Whirlpool GSXH 7451/2 INSTRUCTION FOR USE

Before using the dishwasher, read the user instructions!

GSXH 7451

Indicators

Quick Reference Guide

On button

Off button

Programme selection button

Start button

Switches “on” when the dishwasher is operating.

Flashes when a fault occurs. Switches off at the
end of the programme.

GB

Add regeneration salt

Only add regeneration salt immediately before

starting a wash programme.

Programme chart

Programmes Loading instructions A B

Pre-Rinse cold

Rapid 30 min 40°C

Normal

1)

Intensive 70°C

1) Reference programme for energy label in c ompliance with
EN 50242 regulations;

2) Refer to “User instructions”;

Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“[e-mail]”.

Crockery to be washed later.

Lightly soiled crockery, with no
dried-on food.

Normally soiled crockery.

50°C

Heavily soiled crockery,
especially pots and pans.

3) Program data obtained in conformity with European
standard EN 50242. Values may vary in relation to usage,
e.g.: different loads, water temperatures - above or below
15°C - as well as water hardness and power supply
voltage, etc.

Detergent

- - 5.0 0.02 10

X - 13.0 0.70 30

X X 16.0 1.05 160

X X 17.0 1.90 135

(We reserve the right to make technical modifications)

2)

Consumption

Litres kWh Minutes

3)

5019 496 90427

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Open the door,

switch on the appliance

How to fill the

detergent dispenser

Check the rinse aid level

Check the regeneration

salt level

Load the racks

Select a programme

Press the ON button.

Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash

only.

Mechanical indicator C.
Electric indicator on control panel (if provided).

On models with water softener
system only.

Mechanical indicator D. Electric
indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.
Press the button until the desired programme lights up.

A:

ABC

B:

Select options

Press the Start button

Turn on the water tap

close the dishwasher door

Wash cycle

Switch off the appliance

Turn off the water tap,

unload the racks

If necessary (and if provided) the corresponding indicator lamp lights up.

The selected programme is
then memorised (even in the
event of power failure).

At the end of the programme an acoustic signal will sound.
Only after the START button has switched off: press the
All the indicator lamps switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme”

Press the ST ART button for 2 sec. until
the Start indicator lamp switches off;

Select another programme and press
the START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.

button.

OFF