Whirlpool L 526, L 526 S INSTRUCTION FOR USE
Before using the dishwasher, read the user instructions!
L 526
Indicators
Quick Reference Guide
Wash cycle
Programme selector knob
Pre-Rinse Washing Drying End
Start button
Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Options
Add rinse aid
Add regeneration salt
Only add regeneration salt
immediately before starting a wash
programme.
Programme chart
Programmes Loading instructions A B
3)
“Half load” button
This function can be used with any programme.
The indicator lamp switches on. The wash cycle is
activated for the upper or lower rack
When washing without the top rack, press the
“Half Load” button (LED alight).
Time and failure display
Indicates in hours the time remaining until the start
of the wash cycle. Switches off when the
programme starts and indicates the time remaining
in hours and minutes.
“F....” Identification of faults for service technician
“Delayed start” button
The wash cycle can be programmed to start after
1 - 24 hours. With each successive touch of the
button, the delayed start indicator increases by 1
hour , and after 24 returns to 00. Then press the Start
button. The dishwasher will start at the set time.
Detergent
only
2)
Consumption
Litres kWh Minutes
GB
.
3)
Pre-Rinse cold
Quickwash 40°C
1)
Eco
Daily 60°C
Intensive 70°C
1) Reference programme for energy label in c ompliance with
EN 50242 regulations;
2) Refer to “User instructions”;
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
Crockery to be washed later. - - 4.0 0.03 14
Lightly soiled crockery with no
dried-on food.
Normally soiled crockery. X X 16.0 1.05 170
50°C
Normally or heavily soiled
crockery.
Recommended programme for
heavily soiled crockery, especially
suitable for pans and saucepans.
3) Programme data obtained in conformity with European
standard EN 50242. Values may vary in relation to usage,
e.g.: different loads, options, water temperatures - above
or below 15°C - as well as water hardness and power
supply voltage, etc.
X - 10.0 0.65 30
X X 16.0 1.25 120
X X 17.0 1.55 155
(We reserve the right to make technical modifications)
5019 696 98040
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Switch on the appliance
How to fill the
detergent dispenser
Check the rinse aid level
Check the regeneration
salt level
Load the racks
Close the dishwasher door,
turn on the water tap
Select a programme
Automatic start by turning the programme selector knob (in case of
retractable knob, first press the knob to access it).
Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash only.
If using combined action dishwasher
tabs, follow the user instructions!
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener
system only.
Mechanical indicator D. Electric
indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
Select the desired programme.
The corresponding indicator lamp comes on.
A:
B:
ABC
Select options
Press the Start button
Wash cycle
Switch off the appliance
Turn off the water tap,
unload the racks
If necessary (and if provided) the corresponding indicator lamp lights up.
The selected programme is
then memorised (even in the
event of power failure).
Only after the START button has switched off: Access the knob (in case of
retractable knob, press and then release the knob).
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
“Change programme”
Press the ST ART button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and
press the START button again.
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.
Loading...