Page 1
MACHINE OPERATION
Sort laundry according to
care symbols
Do not tumble dry
Suitable for tumble drying at low temperatures
Suitable for tumble drying
Preparing laundry
Loading dryer
Selecting programme
Selecting options
(if available)
Starting dryer
Programme end -
unloading dryer
Switching dryer off
Additional information (including troubleshooting and service) can be found in the individual chapters of the
Instructions for use.
Sort laundry by:
Material thickness: whenever there is greater load than the dryer can handle,
separate laundry according to weight (e.g. dry towels and thin underwear separately).
Ty p e o f m a t e r i a l: cotton (linen); synthetic textiles (easy care).
Degree of drying: cupboard dry, iron dry, etc.
Do not tumble dry: nylon stockings, delicate embroidery, fabrics with metallic
decorations, bulky items such as pillows.
Check that all fastenings are closed and that pockets are empty.
Please ensure that there are no lighters in the laundry. Turn laundry inside out.
Place laundry loosely in the drum to achieve equal drying throughout.
Then close the door.
Select the drying programme required by turning the programme selector knob (for
information, refer to programme table).
Select the option required by pressing the corresponding button. The indicator lamp
above the relevant button lights up to confirm your selection. A fast blinking led
indicates a wrong selection is made (incompatible options). Press the button again to
cancel the option.
The drying programme is started by pressing the “Start (Pause)” button. The
relevant indicator lamp lights up.
Changing programme selection: if the programme selected is changed during
drying, the dryer stops. The “Start (Pause)” indicator lamp flashes. To operate the
new programme, again press the “Start (Pause)” button.
Interrupting programme: to interrupt a drying cycle, press the “Start (Pause)”
button and open the door. Wait at least 5 minutes, to allow the laundry to cool down,
before you unload the dryer. For your safety the drying cycle stops automatically if
you open the door. To restart, after door opening, close the door and press the
“Start (Pause)” button again.
Warning: never stop a tumble dryer before the end of the drying cycle, unless all
items are quickly removed and spread out so that the heat is dissipated.
The final part of a drying cycle occurs without heat (cool down cycle) to ensure that
the items reach a lower temperature to avoid wrinkling.
Anticrease: if the laundry is not removed at the end of the drying cycle, an automatic
anticrease cycle will operate for maximum 15 min (by choosing the option
“Anticrease” this time can be extended up to 12 hours). The drum rotates to prevent
the laundry from creasing.
End: take the laundry out of the dryer. The drying process is complete and the anticrease phase has been reached (active).
Cleaning the door filter after every cycle: open door, pull door filter up and out of machine and open it. Brush lint using a soft
brush or your fingertips. Close door filter and push firmly back into place.
Emptying water container: pull container out by the handle and empty. Replace the container when empty by pushing it
completely back into place.
Please note: only use additives/plastic items specified as dryer safe. Rinse items that have been treated with stain remover
thoroughly in plenty of water before drying. Never dry rubber objects or objects stained with vegetable oils in the dryer.
The Manufacturer is not liable for any damage to laundry resulting from inadequate or incorrect fabric care instructions which
have been provided with the garment or article.
Set the programme selector knob to “Off” (“O”).
1
Page 2
2
Cotton
Synthetics
Special programmes
Airing
Drying
times
Programmes / Drying levels
Overview of programmes
Extra dry
Cupboard dry +
Cupboard dry *
Iron dry *
Extra dry
Cupboard dry *
Ty p e of te xt il e
Multi-layered, thick laundry such as: terry towels,
terry towelling bath robes.
Terry towels, dry towels, bed linen, underwear.
Similar types of laundry which do not require ironing
such as: dry towels, bed linen, underwear, baby
clothes, T-shirts, cotton socks.
Laundry which requires ironing such as: bed and table
linen, dry towels, T-shirts, polo shirts, work clothes.
Laundry with thick, multi-layered areas such as: bed
and table linen, track suits, anoraks, blankets.
Laundry which does not require ironing such as:
shirts, blouses, T-shirts, sportswear.
Fabrics
Cotton or linen hot wash/
coloured laundry
Max. 7 kg
Synthetic, mixed fibre or cotton easy
care (ironing not required) laundry
Approximate
drying times
Ver y
wet
load
Gentle Anti-
crease
Dryness
level
Options
Buzzer Key
lock
Start
delay
X X X X X X 190 140
X X X X X X 165 125
X X X X X X 155 110
X X X X X X 135 90
X X X X X X 80 70
X X X X X X 65 60
Wet
load
Iron dry
Delicate plus
Mixed load
Laundry is aired, refreshed and loosen
up for 30 minutes without heating.
Completes drying
(suitable for all fabrics).
Laundry which requires ironing such as: trousers,
dresses, skirts, shirts, blouses.
Low drying intensity for delicates and items such as:
trousers, dresses, shirts, blouses.
T-shirts, blouses, towels, underwear, sportswear.
All textiles.
* Test programmes according to EN 61121, tested with maximum rated load capacity.
Max. 3.5 kg
Laundry made from synthetic fibres,
such as polyamide, nylon, polyacrylic,
etc.
Max. 2.5 kg
Cotton - Synthetic blend
Max. 3.5 kg
30' 40' 60' 90'
X X X X X X 55 50
X X X X X X 80 60
X X X X X X 130 100
— — — — — — — —
X X X X X X 30’ 40’ 60’ 90’
Page 3
HOW TO PROCEED IF...
...you want to check the dryer yourself first: (If your machine is not functioning correctly, please
check the following points before calling the customer service - also refer to relevant chapter in the
instructions for use)
• Has the correct drying programme been selected?
• Was the inserted laundry too wet (washing machine spin speed less than
1000 rpm)?
• Is the door filter dirty (filter indicator light on)?
Drying takes too long/
Laundry is not dry enough
The dryer does not
operate (after a power
failure, always press the
“Start (Pause)” button)
• Is the bottom filter dirty (for more information, refer to the instructions for use)?
• Is the room temperature too high?
• Are the “End” and “Anticrease” indicator lamps lighting up? The drying cycle
is complete and the laundry can be taken out.
• If the drying result does not meet your expectation, select a drier
programme. You can use the dryness adjustment option (if available) to
optimize the drying results.
• Is the plug properly inserted into the mains electricity socket?
• Is there a power failure?
• Has the fuse blown?
• Is the door properly closed?
• Has a drying programme been selected?
•Has the “Start (Pause)” button been pressed?
• Has the start delay option been selected?
• Is the dryer overloaded? Please remove a part of the load.
Door filter, water
container or bottom filter
indicator lamp on
Water droplets
underneath the dryer
• Is the door filter clean?
• Is the water container empty?
• Has the water container been inserted correctly?
• Is the bottom filter clean and inserted correctly?
• Has the bottom filter been inserted correctly?
• Have all lint on the bottom filter seal and the door seal been wiped away?
• Has the water container been inserted correctly?
• If the direct drain connection is used, is it tight?
• Is the dryer levelled?
...you want to care of and clean your dryer:
Clean the filter at the end
of every cycle
Empty the water container
at the end of every drying
cycle
Clean the bottom filter
every fifth cycle
• Brush lint using a soft brush or your fingertips.
• Close the filter.
• Push the filter back into place.
• Pull the handle to remove the water container.
• Empty the water container.
• Replace the water container when empty by pushing it completely back in place.
• Clean the bottom filter under running water.
• Remove all fluffs from the seals.
• Clean the bottom filter housing (for further information see chapter
“Cleaning the Bottom Filter” in the Instructions for Use).
• See the instruction for use for further information how to clean the bottom
filter.
3
Page 4
FAILURE CODES
In case of a malfunction of the dryer, one the following failure codes could be
displayed:
FAILURE CODE
You can check yourself before calling the After-Sales
Service.
F01 – F04 Please call the After-Sales Service.
Turn the dryer OFF and unplug it. Make sure that the room
F05
temperature is between 5°C and 35°C. Wait for 1 hour. Plug the
dryer back in and restart it. If the failure reoccurs, please call the
After-Sales Service.
Turn the dryer OFF and unplug it. Make sure that the room
F06
temperature is between 5°C and 35°C. Wait for 1 hour. Plug the
dryer back in and restart it. If the failure reoccurs, please call the
After-Sales Service.
Turn the dryer OFF and unplug it. Make sure that the room
temperature is between 5°C and 35°C. Unload approximately one
F07
half of the laundry from the dryer. Wait for 1 hour. Plug the dryer
back in and restart it. If the failure reoccurs, please call the
After-Sales Service.
F10 – F24
Start LED blinks 2
times per second
when pressed
Bottom filter LED
is blinking, Start
LED blinks 2 times
per second when
pressed
4
Turn the dryer OFF and unplug it. Wait for 30 minutes. Plug the
dryer back in and restart it. If the failure reoccurs, please call the
After-Sales Service.
Make sure that the door is correctly closed and the bottom filter
correctly positioned.
If the failure reoccurs, please call the After-Sales Service.
Make sure that the bottom filter is correctly positioned.
If the failure reoccurs, please call the After-Sales Service.
Page 5
Before using the machine, please also read the Instructions For Use carefully!
GB
TK Plus 72A Di
Quick Reference Guide
Programme selector knob
The drying programme is selected by
turning this knob. The “Start
(Pause)” indicator lamp flashes.
“Start (Pause)” button
The drying programme is started by
pressing this button. The indicator lamp
lights up.
Door filter
The indicator lamp lights up when the
door filter needs to be cleaned.
Clean the door filter at the end of
every drying cycle.
Bottom filter
This indicator lamp lights up when the
bottom filter needs to be cleaned.
This indicator lamp is blinking, when the
bottom filter is not correctly positioned.
Please take care that the bottom filter is
correctly inserted and the handle is fully
engaged.
Water container
The indicator lamp lights up when the
water container needs to be emptied.
The drying cycle is automatically
interrupted. Empty the container and
restart the drying program.
Empty the water container after
every drying cycle.
Indicator lamps
“Remaining time” display
Depending on the programme selected
a default drying time is displayed. After
start of cycle the time displayed is
corrected depending on the volume,
type and moisture of the laundry.
The drying time specified is a
calculated value which will be
updated during the drying cycle.
The flashing lines indicate that the
calculation is running. The remaining
time will be updated.
End
The drying programme is finished.
Please unload the dryer.
Overdry protection
The indicator lights up when a humidity
controlled programme is selected, to
indicate the activated protection function.
Dryness level
By selecting this option you can adjust
the dryness level of the laundry. After
the selection of the desired programme
you can choose the dryness level by
pressing the button.
Pressing 1 time you select a more dry
level
or
Pressing 2 times you select a less dry
level
or
Pressing 3 times you select again normal
dry level.
Once chosen this option together with
a certain program, it's automatically
selected when you use again this
program. Changing or deselecting this
option is possible according the
description above.
5
Page 6
Key lock
For child protection reasons, this
option can be used to lock all functions
of the user interface.
To activate/deactivate this option, the
button needs to be pressed for 3 seconds.
The only remaining function is the “Off”
position at the programme selector knob.
The key lock function is still active even
when the selector knob is turned to
“Off” position or the door is opened.
The function has to be deactivated.
Buzzer
Pressing this option, an acoustic signal is
indicating the end of the drying cycle.
This option deactivates the Anticrease
function, if it is activated.
Gentle
Selecting this option will reduce the
drying temperature at the end of the
drying cycle and thus the thermal strain
on delicate laundry. Due to the lower
temperature, the laundry will not be as
dry as after a drying cycle without this
option.
Anticrease
This option can be chosen to reduce
wrinkling, when the laundry is not
unloaded directly after end of the cycle.
The drum turns from time to time for
maximum 12 hours. It can be
interrupted at any time by switching off
the dryer. This option deactivates the
“Buzzer” function, if it is activated.
Start delay
Delays the start of the drying cycle by 1
to 12 hours. Each time the button is
pressed, the start time is delayed by 1
hour. Press the “Start (Pause)”
button to confirm the final selection and
to start the dryer. The “:” in the
window flashes and the time is counted
down in 1-hour intervals. During the
countdown, the drum will turn from
time to time to redistribute the laundry.
To cancel or change the previously set
time delay, set the index of the
programme selector knob to “Off”
position, or open the door.
5019 407 01484
(Subject to technical modifications)
6
Loading...