Whirlpool GSXK 7316 INSTRUCTION FOR USE
Before using the dishwasher, read the user instructions!
GSXK 7316
On button
Off button
Programme selection button
Start button
Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Indicators
Quick Reference Guide
Options
3)
GB
“Delayed start” button
The wash cycle can be
programmed to start after 3-6-9
hours. Then press the Start button.
The dishwasher will start at the set
time.
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Programme chart
Programmes Loading instructions A B
Quickwash 40°C
1) 4)
Bio
Intensive 70°C
1) Reference programme for energy label EN 50242;
2) Refer to “User instructions”;
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“nk_customer@whirlpool.com”.
Lightly soiled crockery with no
dried-on food.
Normally soiled crockery. X X 16.0 1.05 195
50°C
Heavily soiled crockery, especially
pots and pans.
3) Programme data obtained in conformity with European
standard EN 50242. Values may vary in relation to usage,
e.g.: different loads, options, water temperatures - above
or below 15°C - as well as water hardness and power
supply voltage, etc.
4) Energy saving programme with prolonged drying cycle.
(We reserve the right to make technical modifications)
Detergent
X - 13.0 0.70 30
X X 17.0 1.65 145
2)
Consumption
Litres kWh Minutes
3)
5019 496 90465
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Open the door,
switch on the appliance
How to fill the
detergent dispenser
Check the rinse aid level
Check the regeneration
salt level
Load the racks
Select a programme
Press the ON button.
Compartment
With each wash cycle.
Compartment
For programmes with pre-wash only.
If using combined action dishwasher
tabs, follow the user instructions!
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener
system only.
Mechanical indicator D. Electric
indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Press the button until the desired programme lights up.
A:
B:
ABC
Select options
Press the Start button
Turn on the water tap
close the dishwasher door
Wash cycle
Switch off the appliance
Turn off the water tap,
unload the racks
If necessary (and if provided) the corresponding indicator lamp lights up.
The selected programme is
then memorised (even in the
event of power failure).
At the end of the programme an acoustic signal will sound.
Only after the START button has switched off: press the
All the indicator lamps switch off.
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
“Change programme”
Press the ST ART button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and press
the START button again.
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.
button.
OFF
Loading...