Whirlpool TFN 1630-IB NF, WV1861 NFX, WVE1860 NFX, WVE1660 NF TS, WVE1863 NF TS PRODUCT SHEET
IGB FINDKNPENLFD SGR
1. Freezer Compartment
2. Control unit
3. Area for drawers and pull-out
baskets
4. Rating plate (on the inside of the
appliance)
5. Ice packs (inside - if provided)
Storage compartment
Area for freezing
Note: the design of drawers and
accessories may vary, depending on
the model.
PRODUCT SHEET
GB
A. Temperature setting button (changes the
temperature setting in a loop) and freezer
on/off button (Stand-by function)
B. Temperature alarm indicator
C. Set temperature display Led:
- Led 1: lowest temperature
- Led 2: medium temperature
- Led 3: high temperature
- All the Leds remain lit when the fast freeze
function has been activated
CONTROLS
(depending on model)
To activate the fast freezing function, press button A repeatedly until Leds 1, 2 and 3 flash and then remain
lit. The function is automatically deactivated after 48 h.
FAST FREEZING
FINDKNSGRIPENLFGBD
5019 608 01076/A Printed in Italy 04/10
To activate the Stand-by function, press button A for 3 seconds and the appliance will switch off. To switch
it back on, press button A again.
STAND-BY FUNCTION
Note:
The temperature alarm may activate if the door is left open for a prolonged period of time or following
the introduction of fresh food in the freezer compartment; this temporary rise in temperature does not
affect the storage of already frozen food in any way.
ALARM SIGNAL
This appliance defrosts automatically according to usage and ambient humidity
conditions.
Follow the steps detailed in “Switching on the appliance”.
For non No Frost models, follow steps (1-6):
1. Press button A (the freezer on/off button) for 3 seconds.
2. Unplug the appliance or switch off at the main switch.
3. Fit the drain in place (see figure).
4. Follow the instructions given in the instructions booklet.
5. Plug in the appliance once again.
6. Press button A, the /freezer on/off button.
Follow the steps detailed in “Switching on the appliance”.
DEFROSTING
(for No Frost models no operation is required)
Signal Cause Solution
Temperature alarm Led B lights up The internal
temperature is
above -12°C
Keep the door closed until
the alarm deactivates.
Loading...