How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Open the door, switch on the appliance
Select, save, and supply the detergent
Press the ON button. |
|
|
(The first time you use the appliance |
|
|
and when using a different type of |
|
|
detergent) |
A |
B C |
1.Select the third programme from the top in the relative table.
2.Press the Start button for about 7 seconds until the display changes.
3.Select the required detergent with the
Start button: “3h” = 2in1, “6h” = 3in1, “9h” = All in 1, all three LEDs on = soap powder (factory setting).
4.Switch the appliance off and then switch it on again. The type of detergent selected is shown by the relative LED for approximately three seconds.
For dosage of powder detergent in compartment A and B refer to the programmes table.
Check the rinse aid level
Check the regeneration salt level
Load the racks
Select a programme
Select additional options
Press the Start button
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener system only.
Mechanical indicator D. Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The display shows the last programme selected.
Press P or 
until the selected programme lights up.
If necessary the corresponding indicator lights up.
The selected programme is |
“Change programme in progress” |
||
|
|
Press the START button for 2 sec. until the |
|
|
|||
then memorised (even in the |
|
|
Start indicator lamp switches off. |
event of power failure). |
|
|
Select another programme and press the |
|
|
||
|
|
|
START button again. |
|
|
|
|
Turn on the water tap, close the dishwasher door
Wash cycle
Switch off the appliance
Turn off the water tap, unload the racks
-Only open the dishwasher if necessary (Warning: beware of hot steam).
-If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.
At the end of the programme an acoustic signal will sound.
Only after the START button has switched off: press the OFF button. All the indicator lamps switch off.
Warning: When the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
Dishwasher loading instructions and racks provided
Upper rack:
Fold down glass holder (A):
Depending on the position, for example small or long-stemmed glasses.
Crockery holders (B):
Depending on the position, for example plates, cups and long-stemmed glasses.
Long-handled utensils (e.g. carving forks, knives) must be arranged with the sharp end facing in towards the appliance.
Rack height adjustment (also when loaded):
Lower adjustment:
Upper adjustment:
Pull the two rack handles
(C) outwards and lower the rack.
Pull the two rack handles
(C) upwards until the rack clicks into place (factory setting).
The rack must be level on both sides.
Lower rack:
Plate holders (D).
Cutlery basket (E)
The grid (F) can be fitted onto the cutlery basket to keep items separated.
Sharp knives and forks that might cause injury must be placed in the cutlery basket with the sharp end facing downwards.
Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in a dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery.
Loading...