Whirlpool PDT 610 INSTRUCTION FOR USE

PDT 610GB
Cotton Synthetic Delicate/Wool
ON OFF On/Off
“Intensive Rinse” option
“Rinse Hold” option
Estimated Programme Duration refer to maximum programme temperature selection without special options.
During the selected washing programme the programme selector knob moves by steps clockwise through the phases
rinse and spin
. Each step takes from some seconds
prewash, main wash
to several minutes.
: optional / Yes : dosing required
,
Programme
Selector
Knob
1 2 3 4 4 5
6
Programme
Cotton
with prewash
Cotton
Synthetic
Cotton
short
Synthetic
short
Delicate
Wool
Rinse +
Long spin Long spin
Rinse +
Short spin Short spin
Drain
Temperature
Selector
°C
Min Max. 95°
Min Max. 95°
Min Max. 60°
Min Max. 40°
Min Max. 40°
Min Max. 40°
Min Max. 40°
Min
Min
— —
Heavily soiled, long wearing and temperature stable textiles in cotton and linen (bed linen, table linen, underwear, shirts etc.).
Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Slightly to normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Slightly soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Slightly soiled overalls and sports wear made of cotton, polyester, polyamide and blends with cotton.
Curtains and delicate clothing, dresses skirts, shirts and blouses. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine
washable.
If you select “Rinse Hold” do not leave items to soak for too long. With this programme you can add starch and/or fabric softener.
The programme ends with an intensive spin cycle. In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.
In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.
In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme. Drain only - no spinning. Alternative method of terminating programme the synthetic, delicate and
wool programme and for premature removal of the laundry.
Max
Load
Kg
5.0
5.0
2.0
2.5
2.0
1.5
1.0
5.0
5.0
1.5
1.5
—— — — —
Detergents and additives Special options Spin Speed
Pre-
wash
——
Main
Wash
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Fabric
Softener
Chlorine
Bleach
❉❉❉❉
❉❉❉❉
——
———
—— —————— ——
—— ——————
Intensive
Rinse
Rinse Hold
❉❉
❉❉
❉❉
——
Estimated
Programme
Duration
rpm
Min.
600 120
600 110
600 85
600 75
600 75
600 70
600 60
600 20 600 15 600 15 600 10
6
5019 601 10011
CONSUMPTION DATA
Temperature
Programme
Cotton with prewash 95 5.0 80 2.00 120
Cotton 95 5.0 70 1.80 110 Cotton 60 5.0 70 1.20 110
Synthetics 60 2.0 60 0.90 85
Cotton short 40 2.5 65 0.70 75
Synthetics short 40 2.5 60 0.60 75
Delicate 40 1.5 80 0.60 70
Wool 40 1.0 80 0.60 65
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the energy label refer to the programme Cotton 60°C.
Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Estimated Programme
Duration
Min.
Terminate the “Rinse Hold” option:
• Press the “Rinse Hold” button again; the programme will terminate automatically with the final spin cycle for the present wash programme.
If you do not wish to spin the laundry, turn the programme selector knob to the “Drain” programme.
PROGRAMME CHANGE
To reselect a programme when a cycle has already started:
1. Switch off the appliance by pressing the
ON/OFF” button.
2. Select the new programme, temperature and
options.
3. Start the programme by pressing the
ON/OFF” button again.
NOTES AND INDICATIONS FOR USE
Water level
To obtain low water consumption without compromising washing results the water level within the drum may not be visible.
Cleaning the pump filter
A regular filter check and eventual cleaning is advisable.
Washing cycle
During the washing cycle the turning of the drum is stopped several times for optimization of energy consumption.
Increased spinning efficiency
During spinning the drum starts and stops turning several times: in this way the washing machine performs spinning with increased efficiency.
ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME
Add the detergents as described in the programme table or in the chapter “Detergents and Additives” in the booklet.
1. Open the tap.
2. Set the programme selector to the desired programme.
3. Set the temperature selector to the desired temperature.
4. Special options can be selected.
5. Check that the door is well closed and turn on the washing machine by pressing the “ON/OFF” button. The indicator lights up, indicating that the washing machine is on.
SELECT ANY DESIDERED OPTION
“Intensive Rinse” button
• The water level increases for improved rinsing efficiency.
• This option is particularly suitable for areas with very soft water when washing baby linen and helps people with skin allergies.
• For improved garment care it is advised to use the option for the Cotton 95°C and the Coloured 60°C programme.
“Rinse Hold” button
• The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing.
• This option is particularly recommended for the programme “Synthetic” or “Delicate”.
• This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only.
PROGRAMME END
1. At the end of the programme the programme selector moves to the stop position.
2. To unload the washing machine wait for the door to unlock (about 2 minutes).
3. Switch off the washing machine, open the door and take out the laundry.
4. Close the tap and leave the door ajar to allow the drum to dry out.
5019 601 10011
Loading...