Whirlpool GSXP 7558/2 INSTRUCTION FOR USE
Before using the dishwasher, read the user instructions!
GSXP 7558 |
Quick Reference Guide |
|
GB |
||||||
|
|
||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Options
On button
Off button
Programme selection button
Start button
Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.
Indicators
Add rinse aid
Add regeneration salt
Time and failure display
Indicates in hours the time remaining until the start of the wash cycle. Toward the end of the programme, during the drying cycle, the display will indicate the time remaining in minutes.
“F....” Identification of faults for service technician
“Delayed start” buttons
The wash cycle can be programmed to start after 1 - 24 hours. With each successive touch of the button, the delayed start indicator increases by 1 hour, and after 24 returns to 00. Then press the Start button. The dishwasher will start at the set time.
“Half load” button
The half load cycle can be used for the upper and lower rack. Select the required programme then press the “Half Load” button. The light comes on and goes off at the end of the programme.
The “Half Load” function can be used with programmes marked with an *.
Only add regeneration salt immediately before starting a wash programme.
Programme chart |
Detergent 2) |
Consumption 3) |
|||||
Programmes |
|
Loading instructions |
A |
B |
Litres |
kWh |
Minutes |
|
|
|
|
|
|
|
|
Pre-Rinse |
cold |
Crockery to be washed later. |
- |
- |
5.0 |
0.02 |
10 |
|
|
|
|
|
|
|
|
Quickwash |
40°C |
Lightly soiled crockery with no |
X |
- |
13.0 |
0.70 |
30 |
|
|
dried-on food. |
|
|
|
|
|
Normal 1) (*) |
50°C |
Normally soiled crockery. |
X |
X |
16.0 |
1.05 |
160 |
Hygiene + 4) 5) |
|
Normally or heavily soiled crockery, |
X |
X |
16.0 |
1.75 |
120 |
|
with additional antibacterial action. |
||||||
Intensive |
70°C |
Heavily soiled crockery, especially |
X |
X |
17.0 |
1.90 |
135 |
|
|
pots and pans. |
|
|
|
|
|
1)Reference programme for energy label EN 50242;
2)Refer to “User instructions”;
3)Program data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc.
Important information for Test Laboratories:
4)The bacteria removal efficiency has been tested by the Institut Pasteur de Lille (France), based on the NF
EN 13697 standard of November 2001.
5)Programme interruption (e.g. the door being opened) may compromise the result of the antibacterial rinse.
For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
5019 496 90431
(We reserve the right to make technical modifications)
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Open the door, switch on the appliance
How to fill the detergent dispenser
Check the rinse aid level
Check the regeneration salt level
Load the racks
Select a programme
Select options
Press the Start button
Turn on the water tap close the dishwasher door
Press the ON button.
Large compartment A: |
|
|
|
|
|
|
With each wash cycle. |
|
|
A |
B C |
||
Small compartment B: |
|
|
|
|
|
|
For programmes with pre-wash |
|
|
|
|
|
|
only. |
|
|
|
|
|
|
Mechanical indicator C. |
|
|
|
|
||
Electric indicator on control panel (if provided). |
|
|
|
|
||
On models with water softener |
|
|
|
|
|
|
|
|
|
|
|
||
system only. |
|
|
|
|
|
|
Mechanical indicator D. Electric |
|
|
|
|
|
|
indicator on control panel (if provided). |
|
|
|
|
|
|
|
|
|
|
|
|
|
Refer to the dishwasher loading instructions. |
|
|
|
|
||
The last programme selected will light up.
Press the 
button until the desired programme lights up.
If necessary (and if provided) the corresponding indicator lamp lights up.
The selected programme is |
“Change programme” |
||
|
|
Press the START button for 2 sec. until |
|
|
|||
then memorised (even in the |
|
|
the Start indicator lamp switches off; |
event of power failure). |
|
|
Select another programme and press |
|
|
|
|
|
|
|
the START button again. |
|
|
|
|
Wash cycle
Switch off the appliance
Turn off the water tap, unload the racks
-Only open the dishwasher if necessary (Warning: beware of hot steam).
-If the appliance is switched off during a
wash cycle, when switched on again it will resume the cycle from where it was interrupted.
At the end of the programme an acoustic signal will sound.
Only after the START button has switched off: press the OFF button. All the indicator lamps switch off.
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
Loading...