Whirlpool GSXP 7988 INSTRUCTION FOR USE

GSXP 7988

Before using the dishwasher, read the user instructions!

Quick Reference Guide

GB

On button

Off button

Programme selection button

Start button

Switches “on” when the dishwasher

is operating. Flashes when a fault
occurs. Switches off at the end of
the programme.

Indicators

Add rinse aid

Add regeneration salt

Only add regeneration salt
immediately before starting a wash
programme.

Options

Time and failure display

Indicates in hours the time
remaining until the start of the wash
cycle. Toward the end of the
programme, during the drying cycle,
the display will indicate the time
remaining in minutes.

“F...” Information for the
After-Sales Service

3)

“Delayed start” button

The wash cycle can be programmed
to start after 1 - 24 hours. With each
successive touch of the button, the
delayed start indicator increases by 1
hour, and after 24 returns to

00.Then press the Start button. The
dishwasher will start at the set time.

“Half Load” button

This function can be used with any
programme. The indicator lamp
switches on. The wash cycle is
activated for the upper

only

rack

.

or

lower

Programme chart

Programmes Loading instructions A B Litres kWh Minutes

Sensor Normal

Sensor Intensive

Pre-Rinse cold

Glass 40°C

Rapid 30 min 40°C

Standard

1) Reference programme for energy label in
compliance with EN 50242 regulations;

2) Refer to “User instructions“;

40-55°C

60-70°C

1)

Automatic programme recommended for
routine washes, with no dried-on or burnt
food (not for EN 50242).

Automatic programme recommended for
heavily soiled crockery with dried-on or burnt
food, for example pans and saucepans.

Crockery to be washed later. - - 4.0 0.03 14

Light soiling, for example glasses
and cups.

Lightly soiled crockery with no
dried-on food.

Normally or heavily soiled crockery. X X 13.0 1.05 120

50°C

3) Values may vary in relation to usage, e.g.:
different loads, water temperatures - above or
below 15°C - as well as water hardness and power
supply voltage, etc.

(We reserve the right to make technical modifications)

Detergent

X X 10-13 0.8-1.05 50-110

X X 13-20 1.1-2.0 90-140

X - 10.0 0.80 55

X - 10.0 0.65 30

2)

Consumption

5019 496 90202

3)

How to use the appliance

C

BA

Further indications are given in the single chapters and in the user instructions.

Open the door

Switch on the appliance

How to fill the

detergent dispenser

Check the

rinse aid level

Check the regeneration

salt level

Load the racks

Select a programme

Select options

Press the

Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash only.

Mechanical indicator lamp C.
Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator lamp D.
Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.
Press the button until the desired programme lights up.

If necessary (and if provided) the corresponding indicator
lamp lights up.

ON

button.

A:

B:

Press the START button

Turn on the water tap

close the dishwasher door

Wash cycle

Switch off the appliance

Shut off the water tap,

unload the racks

The selected programme
is then memorised (even
in the event of power
failure).

At the end of the programme an acoustic signal will sound.
Only after the START button has switched off: press the
button. All the indicator lamps switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme”

Press the START button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and
press the START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched off during
a wash cycle, when switched on
again it will resume the cycle from
where it was interrupted.

OFF