Whirlpool PDT 1039 INSTRUCTION FOR USE
GB PDT 1039
A. “On/Off” Button
Programme Care Labels Type of wash / Notes
Cotton with prewash
Synthetics with
prewash
Delicate with prewash Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.
Cotton
Cotton short
Synthetics
Synthetics short
Delicate Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Wool
Handwash
Rinse and Spin
Fast Spin
Slow Spin
Drain
Heavily soiled, long wearing and temperature stable textiles in cotton and linen (bed linen, table
linen, underwear, shirts etc.).
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide
(Perlon, Nylon) or blends with cotton.
Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc. made of
cotton and linen.
When you select the “Rapid” option, the “Eco” and “Half Load” options cannot be selected.
Slightly soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and
linen.
Slightly to normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira),
polyamide (Perlon, Nylon) or blends with cotton.
When you select the “Rapid” option, the “Eco” and “Half Load” options cannot be selected.
Slightly soiled overalls and sportswear made of cotton, polyester, polyamide and blends with
cotton.
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. No spinning.
With this programme you can add starch and/or fabric softener.
–
The programme ends with an intensive spin cycle.
In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.
–
In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.
–
Drain only - no spinning. Alternative method of terminating the synthetic, delicate and wool
–
programmes and for premature removal of the laundry.
A
During the selected washing programme the programme selector knob moves by steps clockwise
through the phases prewash, main wash, rinse and
spin. Each step takes from some seconds to several
minutes.
i : option / Yes : dosing required
1)
For improved garment care spin speed is restricted to
800 rpm in this programme.
2)
For improved garment care spin speed is zero in this
programme.
Max.
Detergents and Additives Special options Max.
Load
kg
5,0
2,5
1,5
Normal
5,0
Rapid
3,0
3,0
Normal
2,5
Rapid
1,5
2,5
1,5
1,0
1,0
5,0
Softener Main
i
i
i
i
i
i
i
i
i
i
i
Wash
Yes Yes
Yes Yes
Yes Yes
Yes –
Yes –
Yes –
Yes –
Yes –
Yes –
Yes –
– –
5,0 – – –
1,5 – – –
Pre-
wash
Bi
Speed
Eco Rapid Half
Load
i i i i i
i i i i i
– – –
i
i i i i i
– –
i
i i
i i i i i
– –
i
– – –
i
– – –
i
– – –
i
– – –
i
– – – – 1000 –
i
– – – – 800
i
i i
Rinse
Hold
i
i
i
i
i
Spin
Speed
rpm
1000 Max. 95°
1)
800
1)
800
1000
1000 Max. 60°
1)
800
1)
800
1)
800
1)
800
2)
–
1000 –
1)
– – – – – – – – – – –
Temperature
Selector
°C
Max. 60°
Max. 40°
Max. 95°
Rapid
Max. 60°
Max. 60°
Rapid
Max. 60°
Max. 60°
Max. 40°
Max. 40°
Max. 30°
–
Programme
Selector
1
2
3
4
5
6
7
8
9
10
A
B
C
D
5019 801 10024
CONSUMPTION DATA
Temperature
Programme
Cotton 95 5,0 60* 1,70 2:05
Cotton 60 5,0 55 0,95 2:20
Cotton 40 5,0 55 0,60 2:05
Synthetics 60 2,0 55 0,80 1:30
Synthetics 40 2,0 55 0,60 1:20
Delicates 30 1,5 60 0,50 0:45
Wool 30 1,0 60 0,30 0:40
Handwash 30 1,0 60 0,30 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values
in the table in relation to the water supply pressure and temperature, the load and the type of wash.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
ADD DETERGENTS, CLOSE THE DOOR AND
SELECT THE PROGRAMME
Add the detergents as described in the programme
table or in the chapter “Detergents and Additives” in
the booklet.
1. Open the tap.
2. Set the programme selector to the desired
programme.
3. Turn the temperature selector to the desired
temperature.
4. Special options can be selected.
5. Check that the door is well closed and turn
on the washing machine by pressing the
“On/Off” button. The indicator lights up,
indicating that the washing machine is on.
Selector
(°C)
Load
(kg)
Water
(l)
SELECT ANY DESIRED OPTION
“Bi Speed” button
• Reduces the predetermined automatic
maximum spin speed.
In some programmes the maximum final spin
speed is limited to go easy on your laundry
items. Selection of a higher spin speed is not
possible.
“Eco Wash” button
• The duration of the wash is extended and the
temperature reduced to save energy
maintaining good washing results.
“Rapid Wash” button
• For quick, economical washes.
• Ideal for minimum loads of lightly-soiled articles.
Note: Reduce the detergent quantity.
“Half Load” button
• Reduces water consumption, above all during
rinsing.
• Suitable for lightly-soiled laundry and small
loads (max. 3 kg).
Energy
(kWh)
Approx. Programme
(hours : minutes)
Duration
“Rinse Hold” button
• The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from
changing.
• This option is particularly recommended for the
programme “Synthetics” and “Delicates”.
• This function is particularly useful if you want to
postpone spinning to a later time, or if you want
to drain only.
Terminate the “Rinse Hold” option:
• Press the “Rinse Hold” button again; the
programme will terminate automatically with the
final spin cycle for the present wash
programme.
If you do not wish to spin the clothes, turn
the programme selector knob to the “Drain”
programme.
PROGRAMME CHANGE
To reselect a programme when a cycle has already
begun:
1. Switch off the appliance by pressing the
“On/Off” button.
2. Select the new programme.
3. Start the programme by pressing the “On/Off”
button.
END OF WASH CYCLE
1. At the end of the programme the programme
selector moves to the stop position.
2. To unload the machine wait for the door to
unlock (about 1 minute).
3. Switch off the appliance, open the door and
take out the laundry.
4. Close the tap and leave the door ajar to allow
the drum to dry out.
NOTES AND INDICATIONS FOR USE
• WATER LEVEL
It may not be visible as the cycle is optimised
for a minimum water consumption without
compromising washing results.
• SPIN SPEED CONTROL
Spin speed may be reduced automatically or
may even be excluded in the case of small
loads with highly absorbent garments (e.g.
bathrobes, bathmat).
This control avoids cloth and machine damage
and excessive vibrations and consequent noise
produced by the machine due to load
unbalance: by selecting high spin speeds the
noise level increases.
• MOTOR NOISE
The running noises of the new, electronically controlled motor are not the same as the ones
you are used to from your old appliance. Don't
be surprised - modern technology has a modern
sound.
• CLEANING THE FILTER
To ensure an impeccable function of the pump,
check the filter regularly and clean it if
necessary.
5019 801 10024
Loading...