Remove the Consumer
Buy Guide label. It will be
easier to remove before
the washer is used.
You should wipe out the
basket with a damp cloth
before using to remove
dust from storing or
shipping.
MAGIC CLEAN
LINT FILTER
(not shown)
-NUMBER PLATE
(not shown)
n
Copy your Model and Serial Numbers here
When you need service or call with a
questlon, have this informatlon ready:
1. Complete Model and Serial Numbers (from plate under the lid near the
hinge).
2. Purchase date from sales slip.
Copy this information in these spaces.
Keep this book in me Laundry Informatlon Center with your”Laundry Guide,”
sales slip and warranty
There is no warranty registration to return. Proof-of-purchase is all
that is required for in-warranty service.
2
Model Number
Serial Number
Purchose Da’e
Service Company/
Phone Number
re
sponsibilities
Read this ‘IIs& and Care Guide”
and your “Laundry Guide” carefully for important use and safety
information.
You are personally responsible
for maklng sure that your
washer...
l
is installed by a qualifiedinstaller.
l
is properly installed and
leveled on a floor that can
support the weight.*
l
is connected to the right kind
of outlet, electric supply, water
supply and drain.* is properly grounded.. is used only for jobs normally
expected of home automatic
washers.
l
is properly maintained.
l
is protected from the weather
and kept where the temperature will not fall below freezing.
l
is not run by children or anyone
unable to operate if properly,
*See the “Installation Instructions”
for complete information.
Contents
Page
PARTSANDFEATURES . . . . . . 2
YOUR RESPONSIBILITIES 3
SAFETY FIRST .
STARTING YOUR WASHER . 4
WHAT HAPPENS IN
EACH CYCLE .
OTHER OPERATING
INSTRUCTIONS .
For a Rinse and Spin 8
For a Drain and Spin 8
For a Soak or Pre-Wash 8
Liquid Bleach Dispenser 9
Magic Clean’ Filter 9
Suds-Miser’ System
(Model LA5805XM only) 10
CARING FOR YOUR
WASHER _. _. _, 11
IF YOU NEED SERVICE OR
ASSISTANCE _. 13
61983 Whirlpool Corporation
3
6
8
-SAVE THESE INSTRUCTIONS 3
Starting your washer
Before starting
your washer:
Select a Select WATER
1. LOAD SIZE
1. Measure and add detergent.
2. Place sorted load in washer.
3. Start washer.
2.
TEMPERATURES
l
l
To change the setting on the LOAD
SIZE SELECTOR, turn the knob to RESET.
l
Then turn the knob to point at a
setting that describes the size of the
load you want to wash.
l
Set the knob anywhere on or be-
tween HAND WASHABLE (a few small
items) and EX LARGE (a full load).
See your “Laundry Guide” for details
on load sizes.
Select wash and rinse water temperatures by pushing a button.
l
This drawing shows a warm wash
(top temperature) and cold rinse
(bottom temperature) selection.
Recommended wash temperatures
can be found in your “Laundry Guide”
and printed under the washer lid.
/ LOAD SIZES AND WATER LEVELS
Use less than a full tub of water
when you have less than a full load load must be able to move freely
to wash.
EX-LARGE (20.5 gals./77.6
MEDIUM (13.9 gals.152.6 L)’
HAND WASHABLE (7.8 gals./29.5 L)’
‘Approximate fill with load.
for best cleaning results. the
in the water. Too big a load or too
little water can tear items.
L]’
’
’
%B
3. Start the washer
A.
Push in the Control Knob and
turn it to the right. It must be
pushed in and turned only
clockwise.
C.
Start the washer by pulling out
the Control Knob. The washer
will fill to the level you set with
wash water of the selected
temperature. Atter filling, the
washer will agitate for the
selected number of minutes.
B.
Stop on a number in the cycle
you want. The numbers are
minutes of wash time. The
drawing shows 8 minutes of
agitation in the REGULAR HEAVY
Cycle.
D.
To stop the washer at any time
push in the Control Knob. To
restart the washer, pull out the
Control Knob.
To set the controls for a rinse and
spin, a drain and spin, or a soak
or pre-wash. see page 8.
5
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.