RHH2600
INSTALLATION
whirlpool VENTLESS RANGE HOOD RHH2600SERlES
and
OPERATING INSTRUCTIONS
TO INSTALL RANGE HOOD
For most efficient operation, top of hood should be
approximately 66 inches (137.6 CM) from floor.
Mark locations for electrical wiring from dimensions
1.
given in Figure 1.
Cut hole to accomodate electrical wiring Be sure to
2.
minimize opening through outside walls or the
ceiling. These will have to be sealed later
Run wire through wall or cabinets according to
3.
National Electrical Code and applicable local codes.
DO
NOT
turn power on until installation is complete.
Remove screws holding junction box cover. See
4
Figure 2.
Lift the hood into position and mark the location of
5
each of the four keyhole mounting slots
6.
Remove the hood and start all four screws in the
center of the narrow neck of the keyhole slot marked
on the cabinet bottom. See figure 3.
Lift the hood Into positron simultaneously feeding the
electrlcal wire through the knockout.
Tighten four mounting screws to secure hood to
cabinet. Be sure the screw heads are in the narrow
neck of the keyhole slot.
Complete electrical wiring in the junction box
according to the National Electrical Code and
applicable local codes.
\
L WIRING KNOCKOUTS
/
NOTE: This unit must be permanently grounded
according to the latest National Electrical Code and
applicable local codes.
~KEYHOLE SLOT
IN CANOPY
r----;-\
FIG. 3
/x+ *
-SCREW
UN INSTALLATION
PARTS BAG1
c
?-ALUMINUM FILTER
FIG. 2
Loading...