Remove the Consumer
Buy Guide label. It will be
easier to remove before
the washer is used.
You should wipe out the
basket with a damp cloth
before using to remove
dust from storing
or
Copy your Model and Serial Numbers here
When you need service or call with a
question, have this information ready:
1. Complete Model and Serial Numbers(from plate underthe lid nearthe
hinge).
2. Purchase date from sales slip
Copy this information in these spaces.
Keep this book in the Laundry Information Center with your”Laundry Guide,”
sales slip and warranty. Phone Number
There is no warranty registration to return. Proof-of-purchase is all
that is required for in-warranty service.
Model Number
Serial Number
Purchase Dote
Service Company;
Your responsibilitie
Read this “Usi and Care Guide”
and your “Laundry Guide” carefully for important use and safety
information.
You are personally responsible
for making sure that your
washer...
l
is installed by a qualified installer.
l
is properly installed and
leveled on a floor that can
support the weight.’
l
is connected to the right kind
of outlet, electric supply, water
supply and drain.=
l
is properly grounded.’
l
is used only for jobs normally
expected of home automatic
washers.
l
is properly maintained.
l
is protected from the weather
and kept where the tempera-
ture will not fall below freezing.
l
is not run by children or anyone
unable to operate it properly.
*See the”Installation Instructions”
for complete information.
Contents
PARTS AND FEATURES.
YOUR RESPONSIBILITIES.
SAFETY FIRST
STARTING YOUR WASHER
WHAT HAPPENS IN EACH
CYCLE.
OTHER OPERATING
INSTRUCTIONS
For a Rinse and Spin
For a Drain and Spin
Fora Soak
Liquid Bleach Dispenser
MAGIC CLEAN ” Filter,
Liquid Fabric Softener
Dispenser
SUDS MISER” System
[Model lA7685XP only)
CARING FOR YOUR WASHER
Winterizing
IF YOU NEED SERVICE OR
ASSISTANCE..
I. Before Calling for
Assistance
2. If You Need Assistance
3. If You Need Service
4. If You Have a Problem
~~‘1985 Whirlpool Corporation
Page
10
10
10
10
12
13
14
15
15
15
15
15
2
3
3
4
6
11
11
11
-SAVE THESE INSTRUCTIONS 3
Starting your washer
Before
starting
Yo”rwasher: 3, Startwasher,
I. Measure and add detergent
2. Place sorted load in washer.
Select a
1. LOAD SIZE
l
To change the setting on the LOAD
SIZE SELECTOR, turn the knob to RESET.
l
Then turn the knob to point at a
setting that describes the size of the
load you want to wash.
l
Set the knob anywhere on or between HAND WASHABLE (a few small
items) and EX LARGE [a full load).
See your “Laundry Guide” for details
on load sizes.
Select WATER
2.
TEMPERATURES
l
Select wash and rinse water temperatures by pushing a button.
l
This drawing shows a warm wash
(top temperature) and cold rinse
(bottom temperature) selection.
Recommended wash temperatures
can be found in your “Laundry Guide”
LOAD SIZES AND WATER LEVELS
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too
little water can cause wear or
tearing of load items.
0
DO NOT
OVERLOAD WASHER.
*Approximate
fill with load.
EX-LARGE (20.5 gals.177.6 L)’
MEDIUM (13.9 gals./52.6 L)’
HAND WASHABLE (7.8 gals./29.5 L)’
Start the washer
3.
A.
Push in the Control Knob and
turn it to the right. It must be
pushed in and turned only
clockwise.
C.
Start the washer by pulling oui
the Control Knob. The washer
will fill to the level you set with
wash water of the selected
temperature. After filling, the
washer will agitate for the
selected number of minutes.
B.
Stop on a number in the cycle
you want. The numbers are min-
utes of wash time. The drawing
shows10 minutes of agitation in
the REGULAR Cycle.
D.
To stop the washer at any time
push in the Control Knob. To
restart the washer, pull out the
Control Knob.
5
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.