Whirlpool GU3200XTXB, GU3200XTXQ, GU3200XTXY, GU3600XTVB, GU3600XTVQ Dimension Guide

®

Undercounter Dishwasher

PRODUCT MODEL NUMBERS			PRODUCT DIMENSIONS
GU3000XTX	GU3600XTV
GU3200XTX

Electrical Requirements: 120-volt, 60-Hz, AC-only, 15or 20-amp fused electrical supply. Copper wire only. A timedelay fuse or circuit breaker and separate circuit is recommended.

If direct wiring dishwasher: Use flexible, armored or nonmetallic, sheathed copper wire

with grounding wire that meets the wiring requirements for your home

and local codes and ordinances.

Use a UL Listed or CSA Approved strain relief.

If connecting dishwasher with a power supply cord:

Use Power Supply Cord Kit (Part Number 4317824) marked for use

with dishwashers. Follow the kit instructions for installing the power supply cord.

Power supply cord must plug into a grounded three-prong, outlet, located in the cabinet next to the dishwasher opening. Outlet must meet all local codes and ordinances.

Water Supply Requirements: A hot water line with 20 to 120 psi (138 to 862 kPa) water pressure. Water temperature must be 120°F (49°C) water at dishwasher. Use ³⁄ " O.D. copper tubing with compression fitting or flexible braided water supply line (Part Number 4396897RP) (¹⁄ " minimum plastic tubing is not recommended). Use a 90° elbow with ³⁄ " hose connection with rubber washer. Do not solder within 6" (15.2 cm) of the water inlet valve.

Drain Requirements: A new drain hose is supplied with your dishwasher. If this is not long enough, use a new drain hose with a maximum length of 12' (3.7 m) (Part Number 3385556) that meets all current AHAM/IAPMO test standards, is resistant to heat and detergent, and fits the 1" (2.5 cm) drain connector of the dishwasher.

Make sure to connect the drain hose to waste tee or disposer inlet above drain trap in house plumbing and 20" (50.8 cm) minimum above the floor. It is recommended that the drain hose either be looped up and securely fastened to the underside of the counter, or be connected to an air gap.

air gap

Make sure to use an air gap if the drain hose is connected to house plumbing lower than 20" (50.8 cm) above subfloor or floor.

Use ¹⁄ " (1.3 cm) minimum I.D. drain line fittings.

If required, the air gap should be installed in

accordance with the air gap installation instructions. When connecting the air gap a rubber hose (not provided) will be needed to connect to the waste tee or disposer unit.

		Page 1 of 2
Because Whirlpool Corporation policy includes a continuous commitment to improve	Dimensions are for planning purposes only. For complete details, see Installation	Ref. W10282549A
our products, we reserve the right to change materials and specifications without notice.	Instructions packed with product. Specifications subject to change without notice.	11/12/10