Whirlpool GSXK 7421 INSTRUCTION FOR USE

Before using the dishwasher, read the user instructions!

GSXK 7421

Quick Reference Guide

GB

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

On button

Off button

Programme selection button

Start button

Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Indicators

Add rinse aid

Add regeneration salt

Only add regeneration salt immediately before starting a wash programme.

 

Programme chart

 

 

Detergent 2)

Consumption 3)

 

Programmes

 

Loading instructions

A

B

Litres

kWh

Minutes

 

 

 

 

 

 

 

 

 

 

Pre-Rinse

cold

Crockery to be washed later.

-

-

5.0

0.02

10

 

 

 

 

 

 

 

 

 

 

Rapid 30 min

40°C

Lightly soiled crockery, with

X

-

13.0

0.70

30

 

 

 

no dried-on food.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Bio 1)

50°C

Normally soiled crockery.

X

X

16.0

1.05

195

 

 

 

 

 

 

 

 

 

 

 

 

 

Intensive

70°C

Heavily soiled crockery,

X

X

17.0

1.65

145

 

 

 

especially pots and pans.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1) Reference programme for energy label in

3)

Programme data obtained in conformity with

compliance with EN 50242 regulations;

 

European standard EN 50242. Values may vary in

2) Refer to “User instructions“;

 

 

 

relation to usage, e.g.: different loads, water

 

 

 

 

 

temperatures - above or below 15°C - as well as

 

 

 

 

 

water hardness and power supply voltage, etc.

Important information for Test Laboratories:

For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

5019 496 98054

(We reserve the right to make technical modifications)

Whirlpool GSXK 7421 INSTRUCTION FOR USE

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Open the door Switch on the appliance

How to fill the detergent dispenser

Press the ON button.

 

 

Large compartment A:

 

 

 

 

With each wash cycle.

A

B C

Small compartment B:

 

 

For programmes with pre-wash only.

 

 

If using combined action dishwasher

 

 

tabs, follow the user instructions!

 

 

 

 

 

Check the rinse aid level

Check the regeneration salt level

Load the racks

Select a programme

Select options

Mechanical indicator C.

Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator D.

Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.

Press the button until the desired programme lights up.

If necessary (and if provided) the corresponding indicator lamp lights up.

Press the START button

Turn on the water tap close the dishwasher door

The selected programme is then memorised (even in the event of power failure).

“Change programme”

Press the START button for 2 sec. until the Start indicator lamp switches off;

Select another programme and press the START button again.

Wash cycle

Switch off the appliance

Shut off the water tap, unload the racks

-Only open the dishwasher if necessary (Warning: beware of hot steam).

-If the appliance is switched off

during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.

At the end of the programme an acoustic signal will sound. Only after the START button has switched off: press the OFF button. All the indicator lamps switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

Loading...
+ 2 hidden pages