEED, OPTIONS AFTER PROGRAMME
START
1. Press the “On/Off” button to switch off the
appliance.
The pilot lampt goes out.
2. Select the new programme, temperature and
options.
3. Press the “On/Off” button to switch on the
appliance.
The pilot lamp lights.
TO STOP, RESET A PROGRAMME BEFORE
THE END
1. Press the “On/Off” button to switch off the
appliance.
The pilot lamp goes out.
2. Set the programme selector on “Drain”.
3. Press the “On/Off” button to start the “Drain”
programme.
Only open the door when the programme
selector is at “STOP” and the door is unlocked
(after approximately 1 minute).
NOTES AND INDICATIONS FOR USE
• After switching your washing machine on, it
does not start immediately: it needs some
second in order to lock the door, fill water and
then drum starts turning.
• Spinning has an interrupted start-up: the drum
starts and stops running several times, to
improve spin efficiency and to better balance
the laundry.
• At the end of the spinning cycle the drum goes
on reversing for some minutes: this helps you
unloading the laundry.
• Do not exceed in detergents dosage: excessive
foam formation may prevent spinning.
• If you want to change the programme during
the wash cycle, remember to switch the
machine off before turning the programme
selector knob.
5019 612 10097
Loading...