Whirlpool GSXS 7321/2 INSTRUCTION FOR USE
GSXS 7321
Before using the dishwasher, read the user instructions!
Quick Reference Guide
On button
Off button
Programme selection button
Start button
Switches “on” when the dishwasher
is operating. Flashes when a fault
occurs. Switches off at the end of
the programme.
GB
Programme chart
Programmes Loading instructions A B
Rapid 30 min 40°C
Standard
1)
Intensive 70°C
1) Reference programme for energy label in
compliance with EN 50242 regulations;
2) Refer to “User instructions“;
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
Lightly soiled crockery, with no
dried-on food.
Normally soiled crockery. X X 16.0 1.24 133
50°C
Heavily soiled crockery,
especially pots and pans.
3) Programme data obtained in conformity with
Detergent
X - 13.0 0.70 30
X X 17.0 1.90 135
European standard EN 50242. Values may vary in
relation to usage, e.g.: different loads, water
temperatures - above or below 15°C - as well as
water hardness and power supply voltage, etc.
(We reserve the right to make technical modifications)
2)
Consumption
Litres kWh Minutes
5019 496 98008
3)
How to use the appliance
CBA
Further indications are given in the single chapters and in the user instructions.
Open the door
Switch on the appliance
How to fill the
detergent dispenser
Check the
rinse aid level
Check the regeneration
salt level
Load the racks
Select a programme
Select options
Press the
Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash only.
If using combined action dishwasher
tabs, follow the user instructions!
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener system only.
Mechanical indicator D.
Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Press the button until the desired programme lights up.
If necessary (and if provided) the corresponding indicator
lamp lights up.
ON
button.
A:
B:
Press the START button
T urn on the water tap
close the dishwasher door
Wash cycle
Switch off the appliance
Shut off the water tap,
unload the racks
The selected programme
is then memorised (even
in the event of power
failure).
At the end of the programme an acoustic signal will sound.
Only after the START button has switched off: press the
button. All the indicator lamps switch off.
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
“Change programme”
Press the START button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and
press the START button again.
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off
during a wash cycle, when switched
on again it will resume the cycle
from where it was interrupted.
OFF
Loading...