Whirlpool ARC 0060/S, TTB 14/S, ARL 620/S, ARC 0070/AL, ARC 0060/S-LH User Manual

60202001GB.fm Page 12 Monday, July 11, 2005 5:37 PM

ISTRUCTIONS FOR USE

PRODUCT DESCRIPTION
REPLACING BULBS
BEFORE USING THE APPLIANCE
SAFEGUARDING THE ENVIRONMENT
PRECAUTIONS AND GENERAL

RECOMMENDATIONS
HOW TO OPERATE THE REFRIGERATOR

COMPARTMENT
HOW TO DEFROST THE REFRIGERATOR
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE/AFTER-SALES

SERVICE
AFTER-SALES SERVICE
INSTALLATION
ELECTRICAL CONNECTION

12

60202001GB.fm Page 13 Monday, July 11, 2005 5:37 PM

PRODUCT DESCRIPTION

A Low temperature compartment
B Low temperature compartment door
C Water collection tray
D Adjustable shelves and grids
ECrisper drawer
F Temperature adjustment thermostat

REPLACING BULBS

Replacing bulbs

Press as shown in the figure.

1.

Pull towards the inside of the appliance.

2.

Replace the bulb (max 15W).

3.

G Rating plate (at the side of the cripser

drawer)
H Adjustable foot
I Door seal spacers for transport purposes

(remove and discard)

13

60202001GB.fm Page 14 Monday, July 11, 2005 5:37 PM

BEFORE USING THE APPLIANCE

Your new appliance is designed exclusively for

•

domestic use

To get the most out of your new appliance,
read the user handbook thoroughly. The
handbook contains a description of the
appliance and useful tips for storing food.

Keep this handbook for future consultation.

After unpacking, make sure that the appliance

1.

is undamaged and that the door closes
properly. Any damage must be reported to
your dealer within 24 hours after delivery of
the appliance.
Wait at least two hours before switching the

2.

appliance on in order to ensure the refrigerant
circuit is fully efficient.
Installation of the appliance and electrical

3.

connections must be carried out by a qualified
electrician, in accordance with the
manufacturer's instructions and local safety
regulations
Clean the inside of the appliance before using it.

4.

SAFEGUARDING THE ENVIRONMENT

1.Packing

The packaging material is entirely recyclable,
and marked with the recycling symbol. Follow
local regulations for scrapping. Keep the
packaging materials (plastic bags, polystyrene
parts, etc.) out of reach of children, as they are
potentially dangerous.

2.Scrapping

The appliance is manufactured using recyclable
material.
This appliance is marked according to the
European directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly,
you will help prevent potential negative
consequences for the environment and human
health, which could otherwise be caused by
inappropriate waste handling of this product.

The symbol on the product, or on the
documents accompanying the product, indicates
that this appliance may not be treated as
household waste. Instead it shall be handed over
to the applicable collection point for the
recycling of electrical and electronic equipment.
Before scrapping, make the appliance unusable
by cutting off the power cable and removing the
doors and shelves so that children cannot easily
climb inside the appliance.
Disposal must be carried out in accordance with
local environmental regulations for waste
disposal. Deliver the appliance immediately to
an authorized dump; do not leave it unattended
even for a few days, since it is potentially
dangerous for children. For more detailed
information about treatment, recovery and
recycling of this product, please contact your
local city office, your household waste disposal
service or the shop where you purchased the
product.

14

Information:

This appliance does not contain CFCs (replaced
with R134a) or HFCs (replaced with R600a).
Appliances with Isobutane (R600a):
isobutane is a naturally occurring, low
environmental impact gas. Caution is required,
however, because isobutane is flammable.
Therefore, it is essential to ensure that
refrigerant pipelines are not damaged.

Declaration of conformity

This appliance is designed to store food and is

•

manufactured in conformity with European
Directive 90/128/EEC, 02/72/EEC and
Regulation (EC) No. 1935/2004

This appliance is designed, manufactured, and

•

retailed in compliance with:

- the safety objectives of the Low Voltage
Directive 73/23/EEC;

- the protection requirements of the “EMC”
Directive 89/336/EEC
amended by Directive 93/68/EEC.

The electrical safety of the appliance can only

•

be guaranteed if the product is connected to
an approved earth connection.