Whirlpool LPR 660 INSTRUCTION FOR USE

QUICK REFERENCE GUIDE

Attention

Please read the operating manual prior to operating the machine for the first time.

GB

1

3

2

1

On/Off button

2

Rinse aid level indicator light

3

Salt level indicator light

4

Start/Cancel button

How to use your dishwasher:

Open the water tap.
Plug to the mains.
Open the door and load the dishwasher. Check if both upper and lower
spray arms move freely.
Pour (Put in) the detergent.
Push in the on/off button and check that the programme light comes on.
Check the salt and rinse aid level indicators before you start the machine.
If necessary add salt and rinse aid.
Use the programme selection button to choose your washing programme.

56

4

7

5

Programme selection button

6

Start/Cancel indicator light

7

Programme lights

Start the programme with the Start/Cancel button:
Close the door then programme starts.

Attention

Avoid opening the door during the washing process. This interrupts the
washing process, and hot steam will escape. When the door is closed, the
programme will continue.

An audio signal with an interval of 10 seconds warns you to switch your
machine off when the selected washing program ends. This audio signal

warns you for a duration of 1-2 minutes and then turns off.
Open the door Press the on/off button after the programme is completed.
The indicator lights will go off.
Close the water tap.
Pull out the plug.
Allow your dishes to cool for 15 minutes, with the door open.

Unload the dishes. Begin with the lower basket.

Programme number

Programme name

Cleaning temperature

Suited to

Degree of dirtiness

Detergents

15 cm³

15-25 cm³

+ 5 cm³

Programme process

Duration (min)

Energy (kWh)

Water (I)

1

Pre-wash

-

Used dishes

which are to be

washed at a later

time

-

-

-

-

Pre-wash

End

15

-

3,6

PROGRAMME TABLE

2

30 Min.

35°C

Dessert and

coffee dishes with

food leftovers
which are not

dried on

Few

x

-

-

35°C wash

Cold rinse

Hot rinse

End

30

0,75

10,2

3

Reference **

Eco

50°C

Normally dirty

dishes with starch

containing food
leftovers which
are not dried on

medium

-

x

x

Pre-wash

50°

wash

Cold rinse

Hot rinse

Dry

End

140

0,95

13

4

Normal

60°C

Normally dirty

dishes with food

leftovers which

are not dried on

medium

-

x

x

60°

wash

Cold rinse

Hot rinse

Dry

End

58

1,15

10,6

5

Intensive

70°C

Especially dirty

dishes with food

leftovers which

are dried on

High

-

x

x

50°C

Pre-wash

70°

wash

Cold rinse

Hot rinse

Dry

End

115

1,30

14,4

The consumption values shown in the table were determined under standard conditions. For this reason, deviations are possible under practical conditions.

** Reference programme für test institutes

The tests in accordance with EN 50242 must be carried out with a full salt container of the water softener, a full reservoir for the rinse aid and the testing programme.
Load capacity : 9

FUNCTION BUTTONS

Function buttons Control indicator lights

GB

On/off button

You turn your dishwasher on / off with this button. When turning
on, the indicator light for the last used programme will light up.

Start/Cancel button

You use this button to start the selected programme.

Programme selection buttons

Use the programme selection button to select the desired
programme. The corresponding programme light lights up.

How to cancel the washing programme

To cancel a programme while the machine is operating:
Open the door
! Care must be taken when opening the door, as steam will
escape.
Press the Start/Cancel button for 3 seconds. Start/Cancel
indicator light will start flashing. Close the door. The machine
will drain the water inside the machine for 45 seconds. The
programme is cancelled when Start/Cancel indicator light goes
off. Then you can choose and start a new programme.

! Important: Depending on the stage of the programme you
have cancelled, there may be detergent residue or rinse aid
inside the machine and on the load. Make sure the items in
the dishwasher are not used before washing properly.

How to change the washing programme

To change the programme selection while the machine is
operating open the door.
! Care must be taken when opening the door, as steam will
escape.
Press Start/Cancel button. The indicator light will go off.
Select the new programme. Press Start/Cancel button. The
indicator light will be on and close the door new programme
will start.

! Important: The new programme will NOT start right from the
beginning. It will start from the stage last carried out by the
previous programme selection.

Attention

- Depending on the length of the terminated programme

- detergent and rinse aid may still be in the dispensers.

2

Rinse aid level indicator light

3

2

If this indicator light comes on, you have to refill
rinse aid.
You can also tell whether rinse aid must be refilled
by looking at the rinse aid dispenser. When the
visual fill indicator is dark, there is enough rinse
aid in the dispenser.
When the colour is light, open the dispenser and
refill rinse aid.

3

Salt level indicator light

3

2

When this indicator light comes on, you must refill
special salt.
In machines which do not possess an electrical
salt indicator, the salt content can be read on the
container for the salt. When the visual fill indicator
is dark, there is enough salt in the container.

When the colour is light, open the container and
add dishwasher salt.

Full

Empty

L

A

Z

S

T

L

U

E

Z

S

S

T

A

L

L

A

Z

S

T

L

U

E

Z

S

S

T

A

L

Note for Testing Institutes

The necessary information for performance testing will be provided upon
request. The request can be done by e-mail through:

[e-mail]

Please do not forget to write the model code and stock code information of
the appliance besides your contact information in the e-mail. The model code
and stock code information can be found on the rating label, which is placed
on the side of the door.

17 1318 01 00-005019 696 94703