AUTOMATIC
WASHER
Design 2000
Large Capacity
Model
LA5460XM
Iwave Ovens. Trash Compactors. Room AN Condltloners. Oehumidlllers. Automallc Washers, Clothes Dryers, Freezers, Refrlgeralor-Freeze
Parts and features
MODEL AND SERtAl
NUMBER PLATE
(nof shown)
Remove the Consumer
Buy Guide label. It will be
easier to remove before
the washer is used.
COPY your Model and Serial Numbers here
When YOU need service of call with a
question, have this information ready:
1. Complete Model and Serial Numbers (from plate under the lid near the
hinge).
2. Purchase date from sales slip.
Copy jhis information in these spaces.
Keep thrs book in the Laundry Informotlon Center with Your “Laundry Guide,”
sa!es slip and warranty
There is no warranty registration to return. Proof-of-purchase is aI1
that is required for in-warranty service.
2
Model Number
Seria, Number
P”rchose ‘Ote
Serv,,-e
Phone Number
Company/
Your
responsibilities
Read this “Use and Care Guide”
and Your “Laundry Guide” carefully for important use and safety
information.
You are personally responsible
for making sure that your
washer...
l
is installed by a qualifiedinstaller.
l
is properly installed and
leveled on a floor that can
support the weight.*
l
is connected to the right kind
of outlet, electric supply, water
supply and drain.*
l
is properly grounded.*
l
is used only for jobs normally
expected of home automatic
washers.
l
is properly maintained.
l
is protected from the weather
and kept where the temperature will not fall below freezing.
l
is not run by children or anyone
unable to operate it properly.
*See the “Installation Instructions”
for complete information.
Contents
Page
PARTS AND FEATURES
YOUR RESPONSIBILITIES
SAFETY FIRST
STARTING YOUR WASHER 4
WHAT HAPPENS IN
EACH CYCLE
OTHER OPERATING
INSTRUCTIONS,
For a Rinse and Spin
For a Drain and Spin
Magic Clean” Filter
CARING FOR YOUR
WASHER
Winterizing.. IO
IF YOU NEED SERVICE OR
ASSISTANCE 11
1. Before Calling for
Assistance. 11
2. If You Need
Assistance 11
3. If You Need Service.. 11
4. If You Have a Problem 11
01984 Whirlpool Corporation
2
3
3
6
8
8
8
8
9
Starting your washer
Before starting your washer:
; 1. Measure and add detergent.
:--/
9
1. LOAD SIZE
2. Place sorted load in washer.
3. Start washer.
DO NOT OVERLOAD WASHER
See pages 6 and 7 in
your “Laundry Guide:’
Select a
mm TEMPERATURES
9 Turn the knob to point at a setting
that describes the size of load you
want to wash.
l
Set the knob on EX SMALL (a few
items) or LARGE (a full load).
NOTE: Use the LARGE water level for
best permanent press results.
DO NOT LOAD
ABOVE CLOTHES
GUARD
l
Match the wash water temperature
to the type of fabrics and soil being
washed.
l
All rinses are cold. Cold rinses save
energy and help prevent wrinkles
from setting into fabrics.
LOAD SIZES AND WATER LEVELS
For best cleaning results, the load
must be able to move freely in the
water. Too big a load or too little water
can tear items.
IMPORTANT: The EX SMALL setting in the
REG/HEAVY Cycle may cause water
to splash over the tub. If this happens,
move the Load Size Selector to a
higher water level.
‘Approximate fill with load.
$
(9.5 galsJ36.0 L)*