Whirlpool LA64ooXP User Manual
AUTOMATIC
WASHER
Design 2000@
Large Capacity
Model
LA64ooXP
UJ
Parts and features
LOAD
SIZE
LAUNDRY
INFORMATION
/ CENTER
TEMPERATURE MAGIC CLEAN 9
SELECTOR LINT FILTER
/
CLOTHES
~E;;;shown’
- LIQUID FABRIC
SOFTENER DISPENSER
. AGITATOR
.BASKET
Remove the Consumer
Buy Guide label. It will be
easier to remove before
the washer is used.
You should wipe out the
(not shown)
NUMBER PLATE
m,.-nr.,crrr
lJl3l-tN3tK
AND SERIAL
MODEL
Copy your Model and Serial Numbers here
When vouneed service or call with a
question, have this information ready:
1. Complete Model and Serial Numbers (from plate under the lid near the
hinge).
2. Purchase date from sales slip
Copy this information in these spaces,
Keep this book in the Laundry Information Center with your”Laundry Guide,”
sales slip and warranty.
There is no warranty registration to return. Proof-of-purchase is all
that is required for in-warranty service.
2
Model Number
Serlo, Number
Purchase Date
Service Company/
Phone Number
Your
Read this “Use and Care Guide”
and your “Laundry Guide” carefully for important use and Safety
information.
You are personally responsible
for making sure that your
washer.. .
l
is instolled by a qualified installer.
l
is properly installed and
leveled on a floor that can
support the weight.*
l
is connected to the right kind
of outlet, electric supply, water
supply and drain. is properly grounded.* is used only for jobs normally
expected of home automatic
washers.
l
is properly maintained.
l
is protected from the weather
and kept where the tempera-
ture will not fall below freezing.
l
is not run by children or anyone
unable to operate it properly.
*See the “Installation Instructions”
for complete information.
IT
onsibilitie
Contents
PARTS AND FEATURES
YOUR RESPONSIBILITIES.
SAFETY FIRST.
STARTING YOUR WASHER.
WHAT HAPPENS IN EACH
CYCLE. .
OTHER OPERATING
INSTRUCTIONS. 10
For a Rinse and Spin 10
ForaDrainandSpin 10
For a Soak or Pre-Wash 10
Liquid Bleach Dispenser 11
Fabric Softener Dispenser 11
MAGIC CLEAN@ Lint Filter 11
CARING FOR YOUR WASHER.. 12
Winterizing 13
IF YOU NEED SERVICE OR
ASSISTANCE.. . 14
1. Before Calling for
Assistance 14
2. If You Need Assistance. . 15
3. If You Need Service 15
4. If You Have a Problem 15
01985 Whirlpool Corporation
Page
2
3
3
4
6
-SAVE THESE INSTRUCTIONS -
1
3
Starting your washer
Before starting
your washer:
1 Measure and add detergent
2 Place sorted load In washer
3 Start washer
Select a
1. LOAD SIZE
l
Turn the knob to point at a setting
that describes the size of load you
want to wash.
l
Set the knob anywhere on or
between EX SMALL [a few items)
and LARGE (a full load).
DO NOT LOAD
ABOVE CLOTHES GUARD
NOTE: Use the LARGE wufer level
for besf permanent press results.
Select WATER
2.
TEMPERATURES
6 Match the wash water temperature
to the type of fabrics and soils being
washed.
Recommended wash temperatures
can be found in your “Laundry Guide’:
LOAD SIZES AND WATER LEVELS
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too
little water can cause wear or
tearing of load items. _
*Approximate
fill with load.
4
Elt?SMALL (9.5 gaW36.0 L)’
DO NOT
OVERLOAD WASHER.
(17.3 galsJ65.5 L)’
(14.7 galsJ55.7 L)’
(12.1 gals./45.8 L)’
3.
Start the washer
A.
Push in the Control Knob and
turn it to the right. It must be
pushed in and turned only
clockwise.
C.
Start the washer by pulling out
the Control Knob. The washer
will fill to the level you sei with
wash water of the selected
temperature. After filling, the
washer will agitate for the
selected number of minutes.
B.
Stop on a number in the cycle
you want. The numbers are minutes of wash time. The drawing
shows 10 minutes of agitation in
the REGULAR Cycle.
D.
To stop the washer at any time
push in the Control Knob. To
restart the washer, pull out the
Control Knob.
5
Loading...