37055Aen.fm5 Page 15 Tuesday, July 27, 1999 6:31 PM
INDEX GB
BEFORE USING THE APPLIANCE
INSTALLATION
CONNECTING THE MINI-KITCHEN
PRECAUTIONS AND GENERAL
RECOMMENDATIONS
REFRIGERATOR
USE OF THE REFRIGERATOR
ELECTRIC HOTPLATES
USE OF THE ELECTRIC HOTPLATES
USE OF THE TIMER
ADVICE
CLEANING AND MAINTENANCE
TROUBLESHOOTING GUIDE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
16
17
18
20
21
23
24
25
26
AFTER-SALES SERVICE
Refrigerator with , compartment and
automatic defrost.
The rated performance is obtained with the
appliance operating at ambient temperatures
between +16°C and +32°C.
The single appliances of the Mini-kitchen are in
compliance with VDE regulations, EEC
international directives, EEC directive
no. 87/308/CE relating to the suppression of
radio interference, and with current safety
standards.
27
PAGE
The refrigerator has been tested for fluidtightness and conforms to VBG 20 accident
prevention standards for cooling systems.
To install an extractor hood...
observe the minimum distance from the
hotplates! Minimum distance between electric
hotplates and lower edge of extractor hood:
650 mm. For reasons of safety this distance
must absolutely be maintained!
15
37055Aen.fm5 Page 16 Tuesday, July 27, 1999 6:31 PM
BEFORE USING THE APPLIANCE
In purchasing this new product you have chosen
a household appliance capable of matching the
highest expectations from a technical standpoint
and affording an ease of use compatible with
practical requirements.
This new appliance offers you all that is
technically possible at the time of its design and
manufacture.
Your appliance is particularly economic in terms
of energy consumption and therefore
environment friendly, if used responsibly.
If treated properly, it will give you dependable
service for many years.
To get the most out of your new appliance, read
the user handbook thoroughly. You will find a full
description of the various components.
Keep this handbook for future consultation.
Information:
This appliance uses neither CFCs (refrigeration
circuit contains R134a) nor HFCs (refrigeration
circuit contains R600a - Isobutane). For more
information, refer to the data plate affixed to the
appliance.
Important In the past, the doors of refrigerators
and freezers were often equipped with spring
catch or bolt type locks. If a product of this type
is to be scrapped and disposed of, destroy the
lock to ensure children cannot trap themselves
inside thus running serious risks.
Having unpacked the equipment, make sure no
part of it has suffered damaged. Any damage
must be reported to your dealer within 24 hours
after taking delivery of the appliance.
Wait at least two hours before connecting the
appliance to the power supply in order to
ensure the refrigerant circuit is fully efficient.
SAFEGUARDING THE ENVIRONMENT
Packing
The packing material is entirely recyclable, and
marked with the recycling symbol . Follow
local disposal regulations.
Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children,
as they are potentially dangerous.
Appliance
The appliance is made from recyclable
materials. If you decide to scrap the appliance, it
must be disposed of in compliance with local
waste disposal laws.
Make the appliance unusable by cutting off the
power cord. The appliance must be consigned to
an authorised collection centre for the recovery of
refrigerant gas.
INSTRUCTIONS
INSTRUCTIONS FOR USE
These indications contain important information
on the use of your appliance. There may be
differences in detail, depending on the model.
16
37055Aen.fm5 Page 17 Tuesday, July 27, 1999 6:31 PM
INSTALLATION
Before installation, make sure that the tubes on
the rear of the refrigerator have not been bent in
transit. If the tubes touch the refrigerator or the
wall, the refrigerator will be irritatingly noisy
during operation.
If necessary, bend them carefully to restore the
correct clearance.
The Mini-kitchen must be installed in a fixed and
plumb upright position. Any unevenness of the
floor can be accommodated by adjusting the feet
(Fig. 1).
Warm air must be free to escape
unobstructed at the rear of the refrigerator so
as not to affect operation (and not to cause
increased electrical power consumption).
Accordingly, the ventilation slots behind the
hotplates must not be covered.
The machine is approved only for freestanding installation against a wall. Items of
furniture may be placed adjacently on either
side.
Fig. 1
TO ALIGN THE HEIGHT
OF THE DOORS, ADJUST
THE FRONT FEET.
17
37055Aen.fm5 Page 18 Tuesday, July 27, 1999 6:31 PM
CONNECTING THE MINI-KITCHEN
Connections to the water supply and waste
pipelines should be made preferably by a
professional installer.
The Mini-kitchen is designed for connection to
the earthed socket outlet of a 220-230 V/50 Hz
supply, provided with an isolating contact in
compliance with current safety regulations.
The Mini-kitchen with electric hotplates must
be protected by a 16 A fuse. The Mini-kitchen
can be converted by a qualified installer for
operation at 380-400 V 2 n 50 Hz.
In this case a 10 A fuse is required.
Important! In the case of a fixed electrical
installation of the Mini-kitchen, the installer
must fit a multi-pole switch with a gap between
open contacts of at least 3 mm, or an automatic
circuit breaker.
This multi-pole isolating device must be fitted
even if the plug is no longer accessible after the
appliance has been installed.
• Important for appliances operating off
380-400 V (CH) supply.
The Mini-kitchen must be connected by the
installer to the 380-400 V 50 Hz supply, fitting a
10 A fuse and a multi-pole switch with gap
between open contacts of at least 3 mm, or an
automatic circuit breaker.
18