Whirlpool PRB 350I A, PRB 380W A, WBE3411 W, WBE34132 A X, WBE34132 A WF PROGRAM CHART

...

AKF 617 PRODUCT DESCRIPTION SHEET

GB IT PT

1. Removable panstand grids

2. Auxiliary burner

3-4. Rapid burners

5-6. Semi-rapid burners

7. Auxiliary burner control knob

8. Rapid burner control knob

9. Rapid burner control knob

10. Semi-rapid burner control knob

11. Semi-rapid burner control knob

Symbols

8 9 10 11

Shaded circle tap closed

Large flame and star

Small flame

Maximum opening/ delivery and electric ignition

Minimum opening or reduced delivery

Operation of burners with safety device and electric ignition

To light one of the burners:

• Press the relative knob and turn it anticlockwise to the large flame and star setting .

• At the same time, hold the knob down until the burner ignites.

• After the burner has ignited, keep the knob pressed down for about 10 seconds.

• Release the knob.

If the burner fails to light, repeat the above steps.

5019 519 66010

Note: — Should particular local conditions of the

delivered gas make ignition of the burner difficult, it is advisable to repeat the operation with the knob turned to the small flame setting .

— The burner safety device shuts off the gas

supply to the burner if the flame goes out accidentally (because of a sudden draught, an interruption in the gas delivery, boiling over of liquids, etc.).

DIMENSIONS OF COOKING HOB AND

WORKTOP (mm)

NOTE: If the distance “A” between the cabinets is between 600 mm and 680 mm, the

height “B” must be a minimum of 520 mm. If the distance “A” between the cabinets is greater than the width of the cooktop, the height “B” must be a minimum of 400 mm. In case of installation of a hood above the cooktop, please refer to the hood instructions for the correct distance. In case of installation of an oven under the cooktop, please refer to the separate oven instructions.

INJECTORS TABLE CATEGORY II2H3+

Ty p e o f gas used

NATURAL GAS (Methane) G20

LIQUID PETROLEUM GAS (Cylinder) G30 LIQUID PETROLEUM GAS (Cylinder) G31

Type of gas used

Ty p e o f burner

Rapid Semi-rapid Auxiliary

Rapid Semi-rapid Auxiliary Rapid Semi-rapid Auxiliary

Appliance model 5 BURNERS

Injector marking

Rated thermal flow rate kW

129

3.00

101

1.75

1.00

3.00

1.75

1.00

3.00

1.75

1.00

Total rated heat capacity kW

Rated consumption

286 l/h 167 l/h

95 l/h 218 g/h 127 g/h

73 g/h

214 g/h 125 g/h

71 g/h

G20 20 mbar 5 gas 10.50 1000 l/h 21.0 G30 28-30 mbar 5 gas 10.50 764 g/h 21.0 G31 37 mbar 5 gas 10.50 750 g/h 21.0

Reduced heat capacity kW

0.80

0.50

0.80

0.50

0.80

0.50

Total rated consumption

Gas pressure mbar

min. rat. max.

17 20 25

20 28-30 35

25 37 45

Air required (m

burning 1m

of gas

) for

ELECTRIC SUPPLY: 230 V~ 50 Hz