Whirlpool NWT0002D01, NWT0002D02, NWT2002D00, NWT2002Q00 Owner’s Manual

Use and Care

Guide ]

This use and care guide applies for the following models:

Nominal Technical Specification I Madeby industries Acres Whirlpoo| S.A. de C.V.

Nominal Current __ 6,0 A J CoL El Milagro
Frequency _ 60 Hz Apedacs N.L.
Voltage _ 110-127 V- M_xico, 66600

NWTOS02D, NWT2002Q, NWT2002D

Antigua Carreteraa Rome km 9

Phone.[phone]

4. Before starting the refrigeration process allow the refrigerator to rest
from 2 to 3 hours in order to let the gas and oil be settled.

Connecting your refrigerator

A 110-127 V-, 60 Hz AC only 15 or 20 A fused and properly grounded
electrical supply is required.

Levellin

g screw

your refrigerator, follow these basic precautions:

Te reduce the risk of fire, electrical shock, or injury when using

• Read all instructions before using the refrigerator.

- Child entrapment and suffocation are not problems of the past. Junked or abandoned refrigerators are still
dangerous ... even if they will "just sit in the garage a few days".

• if you are getting rid of your old refrigerator, do it safely.

• Never allow children to operate, play with, or crawl inside the refrigerator.

- Never clean refrigerator parts with gsmrnable fluids. The fumes can create a fire hazard or explosion.

• We suggest to remove the door or thigh it with a resistant cord.

• if supply cord is damaged must be replaced by our service department or a qualified person to avoid hazard.

• Do not store or use gasoline or ether flammable vapors and liquids in the vicinity of this or any ether appliance.
The fumes can create a fire hazard or explosion.

• If damage in power supply cord occurs, it should be replaced by our service department or by an qualified
electrician in order to avoid a risk.

The refrigerator must be properly grounded.

Do net use an extension cord with this appliance, consult with a qualify technician

any doubts about the proper grounding of this appliance,

_¢ De not modify the electrical cord

• Do not use the refrigerator in an area where the room temperature will fall
below 13°C (55 ° F).

• Keep the refrigerator out of the weather.

• Connect the refrigerator only to the proper kind of outlet, with the correct

electrical supply and grounding.

• Do not load the refrigerator with food before it has time to get properly cold.

, Use the refrigerator only for the uses described in this manual.

• Properly maintain the refrigerator.

• Be sure the refrigerator is not used by anyone unable to operate it properly.

• The refrigerator is intended for domestic use.

if your wail outlet is not proper one have a qualify technician install it.
if supply cord is damaged must be replaced by our service department or a

qualified person to avoid hazard.
Failure to follow these precautions may result in high risk of injury and even

death

•FOR YOUR SAFETY,

-SAVE THESE iNSTRUCTiONS-

Electrical shock hazard

Wall outlet for 3 prong plug cord,

Grounding Method

Your refrigerator has an electrical cord provided with 3 prong
grounding plug. To minimize the possibility of electrical shock,
the cord must be plugged into a mating 3 prong grounding type
wall outlet according to national electrical code and all local
codes, if plug will not fit the outlet, is your responsibility to have
a proper outlet installed by a qualified electrician.

Adjusting temperature control
Your refrigerator has 2 control knobs that let you independently set

the temperature in both, refrigerator and freezer compartments.
When you plug the refrigerator for the first time:

. Set the temperature control knob of refrigerator and freezer in f_.,_,,_

"MED" position, it means mid cool. Temperature ranges goes
from "MIN" or "-" (less cool) to "MAX" or "+" (coolest).

- If you set the temperature control knob to "APAGADO" (OFF) in
refrigerator compartment, the system turn off in both compartments.

but it still remains connected to power supply.

• Give the refrigerator time to cool down completely before adding .............

food. This could take several hours. Adjust the temperature control
to have food as cold as you like. The settings indicated above
should be correct for normal, household refrigerator usage.

grounded properly.

3 prong plug cord

Power supply Grounding
cord Terminal

Before connecting the new refrigerator follow these
steps:

1. Remove all packing material and the wood bases.

2. install your refrigerator under the following conditions:
* Allow 7,5 cm (3 inches) between overhead cabinets and

refrigerator top.

, Allow at least 5 cm (2 inches) between the refrigerator

condenser on the back and the wall.

, Allow 1,25 crn (1/2") on each side of the refrigerator for

ease of installation.

" If the hinge side of the refrigerator is to be against the

wall, you might want to leave extra space so the door can be opened wider.

3. Levelling the refrigerator

• Remove the wooden supports.

- To raise or lower the front of the refrigerator, turn each screw in a clockwise or

counterclockwise direction (figure 1).

• For greater levelling accuracy you should place a spirit level on the upper surface
of the refrigerator.

• it is recommended to incline lightly back the refrigerator
in order to let the door close by itself. ___ _-_'_"\ ii

Raise Lower

Levellin

g screw

:::t

1. Disconnect refrigerator from power supply. _- (_r_J

2. Remove the bulb cover with a plain screwdriver. _

3. Replace with a 15 watt appliance bulb.

4. Replace the bulb cover.

5. Reconnect refrigerator to power supply.

NOTE: Not all appliance bulbs will fit your refrigerator. Be sure to _ Ijreplace a bulb with one of the same size and shape.

; ;t C:: , ; v : C© ;

_t 2

This control helps you to reach longer periods of
conservation of fruit and vegetables, it controls the

amount of cool air inside crisper drawer. If your drawer
has a humidity control as shown in fig. 1, slide control

downward. If your drawer has a humidity control as
shown in fig. 2, she control from side to side. In beth

cases, this allow you to control the circulation of cool
air according to your needs. Fig. 1 Fg. 2

--t

TOP HINGE

Reversing the door swing should be performed by
a qualified person.

important Information

hinge

- Before you begin, turn refrigerator OFF, unplug
it, and remove any food from door shelves.

- When removing hinges, keep doors closed until
ready to lift free from cabinet.

- To remove doors, start at the top hinge and work
your way down.

- To replace doors, start at the bottom hinge and
work your way up.

- Line up doors so they are centered between the
sides of the cabinet and parallel with each

other.

- Seal all unused openings with screws or plastic
plugs. Moisture will enter any openings.

NOTE: After the doors are reversed, reinstall the

handles, If the doors are not shutting on their
own, see the "How to install the refrigerator"
section,

Hinge

Screws 4

Hinge 45

IMPORTANT

BEFORE CALLING THE TECHNICIAN IT IS VERY IMPORTANT TO VERIFY THE FOLLOWING
INFORMATION:

IF AFTER READING THE USE AND REFERENCE GUIDE YOU HAVE QUESTIONS,THIS
GUIDE MAY OFFER YOU SOME SOLUTIONS TO PROBLEMS YOU CAN DETECT AND

CORRECT YOURSELF IN YOUR HOME

IF THE REFRIGERATOR IS NOT WORKING

• Plug firmly into a live circuit. Do not use extension cord.

• Check the power supply. It could be damaged. Connect another appliance and see if it works
normally.

• Do not connect various appliances at the same time, the electrical installation will overload.

, Verify that the temperature control is in the ON (ENCENDIDO) position.

• Avoid placing the appliance close to a hot source.

• Close the doors completely. Check to see if the gaskets are dirty or sticky.

• Level the refrigerator. Remove wood supports and adjust the roller levels (FIGURE 1).

• Do not overload the refrigerator. The air circulation will be deficient.

• Set the temperature control in number 3 or in the middle position and wait at least 24 hours
before making another change of temperature.

THE REFRIGERATOR SEEMS TO RUN TOO MUCH

• Verify if the condenser has lint or is dirty (FIGURE 1)

• Avoid opening the doors constantly or for long periods.

• Do not introduce hot food.

IS THE REFRIGERATOR MAKING UNFAMILIAR SOUNDS

, Verify there is nothing on top or behind.

• The compressor does not work properly; check if you are using the right voltage.

, Verify the light intensity. If it is low, consult with a qualified technician (FIGURE 1).

@ ®

WARRANTY WhJol

WHIRLPOOL MI_XICO, S.A. DE C.V.

Antigua carretera a Roma km 9, Col. El Milagro, Apodaca, N.L. Mexico C.P. 66600, phone
(01-81) 83-29-21-00, in the terms of this policy, we guarantee to the buyer and the consumer
the WHIRLPOOL refrigerator identified in this following policy:

Manufacturing defects that prevent the partial or total product functioning according to the

terms of this policy. In this case the repair will be made at no charge for the buyer or consumer,

in case that part, components or product replacement is required will at manufacturer

expenses, so are the shipping and handling costs with in the service and labor guarantee

network.

• When the refrigerator is used in other than normal, single family household use.

• When the refrigerator was not used according with the use and care guide attached.

• When the refrigerator would have been repaired by any unauthorized service.

When the final customer considers one of the events protected by this contract has happened,

he/she will have to make contact with Whirlpool Service through our Call Center, in Monterrey,

N.L and its surrounding area to (81) 83-29-2100; or from the interior of the Mexican Republic
to 01-800-8-300-400:where a specialized service agent will take care of the matter. Our
facilities are located in Miguel Alem_n Highway km 16 Col. El Milagro C.P 66600. Apodaca,

N.L. where Whirlpool original parts and accessories can also be found. For additional

information of our services, visit www.whidpool-service.com.mx.

This is a 12 MONTHS warranty in all refrigerator parts, beginning the purchase day.

NOTE: The refrigerator sealed system contains: COMPRESSOR, EVAPORATOR, DRYER

FILTER, CONDENSER, JOINT AND SUCTION TUBES.

IMPORTANT NOTE

This document should be presented for any
procedure related with the warranty.

THE PURCHASER SHOULD MAINTAIN THIS
DOCUMENT WITH HIMAND KEEP IN A SAFE

PLACE,

The consumer will be able to request this warranty
policy to be effective,with the distributor where he

acquired the product. In case of the policy loss,
the distributor will expedite a new warranty policy,

by presenting the purchase tickets or the invoice,

PROTECT THE FOLLOWING MODELS:
NWT0002D, NWT2002Q, NWT2002D

COVERED CONCEPTS:

WHIRLPOOL MEX|CO, S.A. DE C.V. WILL NOT PAY:

PROCEDURE TO MAKE EFFECTIVE THE WARRANTY:

TERMS:

Identification Format

NAME OF THE PURCHASER:
ADDRESS:
PHONE NUMBER:
NAME OF THE DISTRIBUTOR:

ADDRESS:
PHONE NUMBER: PRODUCT: MODEL:

SERIAL NUM. DATE OF DELIVERY:

SIGNATURE OF THE DISTRIBUTOR AND STAMP

(Please show with accuracy the street, outside and inside number,

section, city, state and Z.C.)

FIGURE 1 MAGNETIC

SEAL

IF AFTER FOLLOWING INSTRUCTION

THE REFRIGERATOR STILL WITH

PROBLEMS, CALL AN AUTHORIZED

SERVICE CENTER

01 800 8 300 400

COMPRESSOR

When unpacking the product take offthe tape from the shelves and place them in the correct
position.

LEVELING

ROLLERS