Whirlpool LE9800XS User Manual

AUTOMATIC DRYERS
Electric Model
LE9800XS and Gas Model LG9801XS
MlCrOwave Ovens. Trash Compactors. Room Au Condrtloners Dehumrdclcers Aufomat~c Washers Clothes Dryers Freezers. Retr~gerator~~
Additional Safety Instructions and Your Responsibilities
NEVER operate the dryer if...
l
it is not working right (i.e. noisy, too hot].
l
it is damaged,
l
parts are missing [i.e. door latch).
l
all panels are not in place.
. the lint screen is loose, damaged or
missina.
FOR Y~R~ETY
If you smell gas:
1. Open windows.
2. Don’t touch electrical switches.
3. Fatzeguish any open
.
4. Immediately call your gas supplier.
FOR YOUR SAFETY
I Do not store or use gas-
oline or other flammable vapors and liquids in the
’ vicinity of this or any other
ALWAYS shut off the gas valve before leav­ing on vacation.
ALWAYS unplug Ihe power supply cord or turn off electrical power before atempting to service the dryer. Shut off GAS VALVE if yours is a gas dryer.
You are personally responsible for making sure that your dryer...
l
is properly maintained
l
is properly installed and leveled in a well ventilated room* on a floor that can sup­port the weight.
l
is located in an area where the tempera­ture is above 45’F (7.2’C).
l
is connected to the proper outlet and electrical supply.’
l
is properly connected to fuel and ex­haust systems.*
l
is not installed against drapes or curtains.’
l
is used only for jobs normally expected of home clothes dryers.
l
is not used by children or anyone unable to operate it properly.
*See “Installation Instructions” for com-
plete Intormation.
appliance.
3

Operating instructions

Selecting a Cycle and Starting
Your Dryer
Before starting your dryer, be sure laundry is sorted and loaded properly (see your “Dryer Guide”). Be sure the door is tightly closed.
1
. Touch POWER “ON”
l
Touch the POWER “ON” pad. The dryer will power up, but the drum will not start turning. The Fabric Selection lights will scan and the Finish Guard and Cycle Signal lights will come on.
l
The dryer will continue to scan the Fabric Selection lights until a selection has been made. If a selection has not been made wlthin 15 minutes, the dryer will automatically shut off.
Proper and Improper Selections
l
If a selection has not been accepted, the indicator light will not stay on and 3 beeps will sound.
l
If a selection has been accepted, the indicator light will stay on and 1 beep will sound.
2
l
Touch a FABRIC SELECTION that matches the load type you want to dry. The light will stay on in the selection you choose. See page 7 for suggested Fabric Selections.
l
If FINISH GUARD” and/or CYCLE SIGNAL options are not wanted, touch the desired pad(s) to cancel the options. The lights will go off.
NOTE: The AIR FLUFF selection auto-
matically provides 20 minutes of timed drying without heat. If more or less time is wanted, touch the corresponding TIMED DRY pad. An Electronic DRY-MISER@ selection cannot be used with AIR FLUFF.
Touch a
n
FABRIC SELECTION
Touch an Electronic DRY-MISER” Control
3
n
or TIMED DRY Selection.
-
tronic Display will show “AU: After a period of tumbling, the dryer will be able to calculate the remaining time needed
Electronic DRY-MISER@ Control
l
Touch the Electronic DRY-MISER Control that describes the dryness YOU want for the load.
A sensor on the back of the dryer drum senses the moisture in the load. When the selected dryness has been reached, the dryer automati­cally shuts off. If dryness is not what you expected, use the following as a guide:
l
For the first few loads, use REG DRY When finished, check the load for desired dryness.
l
If the load is not dry enough, use MORE DRY or VERY DRY the next time.
l
If the load is too dry, use LESS DRY the next time.
l
If you plan to iron the clothes after drying, use DAMP DRY
to dry the load. The time on the display will count down until the cycle ends.
TIMED DRY
l
Touch a TIMED DRY selection for any load you want to dry by time. The Time Display will automati­cally show 30 minutes.
l
If more time is wanted, touch A MORE up to 99 minutes.
l
If less time is wanted, touch v LESS,
The TIMED DRY selection is good for
very small loads or large bulky items. IMPORTANT: If the load you have
finished drying is not dry enough...
1. Touch POWER “OFF,“then touch POWER “ON!’
2. Touch a FABRIC SELECTION tor the load type.
3. Set TIMED DRY FOR 20 minutes.
Remember to select a different dryness setting for the next similar load.
DRY-MISER Contrcbl, the Time
5
Loading...
+ 11 hidden pages