Whirlpool GR2SHWXP, GT1SHWXP, GT1PHWXP DIMENSIONS
Refrigerator
®
PRODUCT MODEL NUMBERS OVERALL DIMENSIONS
LOCATION REQUIREMENTS
GR2SHWXP
GT1SHWXP
GT1PHWXP
Electrical: A 115 Volt, 60 Hz., AC only 15 or 20
amp fused, grounded electrical supply is required.
It is recommended that a separate circuit serving
only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use
an extension cord.
Water: A cold water line with water pressure
between 30 and 120 psi (207-827 kPa)is required
to operate the water dispenser and ice maker..
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the system needs to be a minimum of
40 to 60 psi (276 - 414 kPa).
IMPORTANT: The pressure of the water coming
out of a reverse osmosis system going to the
water inlet valve of the refrigerator needs to be
between 30 and 120 psi (207 - 827 kPa).
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 2302309
10-25-04
To ensure proper ventilation for your refrigerator, allow for 1⁄2 in. (1.25 cm) space
on each side (between base board trim if used) and at the top. (At the top, when
using half depth cabinet, use top of cabinet height "D" dimension. When using full
depth cabinet, add 1/4 in. to overall "E" dimension.) When installing your refrigerator
next to a fixed wall, leave 2 in. (5.08 cm) minimum on each side (depending on your
model) to allow for the door to swing open. If your refrigerator has an ice maker,
allow extra space at the back for the water line connections.
NOTE: Do not install the refrigerator near an oven, radiator, or other heat source, nor
in a location where the temperature will fall below 55°F (13°C).
E*
overall
D*
top of
cabinet
C
C
D*
top of
cabinet
B
B
not incl.
handle
A
Integrated
Model
Standard
Model
E*
overall
A
Depth Cab.Width Door Width Cab.Height Overall Height
Model size "A" "B" "C" "D*" "E*"
STANDARD MODELS
21 cu.ft. 30 3/4" 32 1/2" 32 3/4" 65 1/2" 66 1/4"
INTEGRATEDMODELS
22 cu.ft. 32 1/4" 32 1/2" 33 1/8" 65 1/2" 66 1/2"
*includes rollers extended 3/4"
1/
2" (1.25 cm)
2" (5.08 cm)
Loading...