Whirlpool LOE 603 INSTRUCTION FOR USE
GB
PROGRAMME CHART
A. “Door open” indication
This washing machine is equipped with
automatic safety functions which detect
and diagnose faults at an early stage
and react appropriately, e.g.:
B. “Service” indication
C. “Water tap closed” indication
D. “Clean filter” indication
Care
Programme
Labels
Cotton
with prewash 95 °C
Cotton
40 - 60 - 95 °C
Synthetics
with prewash 60 °C
Synthetics
30 - 40 - 60 °C
Delicates
30 °C
Quick wash 30 min.
30 °C
Wool
Cold - 40 °C
Handwash
40 °C
Lingerie
30 °C
Rinse & Spin – 5.0 Same as the last rinse and the final spin in the “Cotton” programme.
G
C
D
Max.
Load
- for temperature selection, respect the manufacturer's recommendations on the care label
kg
5.0
5.0
2.5
2.5
Heavily soiled, long wearing and temperature stable textiles in cotton and linen (bed linen, table
linen, underwear, shirts etc.).
Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton
and linen.
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon,
Nylon) or blends with cotton.
Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon,
Nylon) or blends with cotton.
1.5 Curtains and delicate clothing, dresses, skirts, shirts and blouses.
3.0 Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton.
1.0 Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.
1.0 Textiles made of linen, silk, wool and viscose marked as “handwashable”.
1.0
This programme is particurarly suitable to treat delicate lingerie (use of laundry net strongly
recommended).
Type of wash / Notes
E. Programme selector
F. “Start (Pause)” button
A
B
G. Programme sequence indicator
H. “Reset” button
H
FE
Detergents and Additives Special options Max.
Pre-
wash
Yes Yes
– Yes
Yes Yes
– Yes
– Yes
– Yes
– Yes
– Yes
– Yes
– –
Main
Softener Intensive
Wash
1)
1)
Spin
rinse
speed
reduction
–
–
–
–
–
Spin Speed
rpm
Max.
Max.
1000
1000
1000
Max.
1000
400
400
Max.
2)
2)
2)
2)
2)
Spin – 5.0 In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.
Gentle Spin – 1.0 In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.
Drain – – Water is drained only without any spinning.
: option / Yes : dosing required
1)
Do not use liquid detergent in the main wash.
2)
For improved garment care spin speed is restricted in these programmes.
– – – –
– – – –
– – – – – –
Ignis is a registered trademark of Whirlpool USA.
Max.
1000
5019 501 01009
2)
CONSUMPTION DATA
Temperature
Programme
(°C)
Cotton 95 5.0 49* 1.90 2:00
Cotton** 60 5.0 44 0.95 2:20
Cotton 40 5.0 44 0.60 2:00
Synthetics 60 2.5 50* 0.70 1:30
Synthetics 40 2.5 45 0.55 1:15
Delicates 30 1.5 50 0.50 0:45
Quick wash 30 3.0 40 0.40 0:30
Wool
Handwash 40 1.0 45 0.60 0:40
Lingerie 30 1.0 45 0.50 0:36
Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the
home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type
of wash.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.
** Reference Programme for Energy Label.
ADD DETERGENTS, CLOSE THE DOOR AND
SELECT THE PROGRAMME
40 1.0 55 0.60 0:45
Add detergents as indicated on the front page and
as described in your Instructions for Use. Close
the door and turn the programme selector to
the desired programme and temperature. The
indication lamp next to the “Start (Pause)”
button flashes.
Load
(kg)
Water
(l)
SELECT ANY DESIRED OPTION
Energy
(kWh)
Approx. Programme
(hours : minutes)
Push the button(s) of any option(s) desired - the
respective indication lamp lights up.
When the combination of programme and
additional option(s) is not possible, the indication
lights switch off automatically. Unsuitable
combinations of options are deselected
automatically.
Duration
“Intensive rinse” button
• More water is added and rinse cycle is
prologned.
• This option is particularly suitable for areas with
very soft water, washing baby linen and helps
people with allergies.
PROGRAMME START
Open the tap and press the “Start (Pause)”
button. The indication lamp next to the “Start
(Pause)
” button lights up. The programme
sequence indicator shows the current programme
phase, running from left to right through Wash,
Rinse, Spin/Drain.
When the programme phrase is finised, the
corresponding indication goes out.
“DOOR OPEN” INDICATION
Before starting and after end of a programme, the
lamp lights to show the the door can be opened.
As long as a wash programme is running, the door
remains locked and must on no account be forced
open. In case you have an urgent need to open
it during a running programme, refer to “Cancel
(Reset) a running programme before the end”.
RED INDICATIONS
“Service”
Lighting up of the “Service” indication can be
caused by a fault in an electrical component.
Refer to the “Troubleshooting Guide” in your
“Instructions for Use”; if the fault persists, contact
our After Sales Service.
“Water tap closed”
The appliance has no or insufficient water supply.
Open the water tap: if the indications still lights
up, refer to the “Troubleshooting Guide” in the
Instructions for Use.
“Clean filter”
Waste
water is not pumped out. Check whether
the drain hose is kinked or the filter must be
cleaned: in the latter case refer to the Instructions
for Use (“Removing the Filter”).
PROGRAMME END
• All the lights of the programme sequence
indicator are off, and the “Door open”
indication lights up.
1. Turn the programme selector to the “Off/O”
position.
2. Close the water tap.
3. Open the door and unload the machine.
4. Leave the door ajar to allow the drum to dry.
CHANGE PROGRAMME AND/OR OPTIONS
AFTER PROGRAMME START
1. Press the “Start (Pause)” button to pause the
programme. The light flashes.
2. Select the new programme (with temperature),
any options and another spin speed if you want.
3. Press the “Start (Pause)” button again.
The new programme continues at the same
position where the previous programme was
interrupted. Do not add detergent for this
programme.
CANCEL (RESET) A RUNNING PROGRAMME
BEFORE THE END
The “Reset” button cancels a programme before
the end.
• Press the “Reset” button for at least 3
seconds.
Any existing water is drained out before the
door can be opened.
“Spin speed reduction” button
• Reduces the predetermined automatic
maximum spin speed to treat your laundry
more gently.
Ignis is a registered trademark of Whirlpool USA.
5019 501 01009
Loading...