MK3094XAQ
/NSTALUTlON
FOR USE WITH WHIRLPOOL MICROWAVE OVEN MODELS: MT309OXfd& MT3090XAB, MG3090XAQ, MG3090XAB [ UL LISTED - NOT OVER HEAT SOURCE 1
STEP 1
PART LIST
\NST/?UCT/ON FOR WHlRLPOOL TRHVl-KIT MODELS: MK3094XAQ. MK3094XAB
2 STEP
CUT-OUT DIMENSIONS
(KEEP FOR FUTURE REFERENCE)
Aluminum
Vent
a
3 STEP
1. Disconnect microwave and remove any loose
items inside the oven before proceeding with
installation.
2. Detach Exiiting Strews(4) from the microwave
cabinet sides at locations as indicated.
3. Install Duct Di4 by reattaching
Existing Strews(4) as shown.
4. Position Duct D15 over microwave, covering
top exhaust vent. Peel backing off double
sided tape from Duct bottom. Place the
Duct at its original position covering the
vent and firmly press down.
Duct D14
Existing
Screws
Spring Clips
0
6
REAR VIEW OF MICROWAVE
4 Req’d
Height = 15 ‘I,’
Length = 22 ‘/I’
Depth = 23 ‘I,’ (min.)
4
STEP
1. Mark center positions (or center-punch)
for the Anti-Tip Bracket as shown.
Dimensions:
2. Drill pilot holes as required.
3. Install Anti-Tip Bracket
using Low Profile
Screws(P) as shown
Low
Anti-Tip Bracket ~
-Length---o
c---
‘\
Profile Screws 7
-0--
\\
PART NO. 4375012
Loading...