Whirlpool KOMC 9610/IX INSTRUCTION FOR USE

KOMC 9610

Instructions for use

Installing the built in oven 4

Safeguarding the environment 5

Warnings 5

Before using the oven 6

Oven accessories 7

Care and maintenance 8

Troubleshooting guide 10

After Sales Service 10

Electrical connection for Great Britain and Ireland only 11

4

Installing the built in oven

After removing the oven from its packaging, before making the
connections place it on the polystyrene foam base to protect it from
damage.
Oven installation requires two people. Do not attempt to lift the
oven by the door handle. Lift by means of the handles on the side of
the oven.
Check that the appliance has not been damaged in transit.
Oven dimensions and kitchen unit dimensions are shown in the figure
opposite.
Any adjacent kitchen units must be heat resistant (80° C min).
If plastic laminates or cement are not sufficiently heat-resistant,
warping, bubbling or detachment of the finish may result.
Install the oven in the housing, lifting it by the sides, taking care not to
trap the wires of the power supply cable.

For correct ventilation, observe the ventilation opening
directions shown in the figure (500 min x 80 mm and 500 min
x 50 mm inside the cabinet).

Secure the oven to the kitchen unit with screws (A) as shown.

During oven installation, care must be taken to ensure that the sides
do not touch the front edges of the housing or adjacent drawers and
doors (see picture).

• Important: do not connect to the power supply until you
have finished connecting the oven and cooktop.

• Make sure the appliance is installed and connected to the
power supply by a qualified technician in accordance with
the manufacturer’s instructions and in compliance with
local regulations.

• The installer is responsible for the correct electrical
connection of the appliances and the observance of the
relative safety recommendations.

• The appliance must be connected to the power supply by
means of an all-pole disconnect switch with minimum
contact gap of 3 mm.

• The law requires that the appliance be earthed.

• Do not use multiple plug adapters or extension leads.

• After the oven has been installed, the electrical
components must be concealed.

Make sure that the voltage shown on the rating plate is the
same as the domestic power supply voltage.
The rating plate is on the front edge of the oven cavity (visible
with oven door open).

For Australia only:

The oven is delivered without supply cord. Use a supply cord type
H05 RR-F, 3X2,5 mm2 min.

Fumes vent

Earth