Whirlpool GSXK 7451/2 INSTRUCTION FOR USE

GSXK 7451

On button

Off button

Programme selection button

Start button

Switches “on” when the dishwasher is

operating. Flashes when a fault occurs.
Switches off at the end of the programme.

Before using the dishwasher, read the user instructions!

Quick Reference Guide

GB

Indicators

Add regeneration salt

Only add regeneration salt immediately
before starting a wash programme.

Add rinse aid

Programme chart

Programmes Loading instructions A B

Pre-Rinse cold

Rapid 30 min 40°C

Normal

1)

Intensive 70°C

1) Reference programme for energy label in
compliance with EN 50242 regulations;

2) Refer to “User instructions“;

Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“[e-mail]”.

Crockery to be washed later.

Lightly soiled crockery, with
no dried-on food.

Normally soiled crockery.

50°C

Heavily soiled crockery,
especially pots and pans.

3) Program data obtained in conformity with
European standard EN 50242. Values may vary in
relation to usage, e.g.: different loads, water
temperatures - above or below 15°C - as well as
water hardness and power supply voltage, etc.

Detergent

- - 5.0 0.02 10

X - 13.0 0.70 30

X X 16.0 1.24 133

X X 17.0 1.90 125

(We reserve the right to make technical modifications)

2)

Consumption

Litres kWh Minutes

5019 496 90374

3)

How to use the appliance

CBA

Further indications are given in the single chapters and in the user instructions.

Open the door

Switch on the appliance

How to fill the

detergent dispenser

Check the

rinse aid level

Check the regeneration

salt level

Load the racks

Select a programme

Select options

Press the

Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash only.

Mechanical indicator C.
Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator D.
Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.
Press the button until the desired programme lights up.

If necessary (and if provided) the corresponding indicator
lamp lights up.

ON

button.

A:

B:

Press the START button

T urn on the water tap

close the dishwasher door

Wash cycle

Switch off the appliance

Shut off the water tap,

unload the racks

The selected programme
is then memorised (even
in the event of power
failure).

At the end of the programme an acoustic signal will sound.
Only after the START button has switched off: press the
button. All the indicator lamps switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme”

Press the START button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and

press the START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched off
during a wash cycle, when switched
on again it will resume the cycle
from where it was interrupted.

OFF