Whirlpool Petra Collection User Manual

COLLECTION
OWNER'S MANUAL
pedicure
spas
by
Owner’s Manual
Standard Whirlpool Jet SANIJET® Pipeless (Optional)
PETRA 700 PETRA 700-S* PETRA 500 PETRA 500-S PETRA 450 PETRA 450-S PETRA 350R** or V*** PETRA 350R** or V***-S PETRA 300 PETRA 300-S
S*=SANIJET® Pipeless R**=Roller Massage V***=Vibration Massage
Table of Contents
Introduction & Safety Standards 3
Important Considerations 4
Identifying Parts & Description (For Petra 700 & 500) 5
Massage System (For Petra 450, 350R, 350V & 300) 6
Chair Assembly (For Petra 700&500) 7
Chair Assemb ly (For Petra 450, 350R, 350V & 300) 8
Specifications (All Petra Collections) 9
Testing & Cleaning 10
Maintenance for Pipeless S-type Pedicure Spa (SANIJET® ) 11, 12
Maintenance for Standard Pedicure Spa (Whirlpool Pump) 13, 14
Optional Discharge Pump installation guide 15
Lubrication (For Petra 700 & 500 Series) 16
Warranty Statement 17
2
Introduction
Thank you for purchasing the PETRA Whirlpool Pedicure Spa. T his finest Whirlpool Pedicure Spa has been developed by J&A USA, Inc. to operate dependably for many years when used properly. Please take time to read this entire manual thoroughly before installation and use.
PLEASE READ AND FOLLOW INSTRUCTIONS CAREFULLY!
Important Precautions
J&A USA requires that you contact your local, qualified electrician and plumber to install your PETRA Whirlpool Pedicure Spa. It cannot operate efficiently or safely unless it is provided with adequate electrical power, sufficient water pressure, proper water temperature and required drain facilities. Information on these important subjects contained in this manual. We urge you to read it carefully to make sure these requirements are met.
Precautions
1 Excessive water temperature is dangerous and should be checked before use. Maximum water temperature should not exceed 100 deg. F. (38 deg. C.). 2 Always enter and exit the Whirlpool Pedicure Spa slowly and carefully. 3 Never bring and/or operate any electrical devices into or near the Whirlpool Pedicure Spa. 4 Do not stand in the whirlpool tub! 5 This Whirlpool Pedicure Spa has a weight capacity of 250lb.
WARNING
Do Not use if you are diabetic, have poor blood circulation, or if any area of your
feet or legs are inflamed or have open wounds. Consult a physician before using if
you have any kind of fungal infection, swelling, fracture, or persistent pain.
Massage should be pleasant and comfortable.
IF YOU EXPERIENCE PAIN OR DISCOMFORT, DISCONTINUE USE IMMEDIATELY AND
CONSULT A PHYSICIAN.
This product in whole is in compliance with the applicable UL LISTED standards and requirements for the US and Canada by Underwriters Laboratories Inc.
Some of the components of this product are also in compliance with the applicable safety standards of the following:
3
Important Considerations
Please read the following instructions thoroughly
Inspection
Please take time to inspect each pedicure spa shipment thoroughly for damages immediately upon delivery. If damages are found, it is very important to notify the freight driver and indicate extent of the damages on the bill of lading. If you fail to do so, J&A USA will not be responsible for the damages and may not be able to make appropriate claims to the freight carrier. Any damage claims must be filed directly by receiver to the freight carrier.
Electrical Service
Each Foot spa must have its own dedicated 115V, 60 Hz, 15 Amp GFCI protected grounded circuit.
Water Supply
Water supply to the PETRA pedicure spa should consist of a system that will provide both adequate water pressure and water temperature. All plumbing connections must conform to local codes.
Water Pressure
Normal water pressure of 30 to 120 P.S.I. is required to correctly fill the tub to the proper level.
Back Flow Prevention Device
- For following states: AZ, CA, IL, MN, NE, NV, OR, TX, WA, and WI;
All PETRA pedicure spa are equipped with factory installed Dual Check Back Flow Preventer.
Specification:
Tested and certified to meet ANSI/ASSE standard 1024. CSA certified to standard No.B64.6
Pressure / Temperature
Maximum pressure: 150 psi (10 bars) Minimum pressure: 10 psi (69kPa) Working temperature: 33F to 140F constant; intermittent to 180F
(0.6C to 60C sustained; intermittent to 82.2C)
Maximum recommended flow: 15 gpm (571pm)
-For all other states: As an option, the Dual Check Back Flow Preventer will be factory installed. * Inquire with governing authorities for local installation requirements.
Drain Facilities
Connect the Foot spa drain to meet local plumbing codes. Please refer to the installation drawings on pages 9-10. Foot spa is recommended securely fastened to the floor Fasten the Foot spa with at least two fasteners.
Installation Summary
The installation must comply with local, state, and federal building, plumbing and electrical codes, where applicable. A licensed plumber should complete the plumbing of the pedicure spa. Note: Failure to comply with federal, state or local codes and ordinances will result in warranty being null and void.
4
PETRA700&500
IDENTIFYINGPARTS
1
11
13
10
STOP
MASSAGEWHEELS
20
TAPKNEAD
AUTO
UP
DOWN
A
FORWARD BACKWARD
B
DOWN
UP
19
15
2
3
4
CONTINUE/REPEAT
THIGHMASSAGE
J&A
5
6
16
7
8
9
17
18
12
14
SANIJET-Pipeless
StandardWhirlpoolJet
PARTS
1-PILLOWCOVER
2-BACKREST
3-ARMREST
4-MATCHINGARMTRAY(OPTIONAL)
5-SEATCUSHION
6-SHOWERSPRAYER
7-ADJUSTABLEFOOTCUSHION
8-ON/OFFWHIRLPOOLBUTTON
9-OPTIONALON/OFFBUTTON(LIGHTorDISCHARGEPUMP)
10-FAUCET
Duetocontinuousimprovementsonallourproducts;specifications,characteristics,packing,colors,designsaresubjecttochangewithoutnotice
11-SANIJETPUMPIMPELLER
12-OVERFLOWWASTEKNOB
13-POP-UPDRAINSTOPPER
14-LIGHTCOVER
15-BACKPANEL
16-ARMRESTLEVER
17-BASE(SHELL)
18-WHIRLPOOLJET
19-MASSAGEREMOTECONTROL
20-SLIDE/RECLINEREMOTECONTROL
5
PETRA450,350R,350V&300
MASSAGESYSTEM
PETRA450
TRANSFORMER MODEL:GRA1215 INPUT:AC120V,60Hz OUTPUT:DC12V,1.5A
&
JA
VIBRATION
PETRA300
Pacificspa
J&AUSAInc.
VIBRATION
TRANSFORMER MODEL:GRA1215 INPUT:AC120V,60Hz OUTPUT:DC12V,1.5A
PETRA350R
TRANSFORMER MODEL:AD-57241200 INPUT:120V,AC60Hz OUTPUT:24V,DC1.2A
TIMER
ROLLER
BACK
VIB
WAIST
SEAT
SPD
SEL
AUTO
ROLLERMASSAGE
&
VIBRATION
PETRA350V
TRANSFORMER MODEL:MKD-57121500 INPUT:120V,AC60Hz OUTPUT:12V,DC1.5A
HEC
Pacific
ByJ&AUSA
Spa
VIBRATION
Duetocontinuousimprovementsonallourproducts;specifications,characteristics,packing,colors,designsaresubjecttochangewithoutnotice
6
Loading...
+ 13 hidden pages