Whirlpool GSXP 7598/2 INSTRUCTION FOR USE
Before using the dishwasher, read the user instructions!
GSXP 7598
On button
Off button
Programme selection button
Start button
Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Indicators
Add rinse aid
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Quick Reference Guide
Options
Time and failure display
Indicates in hours the time remaining until
the start of the wash cycle. Toward the
end of the programme, during the drying
cycle, the display will indicate the time
remaining in minutes.
“F....” Identification of faults for
service technician
“Delayed start” buttons
The wash cycle can be programmed to
start after 1 - 24 hours. With each
successive touch of the button, the
delayed start indicator increases by 1
hour, and after 24 returns to 00. Then
press the Start button. The dishwasher
will start at the set time.
“Half load” button
This function can be used with any
programme. The indicator lamp switches
on. The wash cycle is activated for the
upper or lower rack
When washing without the top rack, press
the “Half Load” button (LED alight).
only
GB
3)
.
Programme chart
Detergent
Programmes Loading instructions A B
Pre-Rinse cold
Quickwash 40°C
Normal
Hygiene +
1)
4) 5)
Intensive 70°C
1) Reference programme for energy label EN 50242;
2) Refer to “User instructions”;
3) Program data obtained in conformity with European
standard EN 50242. Values may vary in relation to usage,
e.g.: different loads, water temperatures - above or below
15°C - as well as water hardness and power supply
voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
Crockery to be washed later. - - 4.0 0.03 14
Lightly soiled crockery with no
dried-on food.
Normally or soiled crockery. X X 13.0 1.05 145
50°C
Normally or heavily soiled
crockery, with additional
antibacterial action.
Heavily soiled crockery, especially
pots and pans.
4) The bacteria removal efficiency has been tested by the
Institut Pasteur de Lille (France), based on the NF
EN 13697 standard of November 2001.
5) Programme interruption (e.g. the door being opened)
may compromise the result of the antibacterial rinse.
(We reserve the right to make technical modifications)
X - 10.0 0.65 30
X X 13.0 1.50 115
X X 14.0 1.70 150
2)
Consumption
Litres kWh Minutes
3)
5019 496 90428
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Open the door,
switch on the appliance
How to fill the
detergent dispenser
Check the rinse aid level
Check the regeneration
salt level
Load the racks
Select a programme
Press the ON button.
Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash
only.
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener
system only.
Mechanical indicator D. Electric
indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Press the button until the desired programme lights up.
A:
ABC
B:
Select options
Press the Start button
Turn on the water tap
close the dishwasher door
Wash cycle
Switch off the appliance
Turn off the water tap,
unload the racks
If necessary (and if provided) the corresponding indicator lamp lights up.
The selected programme is
then memorised (even in the
event of power failure).
At the end of the programme an acoustic signal will sound.
Only after the START button has switched off: press the
All the indicator lamps switch off.
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
“Change programme”
Press the ST ART button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and press
the START button again.
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.
button.
OFF
Loading...