Whirlpool LA9100XT, LA9300XT, LA9320XT Owner's Manual
~i+l 01
4a
Use & CareGuide
Temperature selector
Load size
select0 -
Extra rina
I
Cvcle control
Model and serial
number plate
Bleach dispenser
MAGIC CLEAN@
(not shown)
SUPER CAPACITY TWO SPEED
AUTOMATIC WASHERS
LA9looxT LA93ooxT LA932oxT
Basket
llnt filter
Contents
Important Safety
Instructions.. . .
Operating Instructions
Starting your washer
What happens in each cycle
Other Operating Instructions
Rinse and spin
Extra rinse option
Drain and spin
Soak cycle
MAGIC CLEANB lint filter
Liquid bleach dispenser .
If You Need Service Or
Assistance. 12-l 3
Whirlpool Automatic
Washer Warranty.
01989 Whirlpool Corporation
Page
4-5
5-9
10
10
10
11
11
11
16
Thank you for buying a Whirlpool
3
appliance. Please complete and mail
the Owner Regrstration Card provided
with this product. Then complete the
form below. Have this information ready
if you need service or call with a
question.
l
Copy model and serial numbers
from plate (under lid near hinge) and
the purchase date from the sales slip.
l
Keep this book, the Laundry Guide
and the sales slip together in a
handy place.
Model Number
Serial Number
Purchase Date
Service Company Phone Number
If your washer has a Consumer Buy
Guide label, remove it. It will be easier
to remove before the washer is used.
To remove any remaining glue:
l
Rub briskly with thumb to make a ball,
then remove.
or
l
Soak area with liquid hand dishwashing detergent before removing glue as
described above.
Do not use sharp instruments,
rubbing alcohol, flammable fluids or
abrasive cleaners. These can damage
the finish. See “Important Safety
Instructions” on page 3.
Important Safety Instructions
l
Read all instructions before
using the washer.
l
NEVER wash items cleaned,
washed, soaked in or spotted with
wax, paint, gasoline, or in flammable fluids in the washer. The fumes
can create a FIRE HAZARD or
EXPLOSION. ALWAYS hand
launder and air dry fabrics containing these materials.
l
NEVER allow children to operate,
play with, or crawl inside the
washer. Close supervision of
children is necessary when the
washer is used near children.
l
When discarding an old washer,
ALWAYS remove the lid to prevent
accidental entrapment.
l
NEVER put your hands into the
washer until all motion stops. If the
lid is opened while the basket is
spinning, the basket will automatically stop in a few seconds.
a DO NOT tamper with controls.
l
NEVER use or store flammable
fluids (dry-cleaning solvents,
kerosene) in or near your washer.
DO NOT add flammable fluids to the
wash water. These substances
- SAVE THESE INSTRUCTIONS -
give off vapors that can create a
FIRE HAZARD or EXPLOSION.
l
If hot water has not been used
recently (usually 2 weeks or
longer), hydrogen gases may build
up in the water heater and the hot
water pipes. HYDROGEN GAS IS
EXPLOSIVE. To prevent injury or
damage, before using your washer,
turn on all hot water faucets and
allow water to run for several
minutes. This will allow gases to
escape. DO NOT smoke or use
any open flame near the faucet
while it is open.
l
You are responsible for mak-
ing sure that your washer:
- is installed, repaired, and has
parts replaced by a qualified
person.
- is properly installed and leveled
on a floor that can support the
weight.’
- is connected to the right kind of
outlet, electric supply, water
supply and drain.’
- is properly grounded.*
- is properly maintained.*
- is protected from the weather
and kept where the temperature
will not fall below freezing.
‘See the Installation Instructions.
,dditional safety instructions and your responsibilities
l
ALWAYS store detergent, laundry
aids and other materials in a cool, dry
place where children can’t reach them
- in a locked cabinet if possible.
l
ALWAYS read and follow instructions
on packages of detergent and laundry
aids -especially warnings and
precautions.
l
HAZARDOUS FUMES can be
formed if chlorine bleach is used in
the same wash as ammonia or acids
such as vinegar or rust remover.
l
ALWAYS unplug the power supply
cord before attempting to service
the washer.
l
DO NOT machine wash glass fiber
materials. Small particles can stick to
fabrics washed in following loads and
cause skin irritation.
l
You are responsible for making
sure that your washer:
- is used only for jobs normally ex-
pected of home automatic washers.
- is not run by children or anyone
unable to operate it properly.
3
Operating Instructions
The drawings in this book may vary slightly from your washer model. They are
designed to show the different features of all the models covered by this book.
NOTE:
Your model may not include all the features shown.
Starting your washer
Be sure to measure and add detergent, then place a sorted load in the washer before
starting it.
1. Select a load size
l
Position the Load Size Selector at the
setting that describes the size of load
you want to wash.
l
The selector can be set anywhere on
or between EX SMALL (a few small
items) and EX LARGE (a full load).
l
To change the water level after the
washer has started to fill, slide the
selector to RESET, then to the desired
water level.
NOTE:
For best washing results, items
should move freely in the washer. Do
not overload the washer or choose a
water level that is too low for your wash
load.
For best results with permanent
press clothes, use the EX LARGE water
level.
Reduce wash time when using EX
SMALL or SMALL water level settings.
Loads with only a few small items need
less wash time for best results.
2. Touch a temperature selection
l
Match the water temperature to the
type of fabric and soils being washed.
l
The top temperature is the wash
selection and the bottom temperature
is the rinse selection.
l
An indicator shows which temperature
has been selected.
NOTE:
Use warm wash water with the
PERMANENT PRESS or KNITS/
GENTLE Cycles.
For heavily soiled permanent press
or knit clothes, pre-soak before washing
in warm water.
ALWAYS use cold rinse water for
permanent press fabrics.
3. Select cycle and wash time
Start the washer
l
Push in the Cycle Control Knob and
turn it to the right.
l
Stop on the number in the wash cycle
you want. The numbers are minutes of
wash time.
l
Star-l the washer by pulling out the
Cycle Control Knob. The washer will
fill to the selected water level with the
selected wash water temperature.
After filling, the washer will agitate for
the selected number of minutes.
l
To stop the washer at any time, push
in the Cycle Control Knob. To restart
the washer, pull out the Cycle
Control Knob.
What happens in each cycle
Each cycle has different agitation and
spin speeds designed for different kinds
of fabrics.
Numbers on the dial in each cycle are
the minutes of wash agitation time.
When the Cycle Control Knob is set
to a number and pulled out, the washer
fills before agitation and timing starts.
After agitation starts, the knob turns
clockwise until it points to OFF and the
cycle ends.
Gentle Wash System
For better fabric care in the REGULAR
and PERMANENT PRESS Cycles, the
agitation speed is reduced during the
last few minutes of wash agitation time.
NOTE: You
may hear the sound of
water spraying during the spin parts of
some cycles. In some cycles, water is
sprayed on the spinning load to help
with the rinsing.
The washer will pause briefly
throughout each cycle. These pauses
are normal. They allow for the reversing
of the motor, normal washer operation
and the cool-down portion of the
PERMANENT PRESS Cycle.
5
Loading...